Question about 2005 Jeep Grand Cherokee

1 Answer

AIR HISSING NOISE COMING THROUGH DOORS CHROME TRIM.

WINDOWS ARE UP AND HEATER IS ON HIGH, AIR IS ESCAPING THROUGH AN AREA BEHIND THE DRIVERS DOOR OUTSIDE CHROME TRIM. TRIM FEELS LOOSE AND NOT SURE IF IT IS 3M TAPE OR HAS ATTACHMENTS THROUGH DOOR PANEL.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Trim generally does not have much to do with body sealing. Check to make sure that the rubber door seals are intact and are actually touching the door frame. Make sure your door is properly aligned in the frame. Sometimes the hinges wear and cause some drooping. If condition is not severe, sometimes you can "fatten up" the door gasket by sliding a length of rubber hose inside it. As far as trim goes, most trim on Jeeps is glued on.
Good Luck

Posted on Jan 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I turn on the air condition or heater car runs very rough is this a vacuum problem


Yes it could very well be , They use vacuum actuators to control blend doors an temp. doors ! Take lower panels off under dash an stick you up under there an listen for a hissing noise . Pull out the glove box too an listen behind it as well ! What make , model an year vehicle do you have ?

Mar 08, 2015 | Cars & Trucks

1 Answer

How to get to power window swtich in door


you will have to remove the door panel as the switch is held in place from behind , go around the side and bottom edge's of door panel and remove the screws then from the bottom of panel gently pull the panel away from door there will be some resistance and noise dont worry as thereis a few pop in/out studs and a bead of water proof adhesive once the panel is loose lift vertically to release from window trim ,you may have to remove piece of trim that cover the door mirror area but usually the panel will come out with out doing this then you will need to disengage the door handle operating bar to allow panel to come far enough away door to get access to the switch wiring disconnect wire connector and release switch assembly , refitting is just a reverse making sure the pop in/out studs are aligned , sounds a lot of work but only takes 15 mins

Apr 27, 2014 | 2002 Ford Taurus

1 Answer

Where is the noise suppressor on a 2008 nissan navara I want to stop the engine noise coming through the stereo


The Coil Noise Suppressor is located in the left rear corner on your car. It is behind the interior trim. Between the driver's side door and the rear window, closer to the roof.

Mar 07, 2014 | Cars & Trucks

2 Answers

2005 grand caravan front heater and defrorst not working ,rear heater is working . i also hear a hissing noice on the passenger side


Just a suspicion: hissing noise comes from failed/jammed/malfunctioning motor to move the door
in the ducting to route heated air to the hoses/ports for "heater" and "defrost."
Problem: failure of motor/linkage to heater/defrost selector door under the dash on the passenger side.
Also sounds like you have not blown fuse to this selector door.
Also - hissing noise could be air being forced against the closed door (which should be open) - in this
case, you'd want to check the fuse to the heater/defroster actuator door.
The rear heater works since its function is not related to the operation of the front heater/defroster.

Jan 02, 2011 | 2005 Dodge Grand Caravan

1 Answer

1997 mercury villager passenger side mirror replacement guide. how do i do it? is there an easy access panel or does the whole door panel need to be removed


door panel must come off.

go here for villager help

http://groups.yahoo.com/group/villagerquest/

Section 01-05: Trim, Interior 1997 Villager Workshop Manual
REMOVAL AND INSTALLATION Trim Panel(s), Door
Front
Removal
  1. Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
  1. svv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
    Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942).




  1. If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel.
  1. Pull the shop rag back and forth to release the window regulator handle clip.




  1. Remove the three cover caps and front door trim panel screws.
  1. Remove the one front door trim panel capped screw from the door pull handle.
  1. If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
  1. Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124).
  1. Remove the front door trim panel.
Installation
To install, reverse the removal procedure. Body Side
Removal
  1. Gently pry loose the body side door latch handle bezel and remove it.
  1. Slide a suitable tool behind each of the retainers and twist the tool to disengage the body side door trim panel from the body side door (24622).




Installation
To install, reverse the removal procedure. Door Electrical Connections
Removal and Installation
Refer to Section 01-11 for Power Window, Section 01-09 for Power Mirror, or Section 01-14B for Power Locks. Watershield
Removal
  1. Remove the Front Door Trim Panel . Refer to the removal procedure in this section.
  1. Remove the front door watershield by carefully detaching it from the adhesive.
Installation
  1. Install the front door watershield in the proper position and press firmly at the adhesive areas. If necessary, use additional adhesive to ensure an adequate seal.
  1. Install the Front Door Trim Panel . Refer to the installation procedure in this section.

May 22, 2010 | 1998 Mercury Villager

1 Answer

Driver's door panel removal trouble


I believe that you will need to remove that trim piece to access some screws. Check in door handle pocket to see if there may be a small cover hiding a screw.

Mar 27, 2009 | 2001 Lincoln LS

2 Answers

Low to No Heat in 1998 Dodge Durango


Provided you bled system good with rad cap off & coolant in rad isn't low, i suspect blend/air door may be malfunctioning, perhaps from a vacuum leak. You might be able to feel or see by reaching in behind dash from driver side, and look for vacuum lines & a plug going into the control. Listen for a "hiss" noise anywhere in that area as well. If you can follow the lines, would help, and pay special attention for vacuum line where it enters firewall on outside in engine area & follow it back to vacuum source too.

Mar 02, 2009 | 1998 Dodge Durango

1 Answer

1999 Econoline E150 Van mirror replacement


Remove the door handle bezel.Remove the power window/door lock switch bezel.Remove the rearview mirror fastener trim cover.Remove the 4 door trim panel retaining screws.One that was behind the mirror trim cover,behind the switch panel,behind the door handle bezel,and one at the bottom corner.Lift the door trim panel up from the door to disengage the trim panel clips.Remove the front radio speaker. Disconnect the power mirror wiring connector.Remove the 3 bolts to the mirror.

Feb 08, 2009 | Ford E-150 Cars & Trucks

2 Answers

Rear wiper fluid leaks


i was wondering I have a leak from the rear wiper. The liquid is coming out from arouhd the trim in the front around the windshield. . How do I take the trim off without breaking anything but fix the problem

Jan 23, 2009 | 2005 Ford Escape

5 Answers

1999 Ford Windstar 3.8 no heat


If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.

Nov 12, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21987 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...