Question about Honda Civic

1 Answer

Driver seatbelt not working - Civic Honda Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 94 Answers

Hi begoniababe, when you say not working do you mean it wont latch? if so it would be a safety issue and may be a recall check with your car dealer it may be fixed for free good luck

Posted on Nov 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Seatbelt will not extract on driver side


There should be a mechanism in the door jamb near-to the seatbelt. If equipped, push on it while jerking seatbelt until it retracts. If not equipped, close door firmly while jerking seatbelt to activate retract.

May 09, 2014 | 2004 Mazda 3

1 Answer

My 2004 rodeo alternator will not work if driver seatbelt not engaged


I would say to make a new ground for the Alternator. If you go to Autozone.com and sign in free, you can access their wiring diagrams.

Look for both engine and chassis wiring. I suspect there is a bad ground for the Alternator. Also check the wiring Fuse block and your Owners manual. See if the Battery light, seatbelt light, and so on are on the same fuse.

If someone installed a fastener it may have combined some wires that were intended to be separate.

Dec 04, 2011 | Cars & Trucks

1 Answer

'06 Volvo V50 drivers seat belt is jammed, there is no play in the belt and the ratchet locks immediatly no matter how gently it's pulled. Same problem with passenger side the day before but it righted...


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

good luck and don't give up.

Feb 07, 2010 | 2008 Volvo V50

2 Answers

CLK seatbelt presenter has stopped working on


check the fuse box of your car if any of the fuse has cut or melted then it should be the fuse of that driver side seatbelt presenter so it needed to be changed. open the burnet of your car and locate the fuse box at the right hand corner of your engine side.
good luck

rate this

Nov 19, 2009 | 2004 Mercedes-Benz CLK-Class

2 Answers

Driver seat belt will not extend out from door pillar.


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Nov 05, 2009 | 2000 Volvo S80

1 Answer

Drivers side seatbelt connected When truck is


sensor in the seat belt bukle needs to be replaced

Aug 01, 2009 | 2004 Ford F150

1 Answer

Automatic seatbelt 1994 saturn


You may have to replace the seatbelt positioner.
Check with Saturn (or their replacement GM division) to find if the warranty is extended for seatbelts (some manufacturers cover seatbelts forever) 800-553-6000

Jul 13, 2009 | 1994 Saturn Sl

1 Answer

Seatbelt Unlatches


This sounds like something broken in the latch. Do yourself a favor. Before it comes unlatched in an accident, go to your local dealer and get a replacement latch ASAP. That is one device in a car you shouldn't ever have to question. If it doesn't work right, replace it.

Feb 03, 2009 | 2004 Ford F150

1 Answer

Automatic seatbelts to manual seatbelts


if i were you i would try to make the ones from either the mark 3 supra or try the es250.. im trying to get it to work with the supra but i think your best bet is from the lexus es250. they share the same chassis obviously so most parts are interchangeable.

Jul 25, 2008 | 1991 Toyota Cressida

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...