The steering damper on my 1997 land rover discovery is broken. the replacement part is on back order. can i drive it until the part arrives?

SOURCE: i need fireing order for v8 4.0

http://www.landrover.ee/est/files/manuals/engine/v8-46e.pdf

18436572 just like a chevy...1357 cylinders on drivers side ...2468 on passenger

Marvin

• 85242 Answers
• Posted on Feb 17, 2009

SOURCE: WHERE IS THE FUEL FILTER LOCATED ON LAND ROVER DISCOVERY 2000

go to this page for detailed instructions on replacing your fuel filter
http://www.roverunited.com/tech/fuel-filter/discovery-fuel-filter.htm

Colin Stickland

• 22516 Answers
• Posted on Sep 10, 2009

SOURCE: how do you get the steering wheel off a land rover

with great difficulty,first you have to disconnect battery to stop air bag accidently going off ,then remove the air bab ,two clips underneath steering wheel ,very difficult without the right tools ,then the big nut and maybe evan a steering wheel puller.Whats the fault that necessatates removing the steering wheel in the first place?

SOURCE: 97 Land rover discovery 1 oil light comes on after approx. 15 mil

Tune-Up-Parts Link:

http://www.britishpacific.com/BPSite/LandRoverDiscovery/DiscoIService.html

Testimonial: "Great site for Land Rover parts. Thanks for the suggestion."

SOURCE: Land Rover Discovery I dashboard replacement.

There is a little more to it than that, but not a tough job if you have patience. You will need to remove both 'doors' on the dash-one glovebox, one fuse access panel. on US models, you will need to remove the pass side airbag as well, then 2 bolts that hold a set of relays under the airbag, then 5 bolts that hold a support bracket (also under the pass side airbag-behind glovebox.

Then under the dash at teh outside near the doors, remove 2 sets of 10mm bolts. after than remove 2 sets of 10mm bolts near where the bottom of the dash touches the tranny tunnel. obviously all the center console needs to be removed, and the center panel of the dash, as there are several sets of screws that hold that to the back of the dash.

be patient, take lots of photos of how it goes together, and where the wiring is(was), and this is pretty easy.

Thanks