- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It sounds like your clock spring, as we call it, has failed under the steering wheel. To remove the assembly you must first disconnect the negative battery cable to avoid deploying the air bag. There are 2 to 4 screws on the back of the steering wheel holding the horn pad onto the wheel. Remove those screws and carefully lift the horn pad off and disconnect the wire plugs. The horn wire is usually red and the air bag usually yellow. You will need a cheap steering wheel puller from the local auto zone to remove the steering wheel. They have a small round disc type that is easy to use and cheap. Now remove the large nut from the center of the steering shaft. Install the tool and remove the wheel. Now you will see a large round disc or air bag ribbon held on by a clip. use an pick tool and a small screw driver to remove this clip. Now trace the wires under the column and unplug the other end and you can remove the ribbon or clock spring. Now feed in the wiring for the new ribbon and reverse the process to reassemble. While you have the horn pad off test the horn switch to see if the horn pad is bad and may need replaced also. If the switch is good find the horn relay in the fuse box under the hood and see if when you press the horn does it get power from the switch. to test the horn itself apply 12volts to the two connectors on the horn and if it sounds it is OK. The system is made up of horn, horn relay, and horn switch. Thanks for looking for a solution at Fixya.com.
At first guess I'd say you have a bad "clock spring", it's inside the steering column and it feeds the electrical signals up to the controls in the steering wheel. Your air bags won't work, your horn, or your cruise control. Anything that's in the steering wheel. It will have to be replaced. You can check with Dodge but I think there was a recall on them but I also think there is a time and mileage contraint.
You need a new clockspring. It is behind the steering wheel, at the top of the steering column. It has wires wound around it like a clock. You will need to disconnect the battery, remove the air bag, then the steering wheel, and the steering column trim. Unbolt it, and install in reverse order.
it is the clockspring it is nothing to worry about i would get some cat 5 wire coil it up and wire it in there because the clockspring is very expensive part in have replace them using cat 5 wire and never had any problem after
There is something called a clock spring in the column that is used for the airbag, horn and cruise control buttons. This clock spring if messed with will cause a/bag light to come on and possibly cause a/bag failure if there is a collision. DON"T mess with the wiring in the column. Run new wires in to the horn or install an a/market horn.