Question about 1994 Toyota 4Runner

1 Answer

Factory alarm going off

Ok I guess my 4 runner has an alarm and it's going off and I can not start my truck! I dont have the key pad is there a way to reset it?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Take it to your local fitment centre that does audio and security for motor vehicles and ask them to remove or replace, which ever u desire

Posted on Jan 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to disable an alarm system on 1998 Isuzu rodeo..


are you in the USA?
Isuzu is bad to own here.
the below is my answer for stock car with stock
engine start blocking feature, factory stock.

I would first find that alarm module
then id take it out of car and photo it totally (see bypass below)
non stock alarms, you need to say so..... for sure...


ok im reading your FSM book now.
it did have a factory option seen below
lets me say how to bypass that. now....
BYPASS is easy:

cut this wire first. on top right.
white-green pin 28 on alarm box.
that wire runs the starter crank like , key line.
then strip it (out going wire) and move it to Ground.




25783945-zy5i2xuw3mfjw4tca3plar50-1-0.jpgthis makes the starter relay pin, at ground full time.
this fools the relay into thinking, it's never in alarm.
and now cranks. and might start,
if its does crank, say so and we can work that issue easy.

but do sell this dog.... (or get a parts car , ) IMO !

Jul 15, 2015 | 1998 Isuzu Rodeo

1 Answer

I have a 1996 3.8 liter camaro. I was driving my car down the road when the gages started jumping and i found out that problem it was the battery and aldernater well after i changed them problems i have...


Hmmm, a puzzle.

The only way to disarm these alarms is with
the factory remote or turning on the ignition.
To turn off the factory alarm.

Ok, do you have the remotes?
If so, let's ID the system.
Go to www.KEYLESSRIDE.com & use th fcc #s
on the back of it.

If not try this:

Programming Factory Security on GM Cars and Trucks
Instructions for programming the GM factory security systems that do NOT
disarm from the driver's door key cylinder. This programming is for the
cars and trucks listed below.

96+ Camaro
96+ Firebird
99+ GM Trucks
99+ GM Sport Utility Vehicles

Step #1 Turn the ignition on then off.

Step #2 Remove the radio fuse only (not the fuse that says acc/radio).

Step #3 Turn the key to the accessory position. When you do this you
will get two chirps from the door buzzer. Should you hear only
one chirp, your vehicle does not have factory security and these
instructions do not apply. You need to hear two chirps.

Step #4 Press the unlock switch on the door. This will give 1-4 chirps
depending on the program step. Continue pressing the unlock
switch until you get to the desired chirp setting.
1 Chirp - Security off
2 Chirps - Remote Only
3 Chirps - Factory Setting
4 Chirps - Passive Arming

Step #5 Turn the ignition off.

Step #6 Put radio fuse back in.

Jul 03, 2011 | 1996 Chevrolet Camaro

1 Answer

2001 olds silhouette non functioning alarm


red light? this is a factory alarm?? Is GM on the key fob? factory alarms dont have "motion sensors" and very few aftermarket alarms do. roll down the window and set the alarm, now open the door and see if it lights off.

Oct 18, 2009 | 2001 Oldsmobile Silhouette

2 Answers

Alarm red light stays on after you shut the car off 1998chrysler


I would turn the key on without starting the car then press and hold the black button till the alarm light flashes.Then turn key off take out of car and try the fob again.

Mar 29, 2009 | 1998 Chrysler Cirrus

1 Answer

1999 volkswagen passat car alarm factory installed system


Do you have a key fob? Unlock the car with that and you should be OK. My sons Elantra is the same way, you can only get in with the fob. I guess the car thinks it's being stolen otherwise. If you don't have a fob, I'm no help

Mar 28, 2009 | 1999 Volkswagen Passat

1 Answer

My alarm goes off when i start the car


Pull the fuse and forget about it. As long as you dont mind, its not a big deal. Fuses rarely, if ever share anything, sometimes if you hook something up after market you may have to run a wire to a fuse. If you have a chip on your key no ne is stealing that car, and its a 92 so no one is stealing it anyway! i have a 92, and have had it in philly since i bought it in 96. It has a built in security if you key is chipped.

Mar 08, 2009 | 1992 Pontiac Bonneville

1 Answer

New battery, can't reset alarm


remove the alarm,their might be a passive switch on the alarm to turn it off with a special key,if you dont have the key break the lock so you can turn it off or try to open case of alarm and look at wires and then dertimine which ones to join or break,every alarm inside is different so you will have to work it out.

Oct 30, 2008 | 2000 Mitsubishi Montero

1 Answer

Replaced rear brakes, Alarms still active


i have a 2003 toyota 4-runner my brake and abs vsc are on and it has a beeping loud noise.....what do u think is the problem?

Aug 21, 2008 | 2003 Toyota 4Runner

Not finding what you are looking for?
1994 Toyota 4Runner Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...