Question about 1992 Ford Ranger

1 Answer

1992 Ford Ranger Healights

I have a 1992 ford ranger 2.3 4cyl, 5 speed. My headlights only come on when i hold them, immediately when i release the lever the light goes out.
my parking lights come on, i check and replace the headlight honest jacket with light each, now when i pull the level the headligts come, but still no deem lights, or when i turn or pull the level for light i get the parking lights, only when i pulled the level and hold the level i can get the highbeam, but inaddition now the door chimes, or beeper stays on, util i take the key out, i am trying to trace the door beeper thru the fuse, i can pulled the number 20 amp fuse located in the fuse compartment inside the truck, and all will go out, do anyone has a fuse outlined diagram, and can someone advise on the lights problem

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

HAD THE SAME PROBLEM

REPLACED THE BLINKER/FLASHER/HIGH/LO/WHINDSHILD WHIPER UNIT $70 AT YOUR LOCAL AUTO ZOO EASY FIX THREE SCREWS FROM BOTTOM OF COLUM. REMOVE PLASTIC COVERS REMOVE 2 SCREWS FROM BLINKER UNIT REMOVE TWO CONECTORS AND INSTALL NEW

HOPE THIS HELPS

Posted on Apr 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to know what 5 speed transmissions will interchange with a 92 ranger with a 3.0


You didn't mention if it was 2 or 4 wheel drive so I went with a 2 wheel drive. According to hollander the 5 speed transmaaion fits a ranger (2WD) 1991 - 1994 and a Mazda B3000 1994 only. Hope this helps.....

Oct 29, 2012 | 1992 Ford Ranger

1 Answer

Where do I put transmission fluid in my 1992 Ford Ranger 5 speed.


on the drives side of your trans should be a plug like 7/8 not on the bottom but on the side pull plug out my truck uses ATF stick finger in hole to see if you use ATF if so fill till fliud leeks out then relplug check owners manual for rite fliud

Jun 16, 2011 | 1992 Ford Ranger

1 Answer

Speed sensor on a 1992 ford ranger. Where is it located.


The speed sensors are usually on the rear of the tranny, you should have 2 sitting back there, one is the speedometer, and the other is the speed sensor. Now, I am not 100% positive of your truck, but take a peek and see what you got. Hope it helps.

Sep 30, 2010 | 1992 Ford Ranger

2 Answers

What type tramission fluid to use for 5speed manual-4cyle?


1992 Ford Ranger came with two different type of 5 speed stander transmission's that year.

For a Mazda stander trans it take's Automatic transmission fluid Mercon.

for a Mitsubishi stander transmission it take's Ford manual transmission fluid.

Hope this help's.

Jun 28, 2010 | 1992 Ford Ranger

1 Answer

I have a 1994 Ford Ranger that blows its headlight


sounds lick you have a dead short check all the wires going to that light make sure no bare spots in wires and check the light socket is in good condition and not burnt up..

Nov 24, 2009 | 1992 Ford Ranger

1 Answer

Both head lights don't work on my 1992 Ford Ranger. Could it be a fuse? All other lights are working.


I believe headlights have a self resetting circuit breaker. Perhaps the headlight switch is bad, or the dimmer switch... both must work for headlights to work. Get a meter or test light and check to see where you're not getting power. I hope this helps.

Oct 14, 2009 | 1992 Ford Ranger

1 Answer

91 Ford Ranger XLT, 4 cyl, manual 5 spd. Engine


most likely right on top of steering colum around have way down

Oct 07, 2009 | 1992 Ford Taurus

1 Answer

2003 Ford Ranger, 5 speed manual. Sometimes I


if you have a slave cylinder on it my not be working right,, if you have levers maybe a brushing wearing out cause wobble

Aug 12, 2009 | 2003 Ford Ranger Regular Cab

2 Answers

Clutch release bearing removal


You have the transmission out and are trying to remove it from the slave cylinder right? Just pull straight out. It should pop free. It just has plastic tabs that hold it on.

May 30, 2009 | 1992 Ford Ranger

Not finding what you are looking for?
1992 Ford Ranger Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...