Question about 1988 Toyota Cargo
Have an 88 Toyota Van Wagon LE (4Y-EC). Somehow the main oxygen sensor electrical connectors were disconnected and I can't find the female end to re-connect to. The male end coming from the sensor is only about 18 inches long, so the female end can't be that far away. Could it be stuck behind something / where could it be? I don't even see any wires where the end may have broken off. HELP.............Thanks
The first thing to check is the fuse that controls that door's motor. Look in your manual for the fuse chart. Determine where the fuse panel is and which fuse it is. Pull that fuse and take a close look to see if it has blown. If so, replace it with a new one of the same amperage
Posted on Apr 11, 2009
Actually this sounds more like your left tire is rubbing against the tire well, this was relatively common amongst these models, as I have one myself that did that while turning right, I solved it by hammering out the dent that was in the well. Hope this helped GL!
Posted on Jan 28, 2010
Try spraying starting fluid into the intake of the air cleaner while someone else starts the car. Continue spraying the starting fluid for about 15-20 seconds. If the car starts, more than likely your fuel pump is bad. Check your fuses, and make sure you are getting power to the fuel pump. firstname.lastname@example.org
Posted on Feb 17, 2010
I have the 1990 model and just so happened to stumble on its unusual location today as I was replacing the door hinges. On the passenger side open the door and look above the step, there should be a little plastic cap with the wiper icon on it. hope this helps!
Posted on Jul 06, 2010
Tips for a great answer:
Nov 07, 2015 | Toyota Cars & Trucks
Aug 06, 2015 | 2009 Toyota Sienna LE
Jul 26, 2014 | 2003 Toyota Tacoma
Mar 20, 2013 | Cars & Trucks
Sep 02, 2011 | 2006 Toyota Sienna
Aug 05, 2011 | 2003 Toyota Camry
Mar 09, 2011 | 1993 Toyota Camry V6
Jan 27, 2011 | 2005 Toyota Tacoma
Mar 22, 2010 | 1989 Toyota Pickup SR5
May 12, 2009 | 1989 Toyota Pickup SR5
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: