Question about 1994 Jeep Grand Cherokee

1 Answer

Transmision i got a 94 jgc that when put in gear it does nothing i changed the motor then drove 4 a few miles then next time got in it the tranny wouldnt go into gear

Posted by on

  • dan lincoln May 15, 2014

    you need to identify the parts that were used in your vehicle. if you choose to work on it you will find many systems were used, and combinations. research thru the library online, or goto library and get the service manual updates from mitchell database. jeep was in transition during those years and the books were thrown together, there were changes and updates made later, then recalls and tsb's affected the correct repair of these



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 94 Answers

Hi joshdwright, is your trans a AW-4 or a 46RH? the 46RH was set behind the 5.2L engine and is a 4sp/od and the AW-4 is an electronically controlled 4sp automatic. start simple check that trans oil level is good then if you have the AW-4 make sure the the shift cable adjustment is correct/on the 46RH make sure the linkage is assembled properly, after these checks things get a little more complicated so get back to me and let me know what you found out buddy we'll go from there good luck

Posted on Nov 12, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a automatic transmission and my van will not go into drive or reverse..

Assuming it is a 4L60E trans. The first thing to do is change the filter & replace the fluid. Have the shop check the fluid pressure. Other than that there are numerous things that could cause your problem. Could be the torque convertor on it's way out. P.S.There is no timing belt in a transmission.

Jan 29, 2014 | Cars & Trucks

1 Answer

94 jeep grand cherokee, trannys slippg in 1s gear, added lucas stop slip, started next day, drve a few feet and it wont engage.......

Transmission might be fried. One suggestion, did you try putting it in 4WD and trying that? I had a Jeep come in, same thing, wont move, ended up being a blown transfer case. Put it in 4 hi or low, and see if it will go into gear and move. Long shot, but worth a try.

Dec 29, 2013 | 1994 Jeep Grand Cherokee

1 Answer

I havea 1991 chevy K2500 with a 454 engine and 4l80E transmision. Just put tranny in truck and drove it less than 50 miles. Overdrive went out immediatly and then reverse. This is 4th transmission in the...


Jan 15, 2011 | Chevrolet Silverado 2500 Cars & Trucks

1 Answer

My 83 chevy truck was a daily driver. It was parked and not moved for 3 yrs because I was in a nearly fatal injury at work. When I recovered to the point I could drive again, I fueled it, started it and...

I bet it's clogged also.
Also check any linkage cables for sticking in any way,use spray silicone on cables.
If they need cleaning try liquid wrench

Nov 25, 2010 | 1983 Chevrolet Chevy

1 Answer

Went on trip and van want go in second just die down but drove in frist the next morning still did not change after about 20 miles it change gears for almost 30 miles then just die out and wold not go out...

If you have a lot of miles on your van , 100,000 or more , have the transmission serviced. But before you do that , check the vacuum line to the modulator valve for leaks or breaks In the vacuum line .

May 12, 2010 | 1994 Plymouth Voyager

1 Answer

94 Chrysler Concorde Tranny Problems

Have your transmission oil filter changed;
it is located under the transmission pan
The oil is what makes the transmission shift
When you shut off the engine it stops the transmission pump then when you start up again the transmission shifts until the filter clogs again

May 28, 2009 | 1994 Chrysler Concorde

1 Answer

2000 durango vibrates when auto transmision shifts

check the motor and tranny mounts for the vibrations if the motor shakes a lot when in park while idling you may need to replace the mount(s)

Apr 01, 2009 | 1999 Dodge Durango

2 Answers

1994 JGC tranny problems

The only thing that can make the noise is the transmission front pump, if the trans works ok try changing the fluid and filter, it may help or reduce the noise.

Aug 20, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides