SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: HOW TO INSTALL THE SIDE MIRRORS ON A 2500 DODGE
If you're lucky, on the inside of the door, will be a triangular panel
right behind the mirror that you can pop off. If you're not as lucky
and it's one piece or the panel is blocked by the door panel, you'll
need to remove the door panel to change it.
On the inside trim,
you can remove screws (these screws may be covered by filler pieces or
may be visible, or they may require you pry a plastic piece off that
covers the screws) that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can remove the bolts
holding the mirror onto the door
SOURCE: 2000 dodge truck code po203 po204
p0203 injecter circuit malfunction cyl #3. p0204 injector circuit malfunction cyl#4. po138 02 sensor circuit,high voltage cylinder bank no.1,sensor no.2
SOURCE: 2001 Ram 3500 Truck: replacing powersteering pump on 1999 dodge 1 ton 3...
it is best to remove the pwr st. pump and vaccum pump assy as a unit which is held to the front cover w/2 15mm head bolt and a support bracket on the bottom bolt next to the block @ the pwr st pump. and disconnect all lines. get the seal kit and replace them @ this time. if you don't and just replace the pump you will probably develop an oil leak where the shaft meshes w/ the adapter.
193 views
Usually answered in minutes!
×