Question about 1990 Mercedes-Benz E-Class

Open Question

Seat belt retractor wont retrack 1991 300e

Seat belt won't retract

Posted by on

  • tony fania Apr 07, 2012

    how do I get the cover off the seat belt retractor

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My passenger side seat belt on my 2000 ford taurus se is locked and i cant retract it. how do i fix this problem with buying a new seat belt retractor


of course it possible to access this retractor , you just need to locate the small round circles in the lower part of trim and gently pry the covers off , screws will be evedent , you will need a 6 mm star (five sided) drive socket wrench to remove the retractor though

Feb 10, 2015 | 2000 Ford Taurus

1 Answer

2008 chevy uplander seat belt wont retract how do i fix it


Please check if your seat belt has "Retractors" or "Automatic Retractor".

Follow these steps to determine if you have a retractor system that will hold car seat securely or your seat belt won't retract as should be:

A. Pull belt all the way out.

b. Allow belt to retract about 6 inches (15 cm).

c. Pull out on belt again.

If belt is locked and you cannot pull the belt out any further, you have an Automatic Locking;

If you pull the belt again all the way out and won't return to normal operation, then the mechanism is damaged, but try first the "retractor" lock to be sure. By Federal Law, nobody will sale a seat belt in a junk yard, try the dealer or order thru the dealer the whole seat belt or the mechanism. I hope that is just a matter of the automatic retractor; you can see this information in your car's manual. Try and we will see.

Jul 02, 2014 | 2005 Chevrolet Uplander

1 Answer

Seat belt retractor locked


Seat belts are not fixed they are only replaced.

Aug 28, 2013 | 1998 Saturn SL

1 Answer

How do I find diagram of seat belt retractor assembly mercury mariner


You never need a dealer except for warrantee
work


You do understand that any repair shop performs
the same services & better in most cases

You have to wrestle the buckle out where it should
be & then snap the belt to get the retractor ratchet
working

If the retractor fails, then you have to get a complete
new belt assy at dealers parts counter

Nov 20, 2012 | 2010 Mercury Mariner

1 Answer

Air bag code 33 for a 2005 lincoln town car


2005 Towncar SRS Code 33 (3 flash + 3 flash, repeat this set for twice. then Beep 5 times pause x 5 = 25 beeps every 30min).

This means you have problem with left (Driver) side pretentioner (Seat belt retract system).
It doesn't mean physical belt or retract mechanism.It is just bomb wiring which is part of airbag system.
When airbag deploy, passenger must stay tight in seat otherwise body lean to front then slam back to seat by airbag.
if belt is loose or delay to lock, passenger's body rocks back and forth.So, system use small bomb (Fire power) to lock and retract seat belt when airbag deploy.There is small bomb and igniter in part of Seat belt retractor.
Code 33 is warning for this part on 2005 Towncar.(older model is different meaning in Ford/Lincoln, it's possibly passenger side airbag system for earlier model)
Before you work for any part of Airbag system and touch any "Yellow connector", * *Disconnect battery (negative side is good enough) and wait at least 5 min to clear all power in system**.(Airbag store back up power for few minutes to be able to deploy even in case if power disconnected)
by the way, you should move your driver seat most forwarded position before you disconnect battery to make it easy to work with seat belt.
locate driver side seat belt retractor (in center pillar between front and rear door, you may have to fight with weather strip)

Locate Yellow connector on bottom of Seat belt retractor (it's called "Pretensioner")it is located on very bottom of rear side of retractor.
only one yellow connector. (make sure your battery is disconnected)
Check its physical connection or looseness.if connection looks fine, you may have to replace whole seat belt ($180-$200 in Lincoln dealer)
You can check if pretensionor is good or bad by regular tester, but unless you know how, I won't tell (because I don't wan't you to blow out pretentionor).








Jul 19, 2012 | 2005 Lincoln Town Car

1 Answer

Seat belt pasenger seat


Are you trying to say the seat belt retractor is stuck? This is in the front seat?
If it's anything like my Tahoe, you need to remove the plastic panel that covers the retractor (carefully - don't break the clips or you won't be able to put it back on). Take a large flat head screwdriver and slide it under the part where the seat belt coils up, and find a little tab - push it with the screwdriver. As long as the seat belt is not twisted up, it should retract.

Nov 30, 2011 | GMC Cars & Trucks

1 Answer

Seal belts on both front seats (driver side and passenger side) will not pull out of the retractor. Don't want a fine for not wearing belt but it won't work. No one seems to know how to fix it. ...


No one can fix it!

Don't you find that odd?

You remove the plastic seat belt retractor covers,
on the floor by the "B" Piller

If you need to replace them, the retractors I mean, there
is a special GM Torx Driver Bit for seat belts

I would play around with them to see what the issues are

IF THEY HAVE AN AIR BAG INVOLVED e.g. SRS
System integrated into the seat belts,disconnect the battery
(before) you even think of going near the covers

Jul 01, 2011 | Cadillac DeVille Cars & Trucks

1 Answer

Seat belt is locked it wont go back in or out


Sometimes the belt is retracted with a twist in the fabric which will jam the roller inside the retractor assembly. It is necessary to pull hard on the belt to get this twist to pass out far enough to be untwisted. If unable to do so, then replace the retractor assembly as a unit. Good luck!

Jul 02, 2010 | Cars & Trucks

1 Answer

Retractable seat belt in a 2006 homda odessy van passinger seat belt wont retrack


You will need to replace the whole seat belt assembly. The retractor inside is Not-Servicable, no internal parts are servicable.

Jun 11, 2010 | 2006 Honda Odyssey

1 Answer

When not in use seat belt does not retract fully


the springs inside the seat belt retractors wear out over time. remove the trim from over the retractor and make sure nothing is rubbing the belt, and if it all looks alright, replace the seat belt.

Feb 17, 2010 | 1997 Honda Accord

Not finding what you are looking for?
1990 Mercedes-Benz E-Class Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85114 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...