Cars & Trucks Logo

Related Topics:

Posted on Nov 10, 2008

Car is very temporamental...starts 8 times out of 10

1 Answer

yungtek

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

  • Contributor 47 Answers
  • Posted on Nov 10, 2008
yungtek
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Joined: Nov 10, 2008
Answers
47
Questions
0
Helped
19307
Points
64

Lancers won't start if the battery is too low, they will crank fine but never spark. the other possibility is fuel... chk back pressure regulator, fuel pump relay and fuel pump.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Put new batteries in and it won't turn on.

  1. New battery, but still needs to jump start. Why? (auto, best ...

    www.city-data.com > City-Data Forum > General Forums > Automotive May 31, 2011 - 10 posts - ‎8 authors
    If the 2nd new battery never could start the car, I would say bad ... the 'clicking' sound and won't turn over with a brand new battery, I'd wager a ... Car Won't Start: Battery Corrosion (auto, GTR, best, buy ...
    10 posts
    Jul 24, 2013
    car won't start and no click, click, from solenoid. (buy ...
    10 posts
    Jul 13, 2011
    More results from www.city-data.com

    New Car Battery Still Won't Start - Auto Repair - TalkLocal Blog

    www.talklocal.com/blog/2012/10/s/.../new-car-battery-still-wont-start/
    Oct 31, 2012 - You have a new car battery and your car still won't start. Use these helpful tips to save money and get back driving on the road in no time.
0helpful
1answer

How can i fix my honda 160i luxline 92 model starting difficulty?

Yes, you need to set your camshaft end distributor timing to TDC. (top dead centre). now you start vehicle, and adjust your distributor timing to 10% after tdc, on the coast or 8% inland
1helpful
1answer

Abnormal voltage codes 1990 subaru legacy

The bat/alternator could be bad. Have both tested and replace as neccessary.
0helpful
1answer

LOSE PRIME OVER NIGHT OR SET WITH ENGINE RUNNING . BUT LITTLE THE IN TAKE IT START RIGHT UP . IT 1993 JIMMY VOXTEX 4.3

sounds like fuel pump check valve stuck if you just cycle the key on 8 sec off 10 sec a few times it will start without spraying intake unfortunately they at times will loosen by them selves but not all the time try a fuel cleaner in the gas tank if that dont work you can live with it or replace check valve or pump
0helpful
1answer

Engine cranks for 8-10 seconds before it starts when engine is warm

you must RUN the SCANNER/computer for better diagnostic and fix it. YOu can have some faulty like: PCM+BCM+ignition coil, sensor, etc. see the diagram attached.
God bless you225004b9-8d42-483d-a0e8-ee6550772ecc.jpg8c2fbe48-c384-4953-ac1d-abce3867e5a4.jpg
0helpful
1answer

Security light comes on the car want start for 4 to 8 min what,s the problem

next time it does this turn ignition to the crank position hold for 10 secounds release to the on position leave it like this for 10 min. try to restart if car starts you needed to reprogram key and ignition if it keeps doing replace both
0helpful
1answer
0helpful
1answer

MOTOR TURNS OVER BUT WILL NOT START,wait 10 mins.

sounds like bad battery or negitive cable problem. also make sure you engine and chasis grounds are replaced, bad grounds cause intermintent problems
Not finding what you are looking for?

136 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...