Question about 2004 Mercury Grand Marquis

2 Answers

Head lights cut out. Can you help me repair them? 04 mecury marquis they are automatic.

I have a 04 merc. marquis with automatic head lights. The lights cut out at night and will not come back on. Some times the will come on when turn the switch on and off. I know there is a control unit. Can this be adjusted
some how ? The cost to replace this unit is over $395.00. Can the control unit be by passed ?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem. The lilghting control monule must be replaced. Mine cost me $400 installed.

Posted on Jun 15, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

Can be repaired
ginolena@sbcglobal.net

Posted on Apr 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dont know how to remove wiper motor on 1996 merc grnd mrqs


1. remove w/s wiper arms2. pull top cover from the wiper motor house, be sure to disconnect the w/s washer hoses.3. remove the 5 or 6, 8mm head bolts holding assembly to fire wall4. remove the sensor that is attached to assmembly on passenger side (2ea 8mm nuts)5. lift assembly and diconnect wires from motor and remove assembly.6. remove 3ea 10mm head bolts that hold motor to assembly.7. install new motor and reverse operation.

Nov 08, 2012 | 1996 Mercury Grand Marquis

1 Answer

Dash lights and tail lights don't work


Lights and electrical circuits are sometimes in pairs so that you notice something is wrong (tail lights and dash). On a '90 merc grand marq., that would be fuse #4,the 15 amp blue one, in the panel next to your left foot. If you are lucky,it
just failed from age. If you are not lucky, there is a short in the system containing
the dash, tail,parking,side marker, license lamps and trailer tow relay if equiped.I had to replace the push/pull main light switch which was shorted. If you are lucky, just replacing the fuse in the panel will do it. Referance Grand Marquis Owners Manual for fuses and function.

Apr 12, 2012 | 1990 Mercury Grand Marquis

1 Answer

Put coolant in and strts tripping in back of engine even if car is cold


Possible leaking expansion plug in the rear water jacket or maybe a warped cylinder head or blown head gasket. Lights and mirrors will help track it down. Might get expensive to repair if it's the head or it's gasket. Hope this helps!

Jun 27, 2010 | 1994 Mercury Grand Marquis

1 Answer

No air coming out air vents whats my problem i hae a 99 merc ls


If you have the electronic automatic climate control, it's likely that the rubber O-rings inside the vacuum solenoids in the EATC unit are leaking. Usually you'll get cold air only out the defrost vents or floor with this problem.

If you are mechanically oriented, you can fix it yourself. I repaired the EATC unit in my 2004 Mercury Marauder in about three hours.

Complete instructions, including photographs and the part numbers for new O-rings and the dielectric grease for reassembly can be found in the user forums at www.mercurymarauder.net.

This is a manufacturing issue with the EATC head unit, so if you get a new one, get a written warranty. A new EATC unit is around $600.00. The parts to do the work yourself are about $12.00.

Hope this helps!

D.M.

Feb 21, 2010 | 1999 Mercury Grand Marquis

1 Answer

1996 merc grand marquis Coil conversion


check out " strutmasters.com " They have what you are looking for. They are on the east coast and have the spring kit. The car will ride just as well and never have a suspension problem again. Trust me on this.

Nov 19, 2009 | 1996 Mercury Grand Marquis

1 Answer

Location of starter on 1995 mecury grand marquis


on the 4.6 motor the starter is on the pass.side....3#--- 10mm head bolt retain the starter to the bell hse. top inner is tuff to get to... disconnect battery prior to removal....hope this helped...GL

Jul 06, 2009 | 1995 Mercury Grand Marquis

1 Answer

I need torque specs for head bolts on 1992 merc benz 230 e


hello,230e with engine 102.982,cylinder head bolt,double hexagonal socket m12, stage 1, 55 newton meter,stage 2 90 degrees stage 3 90 degrees,4 pcs. bolt with m8 tighten to 25 nm.ref. technical data year 1993,ty

Apr 17, 2009 | 1992 Mercedes-Benz E-Class

2 Answers

Remove front door panel on 1995 merc grand marquis


http://www.autoclinix.com/Mercury/Front%20Speakers2.htm

Dec 27, 2008 | 1995 Mercury Grand Marquis

Not finding what you are looking for?
2004 Mercury Grand Marquis Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...