Question about 1994 Jaguar XJ6

1 Answer

Re. the light in the dash

It is not the check engine light it is above it . it looks like a bottle with an x through it. it came on after i changed the oil

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jaguar Master
  • 22,326 Answers

Oil level light i think few people posted this but i havent gone to garage and uncovered my baby to look in the manual i have in the boot.must look soon in case its missing me and thinks iam dead or something,must be due another polish soon as well ,then covered up again till its due for its inspection.

Posted on Nov 13, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

The windshield washer fluid is full but the light is still on

There is a sensor in the washer fluid bottle . like a float ,when rises to the top it turns off the light. It mite be stuck or bad.

Dec 26, 2014 | Cars & Trucks

1 Answer

I cant find the connector on my 1995 honda accord i checked everywhere its the connector for the diagnose of my check engine light

Hi there,

By law, the OBD connectors were required to change to the new 16pin connector (2 rows of 8pins) in 1996.

Have a look for this connector above the driver's knee, under the dash.

However, as your vehicle is 1995, it's possible yours will have the earlier 2pin connector (usually green or blue). This is found either a) behind the centre console - below the dash; b) under the passenger side dash; c) inside the kick panel; d) under the passenger seat.

This connector could also be plugged into a holder connector.


"If this has helped you in any way, please rate this solution or kindly leave a recommendation"

May 13, 2011 | 1995 Honda Accord

1 Answer

How to reset inspection light on 2000 bmw 323

You need a tool that plugs in to the computer connector under the dash above your left foot. The most popular brand is Peake, but there are several brands that will work. This tool will reset the oil change light, the inspection light, and the check engine light, and will read out engine control system error codes.

Feb 19, 2011 | 2003 BMW 325

1 Answer

1. I observe that within every 3 months, i need to change each side shocks absorber at the back? Do I need to change the 2 at once to avoid changing them over and over again? 2. My slow run is always...

it is alwas best to replace shocks/struts as a set per the axle. it seems that you have a high idle problem. the check engine light is probably related but what do you mean when you say that you "unplug the slow run sensor" that will turn the light on also.

Nov 19, 2010 | 2001 Toyota Corolla

1 Answer

Warning light above temperature guagee is flashing

When the engine is cold, I would check the anti-freeze level in the plastic bottle on the left in the picture below. Also check to see if your cooling fan is coming on.0ff55ab.jpg

May 06, 2010 | 1996 Saturn SL

2 Answers

Dashboard warning light

Check your mass air sensor MAS it may need cleaned or changed

Jul 20, 2009 | 2006 Fiat Strada

1 Answer

1994 LEXUS LS 400


I would just check the wiring going to the sensor on the washer fluid bottle. There could be a loose wire. Once the wire is checked. The only other option is to change out the washer bottle . The sensor is not sold seperately.

Apr 30, 2009 | 1994 Lexus LS 400

1 Answer

Buick 1999 century replaced the sensor light and still comes on.

your buick century has a low coolant level sensor located in the passenger side of the radiator , sometiomes the sensor get covered with coolant sludge and will show that the cooling system is not filled , sometime the radiator is just still low on coolant . check the radiator when the engine is cold ( IF HOT WAIT !!! 30 mins ) and make sure the level is above the sensor.

Feb 06, 2009 | 1999 Buick Century

Not finding what you are looking for?
1994 Jaguar XJ6 Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

79865 Answers


Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides