- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
fuel pump, or fuel punp relay mounted on fire wall, check the fuse in relay, also check the ground wire from fuel pump (in tank) to the inlet pipe , under the truck, where you put gas in, fuel pump needs a good ground period. fuel pump could be on its last leg ! reason why I know this is cause I have a 1988 gmc 3/4 ton. to access fuel pump, I cut an access opening in truck bed, 12" square above tank at location of pump. better than dropping tank, besides the truck is how old ? makes a hard job easy. change your fuel filter also. good luck, ken
The fuel pressure should be 60 to 65psi in your system with the engine not running and fuel line primed, (ignition key's to the run position). Once engine is running the fuel pressure should drop by 5psi, change the fuel filter and recheck the fuel pressure at the shredder valve. it's known for the fuel pump to fail when the gas tank runs low or out of gas, the pump will end up burning it self out since the gas is what keeps the electric fuel pump cooled. The other thing to is putting gas through the top of the throttle body to start the engine on the SEFI is a NO NO, well a BIG NO NO. it's been know for the gas in the intake to catch fire and burn up the poppet valve in the injection system causing the replacement of the fuel injection system. Keep me posted and good luck, be gald to help you get your truck running again for the july 4th. OH and it was not mentioned but did the fuel filter get replaced???
Is it fuel injected or carb??? Try holding the gas pedal to the floor while turning the jeep over. This sometimes makes gas pump thru to the cylinders. Have you changed the fuel filter???? I know alot of jeeps have a fule filter with a bypass back to the tank, and sometimes the filter will be bypassing to the tank instead of the the motor. Check it out?????
there is a bleeder on the gas rail bleed some out on a rag and see if it was gas you filled up with or water i have run in to gas stations not fixing cracked tanks and as you know water floats on gas.start rag on fire gas is good if it doesnt light than you need to hurt someone heehe. ok now if your gas is good then the next step is to turn your ignition key on but not try to start and listen to see if you can here the fuel pump kicken in if not there is your problem is so then you need to replace your fuel line filter. good luck.