Question about 1997 Toyota Camry

2 Answers

Got spark from coil got fuel will not start - 1997 Toyota Camry

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Guys
my camry 1997 is not starting, i thought batter was down or else Alternative might have gone. but with booster cable also it is not starting, that means it has someother problem. anyone knows about it?

Posted on May 12, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 37 Answers

Chech to see if you have compression. Then check to see if you have to correct amount of fuel pressure. Also chech to see if you have spark from all the cylinders.

Posted on Nov 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My car can cranking but wont start,i have been replace fuel pump,spark plugs and crank angle sensor but still same problem.i need help please.Thanks.


Did you check the ignition coil for spark? Also, U might want to try replacing the coil since a weak spark will not jump the gap within the confines of a pressurized cylinder.

Sep 11, 2016 | 2004 Mercedes-Benz C 180

2 Answers

Replaced bad coil van cranks but wont start?


Sure the new coil is working? Did you check for spark?Is the fuel pump working? Fuel injectors? ECM?

Feb 21, 2016 | 2005 Chrysler Town & Country

2 Answers

98 ford explorer replaced egnition. Now it wont start. Starting fluid does turn it over. But isn't getting feul


out of fueL, bad fuel , old fuel>?

replace what exactly , ignition parts t are many.
key switch.?
Igniton coil(or coils, or cops or coil packs)
Distributor.
spark wire, (not replaced 1 by 1 = fail..)
ok , the PCM monitors spark and that fails, (even if spark is good)
it will cut fuel. so what did you touch>?

i use a noid light, if pass I check fuel pressure
if noid fails, i find out why PCM is cutting fuel.
check fuses 1st. always. for ever. and ever

Jul 05, 2014 | Cars & Trucks

1 Answer

The 1992 Caprice I'm working on has no Spark to the Coil I've changed the coil and the electronic spark control module. What else besides the Fuel pump or something else could cause the problem of no start...


You say no spark to the coil. does that mean that you have checked the power to the coil & getting none or are you getting no spark from the coil to the distributer cap? If you have no spark that is most likely the problem of not starting but you can always just check your fuel pressure to see.

Jan 26, 2011 | Chevrolet Caprice Classic Cars & Trucks

1 Answer

Crank, won't start problem. I checked the spark plugs on Jeep 98. Looks good. Could it be the crank sensor or starter coil?


Yes it is very much possible.But there are many other possibilities too,including starter and spark plugs issue.

If your engine cranks normally but will not start because it has no spark, or it stalls and won't restart because it has no spark.

You can also do a test to confirm the problem .The procedure to do the test is as follows:---

If your engine has spark plug wires, disconnect one of the plug wires from a spark plug and place the end of the wire near a metal surface on the engine. Then insert a small Phillips screwdriver into the end of the wire (the plug boot), or a small bolt or nail to provide a conductive path. Then crank the engine and look for a spark to jump from the screwdriver, bolt or nail in the end of the plug wire to the engine. If you do not see a spark, there is an ignition problem.

OR-----------

If your engine has a coil-on-plug ignition system with no plug wires, In that case remove one of the coils from the spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil. Ground the spark plug or plug tester to the engine, then crank the engine and look for a spark. No spark indicates an ignition problem.If the engine has no spark, check for voltage at the coil positive terminal when the ignition key is on. If NO voltage, then problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit).

But If there is NO voltage at the coil itself, then in that case the problem is on the supply side (the ignition switch or ignition wiring circuit).-----------------

Jeep cranks but no start:----------------

A jeep that cranks over but doesn't start, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also these problems are related to faulty spark plug. Check the spark at spark plugs when you start the jeep. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt. If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced. If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the jeep. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the jeep. If its very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the jeep. If the car starts momentarily, then there's a good chance the fuel pump is not working or the jeep is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gauge and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem. Thanks. Helpmech.

Jan 07, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

My 1994 oldsmobile 98 regency won't start


Check fuel pressure,spark.If no spark possible crank sensor or ignition module.If no fuel pressure tap the bottom of the fuel tank with a mallet while someone is cranking the vehicle if it starts then you will need a fuel pump.Also if you have spark and fuel but the engine feels like it bucking while turning over,take a hair dryer and heat the coils up.you may have a bad coil pack.After they get warmed it night then start as the coil resistance changes.

Dec 02, 2010 | 1994 Oldsmobile Ninety Eight Regency

1 Answer

Wont start


is the your car engine cranking when you try to start, first check spark plugs ignition coils, remove one ignition coil and spark plug fix the spark plug in to the ignition coil then connect ignition coil to wiring and keep spark plug body touching on ground of engine head mettle parts, ask some one to crank engine then you can see is the plug sparking or not, do the same way to all the coils and plug otherwise you have to buy a ignition spark tester, is the all the coils and spark plugs are OK then check the fuel pump, it's sitting in under rear seat, before that do one thing disconnect oxygen (O2) sensor wiring and crank engine, the thing is if your oxygen sensor completely dead fuel pump will stop working, if engine start after disconnect O2 sensor, replace new O2 sensor, otherwise need to check fuel pump relay fuse and fuel pump. is this information helped you? please vote me and give a comment.

Oct 15, 2010 | 1998 BMW M3

1 Answer

99 tracker 1.6 wont start has fuel,no spark coils


Sounds like a bad ECU module it controls fuel injection and spark.

Aug 08, 2009 | 1993 Geo Tracker

1 Answer

Vihicle died won't start


My 92 Subaru would not start. New rotor, cap, replaced fuel filter. No gas getting to filter. When gas trickled in carb, runs like a top. I think the fuel pump out.

Dec 19, 2008 | 1991 Subaru Loyale

Not finding what you are looking for?
1997 Toyota Camry Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...