Question about 1992 Honda Accord

1 Answer

FRONT DOOR WINDOW

MY WINDOW IS OFF TRACK. ELECTRIC WINDOWS. CAN I FIX THIS MYSELF

Posted by on

  • Anonymous Nov 11, 2008

    I have the same problem.

  • daviestp Nov 13, 2008

    Yeah, I tried removing the inner panel of the window but got stuck with the door handle. It just would not come off. I remove the screw on the lock and other screws on the panel, but the one holding the door lock; the small lever you pull to open the door from inside, will not detach. Pls. whoever has the solution to deconnecting this lever should speak up.

    Thanks

    Dave. St. Louis, MO

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Yes. I have fixed my driver side window several times. The window went all the way down and came off the track, usually because the window automatically went all the way down. The first step was to take the interior side of the door off: (1) I unscrewed the screws around the door and pull the plastic screws out. (2) I disconnected the thin metal rod that connects the door handle to the door frame to be able to pull the interior part of the door away from the metal frame of the door. (3) I unscrewed the speaker to see where the window meets the rubber track. (4) I kept the electrical wires connected so that I could use the electric window button to lower and raise the window. (5) I lowered the window down below the rubber track and loosened the screw holding the rubber track to the door. (6) I manually adjusted the rubber track around the window glass and pressed the electric window button up slowly, making sure the glass stayed on the track. (7) I put everything back in place, screwed in the screws, etc. Be careful not to let the window go all the way down, because it seems to fall off the track at that point. Hope this helps!

Posted on Nov 12, 2008

3 Suggested Answers

  • 708 Answers

SOURCE: 99 ford ranger, electric windows, glass off track

yes,

remove the door panel. typically it has to be pryed off. be careful when it pops off not to let it all to the ground because it will pull the wires out.
Once it is off there is a rail on both sides of the door. One of them has came loose. determine which one and put it back on the window and then make sure to tighten it back down. then put panel back togther. it will take about a half hour to an hour.

Posted on Oct 12, 2009

  • 161 Answers

SOURCE: Driver's side electric window off track.

from a common repair manual.

Posted on Jun 14, 2009

  • 1986 Answers

SOURCE: drivers door window motor and track broke how to

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics

Posted on Sep 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to I fix a window that won't stay on its track


remove the door panel and inside the door at the bottom of the track you will find a bolt that adjusts the window track position
put the window down as far as possible and adjust the track back tight against the glass and tension up the nut

Jun 23, 2015 | Cars & Trucks

1 Answer

Driver side window bracket


That is usually a big job. If you can get the door pad off maybe the front or rear track can be fixed. At leased the window can be put back temporarily. Most door pads have 2 or 3 screws. (look in holes). The electric switches should pop up and remove wire connectors. With a flat tool ,go around door pad edge and pop up clips. .Then lift pad up off top. Tricky Buisiness.

Jan 01, 2014 | 2002 Buick LeSabre

1 Answer

Service manual


If you can take off the inner door panel-not that hard to do-then you could see what caused it to be off track, and probably fix it. If the window regulator mechanism has to come out of door to fix it, a little more difficult but within the scope of experienced owners who do their own work. It will save you big repair bills.

Jul 27, 2013 | 2004 Honda Accord

1 Answer

The window on my 2007 impala came out the track, how do I fix it myself


Not off any track

People have been saying that for 50 years

Your window regulator or cable broke

Remove the door panel to see what the issues are

Jul 28, 2011 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

Drivers door window motor and track broke how to do it your self 97 ford thunder bird electric windows 6 cylinder show me how to fix it myself please thank you


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics

Sep 24, 2009 | 1997 Ford Thunderbird LX

1 Answer

Fallen driver's side window


probably need a new window regulator. ebay. 93 to 98 should fit.

Section 01-05: Trim, Interior 1998 Villager Workshop Manual
REMOVAL AND INSTALLATION Trim Panel(s), Door Front
Removal
  1. Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
  1. swv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
    Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942) .




  1. If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel .
  1. Pull the shop rag back and forth to release the window regulator handle clip.




  1. Remove the three cover caps and front door trim panel screws.
  1. Remove the one front door trim panel capped screws from the door pull handle.
  1. If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
  1. Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124) .
  1. Remove the front door trim panel.
Installation
To install, reverse the removal procedure.
---------------------------------------------------------
Window Regulator, Power Front Door
Removal
  1. Disconnect the battery ground cable (14301) .
  1. Remove the front door window glass (21410) . Refer to the front door window glass removal procedure in this section.
  1. Remove the two front door brace bolts and the front door brace.


    415712f.gif

  1. Disconnect the front window regulator electric drive electrical connector.
  1. Remove the four front door window glass regulator track bolts.

    67b6136.gif


  1. Remove the three front window regulator electric drive bolts.
  1. Remove the front door window glass regulator track and the front window regulator electric drive (23394) as an assembly through the opening in the front door (20124) .
Installation
  1. Install the front door window glass regulator track and the front window regulator electric drive as an assembly through the opening in the front door .
  1. Install the three front window regulator electric drive bolts. Tighten the front window regulator electric drive bolts securely.
  1. Install the four front door window glass regulator track bolts. Tighten the front door window glass regulator track bolts securely.

Apr 29, 2009 | 1998 Mercury Villager

1 Answer

Window jumped off window track


drivers window?
the best way to fix it is to replace the window run channel (rubber the glass slides in) and the regulator. or to get by if the regulator isnt bent take the door panel off, take the door glass out, the front of the run channel inside the door is bent foreward a little bend the metal track to the rear a little by hand, careful its weak, spray the run channel with silicone spray and reinstall the glass. if the run channel is torn it wont last.

Dec 18, 2008 | 2000 Honda Civic

1 Answer

Window is off track






1. remove door panel, door latch handle and window crank unless it is electric, then remove electric control panel , usually on top of arm rest.
2, Remove insulation sound barrier (plastic sheet)
3. Inspect window for damage. If none is found, notice where the window normally slides up and down in what is called tracks. There is felt material inside the tracks.
4. Also look to see if the window has dropped out of the two crossed arms that have white plastic rollers on them. Be careful handling these arms because they are very sharp.
5. Look for small tabs holding track to door. Usually top and bottom. Loosen these screws slightly until you can move them back widening the distance between both tracks so that you will be able to slide the window back into the tracks.
6.Once the window is back in track, move the loosened track back up so its just touching the window, then retighten the screws.
7. Test window operation.
8. If the window comes off tracks again, window regular is causing problem and should be replaced.


Hope this helps.


If you would like to correspond further with me on this or any other issue, please feel free to do so.
Bill
ASE Master Technician

Nov 26, 2008 | 1999 Chevrolet Malibu

1 Answer

1998 Jeep Cherokee window installation


If it slipped the track, something broke inside the door.
You have to take the door panel off and see what the problem is.

Oct 12, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
1992 Honda Accord Logo

1,333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...