Question about 2007 Ford Expedition Eddie Bauer EL

1 Answer

The turn signals and hazard lights quit working temporarily

I recently replaced the heater core. A couple days later the turn signals and hazard lights quit working, for a couple of minutes, while I was driving.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

About the only thing that would cause both the turn signals and hazard lights not to work at the same time would be the flasher relay.

Posted on Nov 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Replaced heater core stop turn and hazard lights all stopped working!! ??? what should i look at fuses all good!


You hooked something up wrong or not at all ,it shouldn't have blown a fuse ,did you disconnect the battery before doing the heater core . Find wiring diagrams an check power an grounds to those circuits . Go to YouTube an check out some basic electrical trouble shooting videos , an voltage drop testing videos.Basic Electrical fundamentals an so on. They worked before right ?

Dec 02, 2015 | 2001 Dodge Ram 3500 Truck

1 Answer

My brake lights and turn signals and hazard lights are not working in my 1999 lincoln town car, does anyone know how to fix.


You must have disconnected something when you replaced the heater core. Did you undo any multi-way electrical connectors. Perhaps you blew a fuse?

Nov 21, 2015 | 1999 Lincoln Town Car

1 Answer

Where are the ground wires in my 2006 pontiac torrent?


Turn signals and hazard lights may be on same fuse.Check that first before pulling it back apart.

May 07, 2014 | 2006 Pontiac Torrent

1 Answer

Turn signals heater


Did all these problems happen all at one time?? If so you may have a bad body ground. Try running a electrical wire from the (-) negative side of the battery to the body and see if this works. Be sure this wire is to a place with no paint as low voltage electricity will not flow through paint.
A). If not try replacing the turn signal flasher for the turn signal problem. This is usually the culprit and it's easiest and cheapest to replace. The turn signal flasher will be found under the driver side dash next to the hazard flasher. Turn the hazard flasher one to locate it. If you want try swapping the turn signal flasher with the hazard flasher to see if this fixes it. They are the same style flasher.
If this doesn't work you may a faulty turn signal switch or some wiring issues.
B). It could as simple as the head lights bulbs need to be replaced, it's rare but I have seen when both bulbs blew at or near the same time. If your able check the voltage at the head sockets.
C). Could be a bad blower motor or switch. I'm not sure if these models have a resistor block or not. The resister block controls the electrical current going to blower motor which controls the speed of the blower fan.

Sep 11, 2012 | Cars & Trucks

1 Answer

I am experiencing trouble with my electical system. I recently replaced a burnt out tail light (without disconnecting the battery). Later that evening the car would not shift out of park. (I solved...


I do not know for sure, but it sounds like you have a short some where. You might want to start looking for bare wires around that tail light that first started giving you all of the problems. I hope this helps you solve the problem

Aug 26, 2011 | 1998 Ford Contour

1 Answer

Rear turn signal and hazard light don't flash (left side only)


The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

Mar 26, 2010 | 2000 Ford Focus

1 Answer

Turn signals quit working. Can't find a fuse labeled for turn sig


Check the flasher unit on both turn and hazard lights,

make sure hazards are off
if hazard flasher bad and and on it will interfere with turn signal

Sep 05, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Hazard lights and turn signal dont work


check your mechanics re-wire job lol

Apr 15, 2009 | Toyota Camry Cars & Trucks

1 Answer

Turn signals work intermittantly


multifunction switch? I think so.

Jan 29, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
2007 Ford Expedition Eddie Bauer EL Logo

461 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...