Why the potential energy is unlimited?

Mechanical energy is just produced by the movement of objects according to the definition of it.
Force is the cause to change the movement of the objects by the first law of Newton. Therefore force is the real source of mechanical energy.
The force (outside force) is limited. However, gravity is a special force which is unlimited.

Posted by on

• 1 more comment
• 001zyl Nov 09, 2008

At present, the potential energy is generally
agreed that it comes from the movement of objects being taken from low to high.

But people have ignored that the kinetic
energy has already been consumed during the period of movement.

The movement of objects takes place depending
on the force acted on. Without force acting on the objects maintain static.
Even with equal forces from opposite directions act on each other, they can't
move as well. Gravity is just in this condition.

• 001zyl Nov 10, 2008

In a word, force is energy itself or a form of
expression of energy just like the electric energy, the heat energy and so on.

• 001zyl Nov 10, 2008

Referring to the Torricelli experiment, We put a
cylinder with water into a water basin ( set a splints in the upper part
of the cylinder, switched by lines), get a inflated balloon with a hollow
tail from the bottom of the cylinder, when the balloon floated up to top,
release the air by pulling the switch wire of the splints, then pulling the
deflated balloon out.  In
the course of the experiment, W1=G(water)h, W2=G(air)h,
W3=G(water)h=P(atmospheric pressure)V . We will get W1 from W2, and W3 from the
atmospheric pressure  will
compensate for W1.

×

• Level 1:

An expert who has achieved level 1.

Governor:

An expert whose answer got voted for 20 times.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

• Contributor

Potential energy is unlimited simply because it's not used yet.
Once you start using it, it eventually ends.

Posted on Dec 15, 2008

• Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

• Master

Its all about what"creates" the force and not the force itself.Force is a by product of an earlier process.Gravity is a good thing but its only free one way takes energy to get back up the hill.Very bazaar topic to post on fixya not sure what sort of answer your after but it was good to consider something outside left field.Good luck with your search for a global solution.

Posted on Nov 08, 2008

• tony yeatman Nov 09, 2008

**** vote? what sort of imbecile are you?Just a wally that likes to spout scientific dribble and has no concept of reality.You can use your gravity and ars fuc yourself

• tony yeatman Nov 10, 2008

Wow your a genius but inappropriate doesnt seem to be a word even you understand,comment 2 was inappropriate so now i deserve that vote.Is force naturaly occuring No it isnt,therefore another action/process comes into play.Gravity is only there due to planet rotation but how do you as smart as you are,harness it.Some thing makes force wether its asyou say electric,heat etc so that means another process comes first as i believe i said in the first comment i posted.Force is a by product of an earlier process and the ability to harness and use that force effectively is the key.In your own words force is an expression!What people ignore?The stupid ones?You will not find the key to perpetual motion either but you sound like a first year science grad with dreams and hopes outside the box so keep studying and dreaming and you may one day contribute your own theories and ideas.

×

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
Good luck!

Posted on Jan 02, 2017

×

my-video-file.mp4

×

Related Questions:

The definition for mechanical energy

Energy associated with the position and motion of an object.

Sep 02, 2014 | Cars & Trucks

What is solenoid

A solenoid is an electro mechanical device, converts electrical energy into movement, by the use of magnetism to move sliding cores. On vehicles they are used on starter motors, central locking, and electric heater controls

Dec 30, 2013 | 2001 Ford Mustang V6

What is solenoid?

A solenoid is an electro mechanical device, converts electrical energy into movement, by the use of magnetism to move sliding cores. On vehicles they are used on starter motors, central locking, and electric heater controls

Dec 30, 2013 | 2001 Ford Mustang

How maximum increase horse power output force of inductiom motor of 2hp using loadwheel or flywheel and how much hp force it can be increase. Plz describe detail.

induction motors develop max hp at the set RPM and current setting according to the windings in the motor. The use of flywheels in the system help the motor to hold steady rpm when a sudden load is applied as the stored energy in the spinning flywheel overcomes the sudden draw of power and stops the loss of rpm's . If you want more HP get a bigger motor.. ( HP is now an irrelevant term as it not an accurate to describe the motor's capacity . The definition is now torque or the ability to turn a shaft That is why older motors were bigger and used more current than the smaller motors that produce more torque for less current

Nov 22, 2013 | Cars & Trucks

My ford ranger can not run a speed more 60km per hour, the thacometer is up to 2000 only, why?

Jan 12, 2011 | Ford Ranger Cars & Trucks

THE POWER SEATS SHIFT ABOUT 1/2 INCH WHEN I ACCELERATE OR BRAKE

First, check with the vehicle manufacturer's website (or call them) for information about any potential recall. If it is a recall issue then you should obtain instructions directly from the vehicle manufacturer on what to do. Otherwise, check where the seats bolt to the frame of the vehicle(s) to ensure that the seats are not allowed to rock/shift by attempting to push/pull/rock the seats with a little force. Otherwise, there could be an issue with one or more of the mechanical components which adjust the seats.

Jan 07, 2011 | Chevrolet Silverado 1500 Cars & Trucks

How to unlock rear restraint from top or rear seat it will only release about 6 inches then locks up

It sounds like the mechanical part inside that seat belt mechanism is bad. If something hasn't fallen into it to cause this problem, you will probably have to replace the seatbelt. They are preset from the factory and should not be messed with. They are designed to lock up when the belt gets pulled fast. It uses a centrifical force type mechanism internally. You might see if there is a recall on it. Do check to see if any foreign objects have gotten inside of it. You will probably have to remove the whole unit from where it's mounted to be able to remove the covers and check for foreign objects. Good luck.

Jan 02, 2011 | 1999 Ford Contour

What is the tourqe? vaccum leak at intake

Torque, also called moment or moment of force is the tendency of aforce to rotate an object about an axis,[1] fulcrum, or pivot. Just as a force is a push or a pull, a torque can be thought of as a twist.

Loosely speaking, torque is a measure of the turning force on an object such as a bolt or a flywheel. For example, pushing or pulling the handle of a wrench connected to a nut or bolt produces a torque (turning force) that loosens or tightens the nut or bolt.

Vacuum leaks in manifold means u got a broken VACUUM hose that helps your HYDRAVAC to boost ur BRAKiNG power! Just look at ur BRAKE MASTER and u will see at the rear, there is this BiG ROUND drum, hose/pipe is attached to it, follow that hose/pipe it will lead u to the iNTAKE MANiFOLD, where air/fuel was being sucked by the ENGINE PiSTON!

Nov 09, 2010 | 2001 Jaguar S-Type

Timing belt on Accord 2004 v6 models

2003 and up Honda Accord with 4 cylinder engines do indeed have a chain and the V6 has a belt which must be replaced at 110,000 miles. Why? Ask Honda, they designed the engines.

Apr 08, 2009 | 2004 Honda Accord

Clutch kit

Revise driving habits if no mechanical faults can be found in old parts

Jul 31, 2008 | 2007 Honda Accord Sedan

Open Questions:

Related Topics:

179 people viewed this question

Level 3 Expert

Level 3 Expert