Question about 2005 Chevrolet Cobalt

1 Answer

Oil filter location

2005 Chevrolet Cobalt
w/ 2.2L Eco-tech engine

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 112 Answers

It is an internal fiber filter. It is underneath a screw cap which is located on the drivers side top of the engine.

Posted on Nov 08, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

2005 cavilar I was told it has direct gear to gear timing is this true

is it a 2.2 L if it is you have a chain no gear to gear you can see it at autozone library

Jul 07, 2015 | 2005 Chevrolet Cavalier

1 Answer

05 cobalt manual oil pumped clogged up, engine almost ran dry. replaced oil and filter and few days later engine started pinging. kinda moderate when idling then very rapid while driving. Wanna do the

pinging is from spontaneous combustion ( detonation) and is from incorrect air /fuel ration and ignition timing. Run fault codes and check knock sensor and MAF/MAP/VAF sensors . Left un- checked it will melt holes in the pistons.

Feb 19, 2014 | 2005 Chevrolet Cobalt LT

1 Answer

For 2005 Chevrolet cobalt, where is the oil pressure switch located

Should be below and to the right of the oil filter, behind a metal tube.

Feb 18, 2013 | 2005 Chevrolet Cobalt

1 Answer

Problem with power steering sometimes it works sometimes it don't

I had a similar problem with my 2005 Cobalt LT. Mine was as simple as checking the engine oil level. When the engine oil gets too low it will make the car do all kinds of weird stuff.

Nov 09, 2012 | 2005 Chevrolet Cobalt

1 Answer

Where is the oil pump located on a 2005 cobalt?

under the car on the bottom of the engine.

Apr 01, 2012 | 2005 Chevrolet Cobalt

1 Answer

Where on a 2005 colbalt supercharged engine is the oil filter


Feb 22, 2010 | 2005 Chevrolet Cobalt

1 Answer

Oil filter change Cobalt 2008 Chevrolet

the oil filter is located at the upper side , front of the motor it s a cartridge filter no like regular filters, , you will see a plastic black cap under the intake manifold, will need a gid range

Sep 03, 2009 | 2008 Chevrolet Cobalt

1 Answer

2005 pontiac sunbird oil filter location

Your looking for the location of your oil filter on your 2005 Pontiac Sunfire. They use a fabric/paper file which is located on the top/front of your engine. If your vehicle has an Ecotec engine, then open your hood. stand directly in the center of your car looking toward the windshield. And when you look down, it's at the front of the engine over to the right a bit. You need a certain tool, or Vice grips to turn the large plastic shaped cover off (Counter clockwise to losen). When it is loose, and you take off the cap. the oil filter will come out with it, you pull it off, and replace it with a new one.

Apr 18, 2009 | 2007 Chevrolet Cobalt Coupe

1 Answer

Trying to locate the oil filter on a 2006 cobalt with a 2.2 engine.

the oil filter is a cartridge style it is located on the front top of the engine driver side behind the radiator i believe it is an 1 1/4" socket (plastic lid be careful) spin this off and the filter is inside

Dec 26, 2008 | 2006 Chevrolet Cobalt

2 Answers

Chevy colbalt

The oil filter is not located on the bottom of the car in the Eco-tec engines like you may be used to seeing. It is actually in the upper area of the engine.

Open the hood and it will be slightly to the driver side of the intake manifold. (Black plastic looking set of tubes that go into top of engine). It will be an aluminum cylinder with a black plastic cap that has a molded "nut" on the top for removal of the cap. Just unscrew the cap. The filter will be clipped into the cap. Just pull it off and push new filter onto the cap and screw back into housing.

Aug 15, 2008 | 2006 Chevrolet Cobalt

Not finding what you are looking for?
2005 Chevrolet Cobalt Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides