Question about 2002 Volkswagen Jetta TDI

2 Answers

Break light on dash

Changed the front pads put light is still on

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem and check the brake fluid level - ok
Replaced the rear pads - some wear
Still the light stayed on
Try putting an electrical metre on the Sensor itself
That's what mine was.
Hope it works for you
Kevin in the Country

Posted on Nov 22, 2008

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi,

Initially, pls try checking the level of brake fluid in the reservoir above the master brake cylinder.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

Posted on Nov 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 vw


Hi. looks like the break pad warning. Are the outer brackets dotted? if so then replace the worn front break pads. Check the rear aswell.

Jul 07, 2014 | Volkswagen Beetle Cars & Trucks

1 Answer

How to reset dash brake light


Is the sensor shorting to the hub?

Mar 27, 2014 | 2004 Chevrolet Suburban

1 Answer

Brake Light on Dash


Have you tried bleeding the brakes? Sometimes air in the lines causes the break trouble light to come on.

Jul 14, 2017 | 2005 Porsche Boxster Convertible

2 Answers

Replace brake pad light on, how do you reset it?


you need to replace the pad wear sensor when the pad wears down it wears the sensor and the sensor needs to be replace if you look at the sensor you can see the wire on the sensor wears threw

May 19, 2012 | 2009 Audi Q7

1 Answer

I have a 2006 lr3 i just changed the rotors and pads on the fronts and backs but brake pad warning on the dash wont go away


Did you replace the wear sensors. If the sensors were activated(the light went on) before you changed the pads then the sensor must be replaced

Mar 07, 2011 | 2006 Land Rover LR3

1 Answer

1988 chevy c3500 with 454 engine. brake warning red light came on, we found that the drivers side brake pad was being held against the rotor creating a lot of heat and pad wear. we removed the calibur...


sounds like the flexable line close to the wheel is bad.
it has plastic inside it and when they get old the plastic breaks apart and plugs the line.

Feb 22, 2011 | Chevrolet 3500 Cars & Trucks

1 Answer

I'D CHANGED ROTORS & PADS (FRONT) NOW THE BREAK LITES ARE COMING ON EVERY TIME I BREAK


Hi,
The 'brake' light on the dash or the rear brake lights? Did you ensure the brake fluid level is correct?

Td

Jul 06, 2010 | 1997 Dodge Intrepid

1 Answer

I changed my break pads but the light on my


disconnect the positive wire on the battery for about 15 minutes an put it back on to see if that rests it

Feb 03, 2010 | 2001 BMW 325

1 Answer

Honda Civic 2007 Civic . Cahange wheel bearing and


sorry to tell you this but it sounds like the wheel bearing was put in backwards on one or both sides. the front wheel bearings have a black speed ring built in and that is what your speed sensor reads off. - this is common as the front bearings will install either way- hope this helps

Dec 12, 2009 | 2007 Honda Civic GX NGV Sedan

1 Answer

1998 328I Dash board brake light is on (a circle with dashes either side). Ive changed the brake pads but its still on... any ideas??? thanks


there is a break in the connection on one of the wires on the pads find it and your problem will be solved also check the brake fluid level it nay be low enough to set the light

Dec 01, 2009 | 1997 BMW 328

Not finding what you are looking for?
2002 Volkswagen Jetta TDI Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...