Question about 2000 Ford Explorer

1 Answer

2001 Ford Explorer Sport

4.0L, SOHC. Where is PCV Valve?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Pcv is on the back side(firewall) of the drivers side valve cover.held in buy lock tabs,turn then pull to remove.

Posted on Nov 10, 2008

5 Suggested Answers

  • 92 Answers

SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location

the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

Posted on Oct 21, 2008

SOURCE: pcv valve

I have a 98 4L SOHC . The valve seems to be behind the intake manifold. The emissions diagram shows 2 hoses going to it. Local dealership swears Part #EV225 is correct. You would not believe how much of the internet is devoted to this situation

Posted on Sep 23, 2008

Handy Mike
  • 6 Answers

SOURCE: how do i replace the pcv valve on a 2000 explorer xlt v6 sohc?

On the passenger side of the intake manifold, coming off the bottom about the center of the engine front to back, you'll feel a hose that comes off a nipple. That hose makes a 90 degree bend and goes around to the rear of the motor. Where that hose meets the Y-connector from the other side of the intake you'll find the PCV valve. It's almost impossible to see it with the hood installed, and even tougher to reach it.

A good source of information for Ford Explorers can be found here

Posted on Oct 25, 2008

  • 1596 Answers

SOURCE: pcv valve :where is it located on a 1999 ford explorer sport 2wd

Look For A 3/8 th's Vacuum Hose Coming from The Base of Throtle Body Fallow it to the 2 Line PCV At Valve cover

Posted on Feb 10, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 ford explorer sport, im trying to figure out whether or not its a 4.0L pushrod v6 or a 4.0L sohc v6


if the moter says sohc on the valve cover that means the cam is in the head but most ford V6 motors have the cam in the block making it have pushrods.

Dec 12, 2010 | 1994 Ford Explorer Limited

1 Answer

Timing chain guide replacement on right side on 4.0 sohc ford sport trac 2001


You will have to pull out the motor. Remove the both oil pans, intake and cylinder heads. Plus you will need a whole bunch of special tools.

Apr 03, 2010 | 2001 Ford Explorer Sport Trac

1 Answer

Need 2 loc8 PCV on 1999 Exploer 2WD 6CYL SOHC.


The pcv valve is typically located in the valve cover near the brake booster which is on the drivers side

Jan 20, 2010 | 1999 Ford Explorer

1 Answer

2001 Ford Explorer 4.0 SOHC no timing marks on cam or chain


get a haynes manual and look up camshaft replacement..its worth the 30 bucks

May 04, 2009 | 2001 Ford Explorer Sport

3 Answers

Pcv valve :where is it located on a 1999 ford explorer sport 2wd


It is located at the back of the engine near the fire wall. It is gray with a T connector at the top with two hoses coming off of the T and going forward into the intake manifold.

Feb 10, 2009 | 1999 Ford Explorer

1 Answer

1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location


the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

Sep 25, 2008 | 1998 Ford Explorer

1 Answer

How do i replace the pcv valve on a 2000 explorer xlt v6 sohc?


On the passenger side of the intake manifold, coming off the bottom about the center of the engine front to back, you'll feel a hose that comes off a nipple. That hose makes a 90 degree bend and goes around to the rear of the motor. Where that hose meets the Y-connector from the other side of the intake you'll find the PCV valve. It's almost impossible to see it with the hood installed, and even tougher to reach it.

A good source of information for Ford Explorers can be found here

Jul 22, 2008 | 2000 Ford Explorer

2 Answers

Pcv valve


Normally located on top of the valve cover.

Jun 24, 2008 | 2003 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

428 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...