Question about 2008 Toyota Camry

2 Answers

Viberation. When my 2009 camry sits in idle with the car in "D" (drive), the whole car viberates. When I shift it up to Neutral, it no longer viberates then when I shift it back to "D", it viberates all over again. The viberation happens only when its in "R" (reverse) and "D" (drive). When I have the car in "P" (park) and "N" (neutral) it does not viberate at all. I would like to know what we can to do solve this issue. The viberation has been annoying.

Posted by on

  • paul erickson
    paul erickson May 11, 2010

    the virbration you feel is the trans trying to pull in gear this happens on all the new camrys . you should go complane to your dealer .

    i dont know if they have a fix yet but they are working on it.

    ive seen it 2 other times



2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Read more here

Posted on Oct 27, 2015

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 34 Answers

This sounds like a case of bad gas affecting your vehicle's smooth operation. Try going to an auto parts store and getting some gas treatment next time you need to fill up. Add it to your gas tank at that time, and it should help. I had the same problem, and this worked for me. Good luck!

Posted on Dec 10, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Viberation in drive at idle

This most common cause of this is the engine mounts are defective.

Jun 30, 2017 | Cars & Trucks

1 Answer

I have camry 2009, when i turned the steering wheel I feel there is a resistance and viberation. this happened when the car is stop and when a car in circle road

Rack needs replacement or fluid, ussually fluid, part of normal servcie.... check owners manual and use only what it says.. should clear up fast, pump is overloaded .. if not tow in a get Rack n Pinion replacement!

Oct 02, 2013 | Toyota Camry Cars & Trucks

1 Answer

Between 2300-2800rpm viberation thro body drive feels course

You may have bad baffles in the Exhaust muffler or the Catalytic Converters. Also some Manufacturers put Tuning weights on Exhaust pipes. Since the problem seems to be isolated to engine RPM, you have eliminated many of the other possibilities in the Drivetrain by your description.

If this would happen to be a Ford V-8 with Cam Phasers, they can get out of sync and cause the engine to vibrate. Check your Vibration Damper bolt as a loose pulley can vibrate.

Jan 15, 2012 | Cars & Trucks

1 Answer

1998 Audi A4 Quattro Sedan 2.8L Major viberation at 15 mph in center of the car. Under 15mph it smoothes out. Feels like rear drive shaft or u-joint is shot but I'm not familiar with Audi. It started a...

have you checked your calipers? They may be sticking putting lots of strain onto the drive shaft causing it to vibrate.

With all the recent snow and grit on the roads you may have some caught in the mechanism meaning it cant release.

Just a small thought to start to determine the problem.

Jan 07, 2011 | 1998 Audi A4

1 Answer

When in low idle has a bad viberation seems to to less viberation when accelerating

Common problem. Check your motor mounts and transmission mounts, more than likely it's the motor mounts. While they may "look" OK from the outside, the mounts tend to crush and not be as high as they need to be. This problem has is just a nuisance and won't hurt the performance of your TB. Typically this problem will start out only happening when it's a cold engine, then go away once the engine has warmed up. But will get worse as time goes on. Buy OEM mounts as aftermarket mounts won't be as stiff and a lot of times end up with vibration quickly after they are replaced, so don't waste our money. Hope this helps! Good luck.

Jan 02, 2011 | 2005 Chevrolet Trailblazer Ext

1 Answer

With jeep running foot on brack putting in drive i get viberation it dosent happen all the time some times at a stop light . i can put it in nutrel and it well stop ? can you help

sounds like a CV joint that may be failing. When the trans in neutral is disengages the joint and that stops the vibration. Have it checked out at a local shop.

Oct 10, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Ford f250 viberation high speed 65mph

Check the U-joints and center carrier bearing on the drive line.

May 24, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Toyota camry 1997

Your motor mounts are worn out. Replace the "dog-bone" looking mount at the passenger side of the engine, and then replace the hydraulic mount right between the engine and the radiator.

Aug 19, 2008 | 1998 Toyota Camry

Not finding what you are looking for?
2008 Toyota Camry Logo

Related Topics:

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides