Question about 1989 GMC S-15 Jimmy

1 Answer

Not starting. my turck is not starting at all..im not sure if its the timeing gears or not..i cant really check anything on it because i cant take it anywhere to get diagnostics done on it.any solutions let me know...

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 104 Answers

When did it last run?

Posted on Nov 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Performance problem brake light flashing


It sounds like the distributor is a notch off, or wiring is off.

Feb 05, 2013 | 1994 GMC Sierra

1 Answer

How do i figure out my problen


thats what it sounds like but the shaking may be one of your motor mounts check your o2 sensors too

Aug 13, 2012 | Jeep Cars & Trucks

2 Answers

2004 Voplvo C70 T5 would not start one afternoon about 6 PM clear day 75 degrees. Battery fine. turn over just would not start. Seemed like no fuel or spark to engine. Tried different times and finally...


Though that information is correct, that the computer may not give sufficient info back to use, the problem would have be "captured" live. Some times we have to rely on experience to guide us in the proper direction. What you described though sounds like there may have been a glitch with the alarm/security system and doubt you have anything to worry about but can understand how this would worry you. Keep an eye on it and if it does it again, get it towed to the nearest Volvo dealer immediately so they can capture any faults that may have arrisen. Let me know if you need anything else.

May 22, 2011 | 2004 Volvo C70

1 Answer

Hello, this mornign when i take the car i find out when i try to change the gear its comme really hard,,,,speacially in gear one and the backup one, i think its the clutch cable but im not sure,,,and im...


it might be adjustment on your cable or your clutch could be worn
all the other gears will be easy cause there synchromesh
should get you home use second gear starting off will go in easier
goodluck

Mar 02, 2011 | 2003 Kia Rio

1 Answer

When stopping in drive position the transmission grinds - shift to nuetral- OK. Shift to reverse it grinds. After couple minutes, in stops grinding. Any suggestions?


there are a few posibilities.I would start with the basic checks.start with the mounts and make sure that the motor or trany are not viberateing or rubbing on anything.If that checks good then check the fluid to see if it is burnt if the fluid is any color but pink to a redish then there is problems with the internals and you will need a knowlegable technitian take a look at your car.Im sorry I cant really be of anymore help without looking at the car

Feb 05, 2010 | 1999 Ford Explorer

1 Answer

Bronco 2. Grinds Gears, Hard to Shift


i had this same problem with mine and all i had to do to fix it was fill up the clutch fluid...i drove my turck like this for one year and the second i filled that up it worked like a dream. try it it might help.

Nov 19, 2009 | 1988 Ford Bronco II

1 Answer

My blazer is having tranny problems ,I think, Its not slipping or anything but its taking a little longer to get out of 1st gear.. people who ride with me cant notice anything but i can because ive been...


they could be related yes. The transmission fluid gets cooled by a cooler assembly that is located in the radiator. you can see the lines going into one side of the tank. If the fluid gets too hot it could brake down and become too thin which would allow it to not apply pressures enough to apply the gears in the valve body. I would fix the coolant leak flush the transmission fluid and see what happens..

PS flus the fluid by removing the line that flows fluid to the transmission cooler, start the engine and allow the transmission fluid pump to purge the fluid out of the system. once its done stop the engine and refil the system, repeat 2 times.
let me know if this helped the problem

Aug 26, 2009 | 1997 Chevrolet Blazer

1 Answer

Shift indicator on 2000 blazer is all wacked out


Check out Edmonds.com for Recalls, Service Bulletins ans Complaints. On this Year Model Blazer. You will be Shocked!!!! Luckily I found a Buyer for Ours before it got WORSE!

Jan 30, 2009 | 2000 Chevrolet Blazer

1 Answer

Transmission jerks


One possibility is that the speed sensor is going out. When that happens the computer gets bad information and thus makes bad decisions. When the car goes into 2nd all of the solenoids are actually off. That is so if there is some kind of problem the transmission gets no power, then it still has P, R, N, 2nd. It would be kind of weird, maybe, to see only the 1-2 shift being affected but I can't really think of anything else that could cause that kind of problem.

Jan 10, 2009 | 2001 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...