How do I change the studs on front right side.3 Lug nuts are no good. At least 2 studs need to be changed, maybe 3. Do the punch out the backside of hub?
There is usually a notch in the backing(dust) plate or on the spindle itself so that the studs can be pushed through. Every now and again, depending on the vehicle you will have to remove the backing(dust) plate.
The easiest way to replace them is to do with an Impact hammer with a flat valve attachment. It will force them out and press them back in place without too much of an effort. But be sure to run a nut down flush with the hub initially when installing the studs to ensure they are installed straight. If they are installed at an angle you could run the risk of reaming out the splines and end up have to replace the whole hub.
SOURCE: my lug nut studs roke off where do they sell the
Hello there:these studs are pressed in to each hole using a press most machine shops will have the capability of getting them off for you.
now as far as getting new ones you can go to autozone or kragen auto parts or carquest or any good car parts buisness place ok they generally run about 5 to 10 dollars for the whole set ok.
I hope that this very helpful for you.
best regards michael
SOURCE: 2001 dodge stratus.how to change lug nut studs on the
take the tire off and the brake rotor see if u have room to hit the studs out with a punch and then to reintsall them put the studs in the hole tighten witha lug nut and washer
192 views
Usually answered in minutes!
×