Question about Audi A4

1 Answer

Audi a4 2003 2.4 v6 surging slightly under low acceleration

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

It could be a dirty IAC (idle air control vavle.) Take of the air duct work from the throttle body. Using a good cleaner or enginr Top cleaner.Run the car at about 1000 RPMs spary the cleaner directly into the IAC which is located right straight in the throttle body.turn engine off. let the cleaner sit for a few miniutes. then repeat procedure. if that does not work, remove the vavle and spray cleaner directly into the two holes on the valve.

Posted on Nov 10, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi 2002 a4 v6 2.4l when the car first starts the RPMs surge up and down unsteadily this stops if you give a few revs on the accelerator pedal. When driving around 50kph the rpms surge slightly it feels...


You have two problems. The surging is from a dirty throttle body and /or air filter. The selector light could be from a bad selector switch or internal transmission problems. Have the car scanned for codes.

Oct 20, 2014 | 2002 Audi A4

1 Answer

Audi 2002 a4 v6 2.4l when the car first starts the RPMs surge up and down this stops if you give it some accelerator pedal. when driving around 50kph the rpms surge slightly it feels like a gentle tug...


It seems like you need to have your car's TCM scanned .The flashing lights always mean a TCM going bad.You can get a rebuilt one for around $300-$400 www.programainc.com/ in Boca Raton Fl.If you live in South Florida Call German Car Depot 954-921-1515 we can scan and install a new one if needed. Ollieracepnc

Oct 20, 2014 | 2002 Audi A4

2 Answers

Low oil


It should be under factory warranty, so let the dealer handle it.

Jul 10, 2012 | 2012 Volkswagen Passat

1 Answer

Hesitation in acceleration with no check engine light


MOST TIME CAR STUMBLE OR HESITATION ON ACCELERATION YOU.HAVE A SLIGHT LEAN FUEL MIXTURE.CAUSED BY STOPPED UP FUEL INJECTORS OR FUEL FILTER SLIGHTLY PLUGGED.

Jun 07, 2010 | 2001 Audi A4

1 Answer

CAR SURGES WHEN YOU ACCELERATE IN OVER DRIVE.


It may be the MAF sensor. In needs to be cleaned or replaced. Located on the throttle body, under the engine cover. Might need special anti-tamper Torx sockets to remove. 2 bolts. One wire connector.

I had to replace mine on 2002 3800 V6. Bucked and shook on moderate to hard acceleration at about 3500-4000 rpms.

Feb 03, 2010 | 2002 Chevrolet Impala

1 Answer

Surging during acceleration


If it always, under acceleration, reguardles of what gear you are in, it is must likely, your ignition wires. If it's while coasting, past 45, vehicle in fourth gear, then it would be an isue with your trans. i.e. trans coming in and out of fourth gear or a torck converter clutch problem. Should have codes. If so what are they?

Jan 16, 2009 | 2001 Buick Century

1 Answer

AUDI A4 2.4 V6 1999 Low power in reverse and engine surges


Check for a vaccuum leak around the engine (specifically the PCV line). You can usually hear a hissing sound if you listen closely. The leak will not allow proper intake when idling, hence the nearly dying part. More air is allowed in while throttling so it isn't as noticeable. You can trace the vaccuum lines from the intake manifold. If you can't find it, you can follow your HVAC lines, they are fed from the same spot.


If you take it to a mechanic who can recognize it, it is a relatively inexpensive repair. Usually just labor to tighten up the hoses.

Jan 13, 2009 | 1999 Audi A4

1 Answer

A3 power surges


run the fault codes
could be a transmission actuator problem as it senses vacuum changes when moving the accelerator and tries to change ratios ( 2000 to 2500 rpm indicates a ratio change which is the speed increase momentarily until the Transmission range sensor puts it back in the correct ratio for the road speed
check the wiring to the transmission
it is a sensor problem not a transmission failing

Jul 01, 2017 | 2002 Audi A6

1 Answer

AUDI 80 1994 Misfires cuts out at low speeds


Have Audi 1994 80 v6 2.6lPrefix ABC No power on acceleration but is intermittant, feels like loss of fuel

Oct 25, 2008 | 1992 Audi 80

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

549 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77202 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14394 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...