Question about 1996 Chevrolet Cavalier

1 Answer

One cable is not sparking contniuously

I haave chnaged the plug also .the wire which u put in to plug i chaeked this wire its not firing continiuosly

Posted by on

  • mkhijazi Nov 08, 2008

    i haave chnaged the plug also .the wire which u put in to plug i chaeked this wire its not firing continiuosly

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Autozone auto parts will scan your computer for free...start there...then do a major tuneup...plugs, dist cap and rotor, wires, pcv valve, Ox [O2] sensor in exhaust every 60,000 miles...GAS FILTER!!! soooo important with fuel injected autos...every 12,000 or 15,000 miles. If gas filter is not changed the fuel pump has to work sooo much harder!!! Then it dies... start me up!!!

Posted on Nov 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What happen if wrong matching spurk flug cable


If you put the wrong wire on a spark plug, the engine will not start, or if it does, will run very rough. It is ******* the engine. Get the correct firing sequence from a mechanic or a website and get the wires on the correct spark plugs.

If you are talking about the wrong cable type, I am not sure.

Nov 09, 2012 | Cars & Trucks

1 Answer

Vauxhall engine


The ignition system is responsible for the starting engine:
the primary circuite is battery, ignition switch, ignition contact, condenser, ballast resistor. The secondary circuite. provide high tension to fire the spark plugs, add ignitioncoil, distributor, cap, rotoretc, high tension wiring, spark plugs. Test the mayor problem: 1) contact points and 2) coil.IF the ignition system do not provde the 20,000 or 30,000 volts, for spark plugs, will not work.

Easy test carefully:use screwdriver with the spark plug cables put around about 1/4 of inch againt the chassis give ignition, and some spark is coming, test by each spark plug cables, IF do not the coil can be faulty.

God bless you

May 09, 2012 | Vauxhall Cars & Trucks

1 Answer

Spark plugs and wires


It sounds like the spark plug wires are not plugged into the correct place on the distrubutor. take the distributor cap off and crank the engine over. Make a note of which direction the rotor spins. (Clockwise, or Counterclockwise) then find the firing order for that engine. Sometimes the firing order is on the intake manifold. (if you tell me which engine it has, the 4 cylinder 2.0, or the 6 cylinder 2.5; I could post you the firing order). Now on the distributor cap there is one wire post that has the #1 on it, that would be where you put the spark plug wire from cylinder 1. Following the rotation of the distributor rotor, you would put the spark plug wire for the next cylinder in the firing order after the #1 wire, and so on.

Dec 11, 2011 | 1998 Ford Contour

1 Answer

On my 92 Saturn SL2 do I haave to remove the cover to repalce spark plugs?


no, the plug wires snap onto the plugs which are in deep recesses in the valve cover on the DOHC, which is the SL2. On this old car you may just want to replace the plug wires at the same time unless you are sure they are less than 5 years old. get some good wires, not generics, that are made for the car.

Jan 03, 2011 | 1992 Saturn SL2

1 Answer

Number one cyl on coil pack not firing, all others are, codes reads misfire on 1 cyl should i replace the coil pack and how do you test the pack


Check the spark plug first. then if the plug is good you wil need a digital ohm meter to test the coil pack. if you need to know how to remove the coil pack let me know, to test put on ohms should not have more than 2 1/2 ohms restance betweent coil lead to coil connector. If you test the coil pack on both sides of the pack and get a reading then the coil is bad, if it does not read then you haave a bad fireing plate diode.

Mar 12, 2010 | Ford Explorer Cars & Trucks

2 Answers

Missfire # 5 cyl before and after plugs and wires ?I changed some vacume hoses still same what to ck nexed


i had that happen plenty of times. be sure that the new plug isnt bad and ohm test or see if you haave spark on the new wire. good luck

Jan 07, 2010 | 2001 Ford Explorer Sport

1 Answer

I need the diagram to put the spark plug cables


2003 Chevrolet Malibu 3.1L SFI OHV 6cyl
Spark Plug Wires - Removal & Installation

3.5L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.
  2. Remove the intake manifold cover, if required.
  3. Disconnect the left side spark plug wires from the spark plugs.
  4. Disconnect the left side spark plug wires from the ignition coil.
  5. Remove the spark plug wire clips from the Manifold Absolute Pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
  6. Remove the spark plug wire assembly.
  7. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.
  8. Disconnect the right side spark plug wires from the spark plugs.
  9. Disconnect the right side spark plugs from the ignition coils.
  10. Remove the spark plug wire assembly.
  11. If replacing only one plug wire, open the retaining clip and remove the appropriate spark plug wire.
To install:
  1. Install the spark plug wire assembly.
  2. Connect the right side spark plugs to the ignition coils.
  3. Connect the right side spark plug wires to the spark plugs.
  4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
  5. Install the spark plug wire assembly.
  6. Connect the left side spark plug wires to the spark plugs.
  7. Connect the left side spark plug wires to the ignition coil.
  8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
  9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
  10. Install the intake manifold cover, if required.

Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system
74d742b.jpg


Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
306b531.jpg


Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
9313fa7.jpg


Fig. 2.4L Engine Firing order: 1-3-4-2 Distributorless ignition system
2c9af72.jpg


Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system
d929c16.jpg


Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system
f357cd3.jpg

Fig. 3.5L & 3.9L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system
09e9db9.jpg

I really hope help you with this (remember rated this help) Good luck.

Sep 23, 2009 | 2003 Chevrolet Malibu

1 Answer

Put new front head casket & spark plugs & wires runs like ****


Are you sure you have plug wires on correctly? Better double check them.

Sep 11, 2009 | 1993 Dodge Caravan

2 Answers

One plug is not working


normally whe nthe car is running the engine is hot, if it is very hot, it might be your thermostat, the radiotr and or the lead may not be working, better off going to a mechanic not here

Nov 08, 2008 | 1996 Chevrolet Cavalier

Not finding what you are looking for?
1996 Chevrolet Cavalier Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...