Question about 1992 Mitsubishi Eclipse

1 Answer

Timming marks i help settin the timming on a 1992 eclipse. i had to replace the water pump and i think i might have made the timming off a notch. the engine just turns over now

Posted by on

  • kevin craig
    kevin craig Nov 11, 2008

    2.0 non-turbo

  • alex metro
    alex metro May 11, 2010

    what motor do you have?

    1.8L

    2.0L non-turbo

    2.0L turbo

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Mitsubishi Master
  • 329 Answers

Here is a step-by-step guide (w/pictures) for the timing belt.
Camshaft Timing Belt Replacement/Adjustment Service Procedure

Posted on Nov 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987cadillac 4.1 v8 timming marks


They are on the timing cover actually the lower part of the water pump and there is a notch in the balancer.

Aug 25, 2014 | 1987 Cadillac DeVille

1 Answer

I need to know where to put the timing marks facing for alignment on a harmonica balancer


Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------

For water pump replacement i suggest you to check the help link provided below.

click the link below :----

Water pump replacing procedure for all vehicles?

http://technoanswers.blogspot.com/2011/11/water-pump-replacing-procedure-for-all.html
---------

HOW TO REPLACE A WATER PUMP

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-water-pump.html

------------------
How to route Water Pump Belt for 1992 Oldsmobile ?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html

---------
How to replace Water Pump on Car ?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-water-pump-on-acura-car.html

---------
How to Remove Water Pump?

http://technoanswers.blogspot.com/2011/12/how-to-remove-water-pump-on-toyota.html

-------
Where is Water Pump located ?

http://technoanswers.blogspot.com/2011/12/where-is-water-pump-located-on-toyota.html

-----------

This will help. Thanks.

Feb 14, 2012 | 1997 Nissan Pathfinder

2 Answers

I need the markings on a mazda xl v6 timming belt


Hi Marina,

These diagrams may be a little hard to see, but the cams have a mark that align with the raised "V" on the rear timing cover and the crankshaft pulley has a notch that aligns with the mark in the 12 O'clock position on the oil pump housing.

10_16_2011_10_28_43_pm.gif

10_16_2011_10_29_28_pm.gif

Oct 16, 2011 | 2002 Mazda 626

1 Answer

2002 mazda 626 replacing timming belt need to know where timming mark are and where to turn them ///v-6 dohc


TIMING MARKS SHOULD BE A NOTCH ON THE CAM GEAR, AND ONE ON THE CRANK GEAR! THEY SHOULD BE LINED UP FACING EACH OTHER!

Feb 22, 2011 | 1999 Mazda 626

1 Answer

Cam shaft timming marks 1999 Daewoo 1.6 liter


there is a special tool to hold gears in correct place on some of these models, but you can hold one cam at a time with a spanner then feed belt on exhaust cam then inlet cam gear
get someone to hold gears in place while you feed belt on.
the inlet cam is more prone to turn off mark more than exhaust.
if you have tensioner that needs retaining pin in when installing
you fit belt while aligning timming marks
fit tensioner as last spot to feed belt on with retaining pin in adjuster
get correct tension on belt by turning water pump so that you can flex (turn) belt 90 degrees only just while using finger and thumb
tighten water pump check flex
check all timing marks are correct
remove retaining pin from auto tensioner
turn motor over a couple of turns by hand observing tensioner arrow should hover around V mark and that all timing marks align up again(after one complete turn)

Aug 02, 2009 | 1999 Daewoo Lanos

1 Answer

Working on 1992 saab 900 replaced head gasket and settin the timing chain and the book is unclear of cam marks to cam bearing block marks. Dale


If you're not using the "Bentley Bible" aka the Saab 900 Official Service Manual, which costs about $40 from Amazon, you might have difficulty.

16 valve manual: http://www.amazon.com/Saab-900-Valve-Service-Manual/dp/0837603137

8 valve manual :http://www.amazon.com/Eight-Official-Service-Manual-1981-1988/dp/0837603102
get the appropriate manual for your car and enjoy the Saab!

Jul 07, 2009 | 1992 Saab 9000

1 Answer

I need to know how to set the timming marks on the 1.6 double over head cams to replace timming belt


timming marks on cams face each other 3 and 9 o clock crank mark at about 6 o clock mark in cover and sump auto adjuster arrow should be in v mark to set this requires turning water pump by loosening water pump bolts slightly be warned some times this causes pump o ring seal to leak if turning.

May 19, 2009 | 2000 Daewoo Lanos

1 Answer

Replaced battery on a 1992 Mitsubishi eclipse, still needs jump


THE HIGH LOW IDLE MAY BE A SIGN OF A LOW COOLANT LEVEL.THE IDLE CIRCUIT IS CONTROLED BY ENGINE TEMP.AS FAR AS THE BATTERY.THE STARTER MAY BE DRAWING TO MANY AMPS.THERE MAY BE A DRAIN ON THE ELECTRICAL SYSTEM W/THE KEY OUT.

May 01, 2009 | 1992 Mitsubishi Eclipse

1 Answer

Timing marks on lucida estima 3CT engine


hi the timming marks are on the plastic case thanks brian

Apr 28, 2009 | 1992 Toyota Previa

1 Answer

Golf fti 8v, 1993 k- reg 2 E engine, Is the engine at tdc?


slide a straw or a pen into the plug hole and slowly rotate crank pully back and forward and note the rise and fall of the straw this will indicate TDC . once TDC is achieved note the mark on the pully should be alighn with a mark on the timming case .rotor button to number one lead will have you on compression stroke .cheers MAL

Jan 02, 2009 | 1995 Volkswagen GTI

Not finding what you are looking for?
1992 Mitsubishi Eclipse Logo

Related Topics:

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...