Question about 2000 Dodge Durango

1 Answer

Idling high and running hot

During summer car was running hot. Replaced electronic fan relay, thermostat, coolant sensor and top hose. Car ran fine for a few months. The car has started running hot again, over 230 degrees within twenty miles of driving with the additional problem of a high idle, around 900 RPM. Any suggestions? Car has over 100,000 miles on it but runs well otherwise.

Posted by on

  • Anonymous Apr 07, 2009

    Exact same

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 303 Answers

Did you change the thermostat? and it sounds like you have a vacuum leak that will make it idle high

Posted on Nov 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Before! My car ran hot when I turned on a/c. At one time I was running 50/50 antifreeze. I changed the thermostat, and mechanic friend said take radiator top off run car for 15min to get water out of...


Never ever put undiluted coolant/antifreeze in your vehicle. It is to thick and will cause even more overheating and other problems as well. One fan should run almost the instant you turn the A/C on.
The other fan is controled by coolant temperature. You should check the fan relays, fuse's and coolant temperature sensors for proper operation. Also clean the condensor and radiator fins with a good stream of water from a garden hose, not high pressure water at a car wash. The water pump may be worn out as well.

Aug 03, 2011 | 2001 Jeep Grand Cherokee

1 Answer

Overheating


CAR OVERHEATING FIRST CHECK FOR LOW COOLANT IN THE RADIATOR COOLANT OVERFLOW JUG.IF COOLANT LEVEL IN OVERFLOW JUG LOW REFILL ADD COOLANT BACK TO THE FULL COLD MARK.PUT RADAITOR CAP ON COOLANT OVERFLOW JUG START ENGINE LET IT IDLE UNTIL IT OPERATING TEMPERATURE.MAKE SURE TOP RADIATOR HOSE GETTING HOT WHILE ENGINE WARM UP.IF TOP RADIATOR HOSE DONT GET HOT WHILE ENGINE IDLING YOUR THERMOSTAT COULD BE STUCK CLOSE CAUSING CAR TO OVERHEAT.IF TOP HOSE IS GETTING HOT.CHECK FOR COOLANT LEAKS CHECK TOP RADIATOR HOSE AND BOTTOM RADIATOR HOSE FOR LEAKS.CHECK FOR LEAKS AT THE RADIATOR CORES AND PLASTIC SIDE CONTAINERS.IF ALL IS GOOD ENGINE OVERHEATING WHILE IN A LONG TRAFFIC LINE, COOLANT FANS NOT COMING ON.COULD HAVE FAULTY ENGINE COOLANT TEMPERATURE SENSOR OR BLOWN COOLING FAN FUSE OR RELAY.COULD HAVE PCM FAULT.MAKE COOLING FAN ELECTRICAL CONNECTORS AND WIRING NOT DAMAGE OR BROKEN.

Jul 17, 2011 | 1999 Oldsmobile Alero

1 Answer

Car overheated and lost all power. how do I get it to start?


ENGINE NOT GOING TO START IF GET TOO HOT FIRST THING I WOULD REPLACE THERMOSTAT AND RADIATOR PRESSURE CAP THEN ADD COOLANT UNTIL COOLANT LEVEL CORRECT THATS WHEN THERMOSTAT OPEN UP AND TOP HOSE HOT.CHECK FOR LEAKING RADIATOR HOSES CHECK TOP RADIATOR HOSE CHECK BOTTOM RADIATOR HOSE.CHECK FOR LEAKS AROUND THE RADIATOR LOOK DOWN BELOW COOLANTS FANS CHECK FOR LEAKS AT RADIATOR CORES OR LEAKS AT THE RADIATOR PLASTIC SIDE CONTAINERS. CHECK FOR LEAKS AT WATER PUMP WEEP HOLE AND CHECK FOR LEAKS AT THE HEATER HOSES AROUND ENGINE BLOCK TO THE HEATER CORE HOSES. THERE IS A REASON CAR OVERHEAT.IF CAR OVERHEAT WHILE DRIVING YOU HAVE FAULTY THERMOSTAT OR LEAKING OUT COOLANT OR BLOWN HEAD GASKET.IF ENGINE OVER HEAT WHILE SITTING DURING A LONG IDLING PERIOD.YOU COULD HAVE FAULTY COOLANT TEMPERATURE SENSOR OR FAULTY COOLING FAN FUSE OR RELAY.HOT WIRE COOLANT TO SEE IF IT RUNS IF NO REPLACE FAN MOTOR. IF YES FAN MOTOR COULD HAVE FAULTY WIRE OR PCM FAILURE. CHECK ENGINE CRANKCASE IF OIL LOOKS LIKE MILK SHAKE ENGINE HEAD GASKET LEAKING.

Nov 26, 2010 | 2002 Mitsubishi Galant

1 Answer

Engine running hot


CHECK ENGINE COOLANT LEVEL.IF OKAY.CHECK BOTH RADIATOR HOSES BOTH SHOULD BE HOT. IF THERMOSTAT TOP HOSE NOT HOT YOU HAVE A FAULTY THERMOSTAT AND RADIATOR PRESSURE CAP IF RADIATOR HOSES HOT AND THERMOSTAT OKAY.IF ENGINE OVERHEATING WHILE CAR SITTING IN A LONG TRAFFIC LINE COOLANT FANS NOT RUNNING.THE COOLANT TEMPERATURE SENSOR IS BAD OR YOU HAVE FAULTY FUSE OR RELAY.THE FAN MOTOR DEFECTIVE, WIRES AT MOTOR HAS A SHORT OR PCM FAILURE DEAD DRIVE CIRCUIT TO FAN.

Sep 09, 2010 | Ford Thunderbird Cars & Trucks

1 Answer

Sometimes stalls or surges when hot, runs hot


Clean the temperature sensor wire connector.
Replace the temp sensor near the thermostat hosing.

Check the condition of the sensor wire cut(s) or short onto the engine block.

Monitor the fan operation with the hood open during warm up (0-15 minutes.) It should ran after the engine coolant temp get above 195F +.

Test fan relay.

Feb 10, 2010 | 1993 Buick LeSabre

2 Answers

Car running hot, radiator has been flushed, heater coil flushed, themostat replaced


Air pocket in coolant system.

====

When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Nov 16, 2009 | 1995 Cadillac DeVille

3 Answers

My car is running hot then cool, it seems to run hot when I use the heater and run cool when I use the AC, is this a problem with the thermostat?


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BEKIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat2_bing.gif open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may bepartially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do ahydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Oct 19, 2009 | 2002 Mazda 626

3 Answers

1998 bmw Z3 running hot replaced thermostat and continues to run hot replaced aluminum engine 10 months ago,with cast iron engine with 68,000 miles


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Oct 03, 2009 | BMW Z3 Cars & Trucks

2 Answers

Still running hot after changing therm. 2000 lincoln ls


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Sep 07, 2009 | 2001 Lincoln LS

1 Answer

Running hot


Radiator Fan Control Relay Switch. I bet your electric fan doesn't run?

Dec 01, 2008 | 2002 Nissan Altima

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

307 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...