Question about Hyundai Elantra

2 Answers

My buddy has a 2000 Hyundai Elantra that has a bad drivability issue...I am a master ASE tech but have run out of ideas. The car has a p0300,302,303 codes in the PCM. the plugs and wires are new. The car will not miss if you just feather the gas pedal, but if you try and normally accelerate or hard accelerate the car has no power and the check engine light flashes (indicating a misfire condition)...if while the car is misfiring you go back to just barely touching the gas pedal the car will accelerate fine..also the primary o2 sensor is new...any further ideas?

Posted by on

  • JoeKay May 11, 2010

    Yachtdoctor - how did you make out with the solution? I have the same problem, except no codes at all. I replaced the TPS, and also the fuel pump regulator located at the end of the fuel rail. It improved things to where the gas can be feathered with no missing. As soon as you try reasonable demand acceleration, the misfire returns until around 2000 rpm, at which it disappears again. Fuel pump pressure was checked, and it was fine. Any other ideas out there?

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 298 Answers

Have you checked the MAF and/or TPS sensor?. I have had the same issue before on the same kind of car and it turned out to be the MAF sensor.

Posted on Nov 07, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

If the car has a distributor pickup or ignition module which steps up the voltage under heavy acceleration that may be bad.gnition

Posted on May 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where can I download the owners manual for a 2000 Hyundai Elantra for free?


buddy, if you work on it yourself, its worth the money to buy from manufacturer-- also, join a hyundi forum and they can give you gold in advice- helps me fix my SSEi.....happy trails

Apr 28, 2014 | 2000 Hyundai Elantra

2 Answers

What wire is the exciter wire for the alternator on a 03 hyundai elantra


https://www.hyundaitechinfo.com/index.asp
Make a free account and you can research everything about that car. It takes some getting used to using that site.

Jan 25, 2013 | Hyundai Motor 2003 Elantra

1 Answer

Back windows wont roll down


i first check to see if you have a master power control switch at the driver side switches. If so, is it set to block? Also try pressing on and off a few times( maybe bad /corroded contacts inside the switch} . try the switch at each window{replace as necessary} there will be CIRCUIT BREAKERS not fuses you can check, also maybe window relays ,BURNT wiring, bad main switch,{master window} the last thing i would check is the motors themselves,doubt they would both be burned out!!! DAN F A.S.E. CERTIFIED TECH

Aug 19, 2012 | 2000 Hyundai Elantra

1 Answer

2004 elantra gt stalls and then restarts but will stall again


its the cam shaft or drive shaft sensor. since your probably trying to restart it over and over again you are resetting the computer so you get no codes. have a 2000 and it did the same thing tell i gave up trying to start it and took it towed it to my house and had it tested.

Apr 03, 2012 | 2000 Hyundai Elantra

1 Answer

2000 Hyundai Elantra starts only sometimes.


Here is a view of where the fuel pump is located (in the gas tank) and what all the components look like. Good luck.
Greg
http://www.chiltonlibrary.com/content/images/7923/images/7923gg86.gif

May 29, 2009 | 2000 Hyundai Elantra

1 Answer

2008 Hyundai Elantra


time for you to replace the remote control. common problem.

jj hyundai master tech boston ma.

Feb 15, 2009 | 2008 Hyundai Elantra

1 Answer

Fuse for cig lighter


In your cars manual you will see a page, or a map of your fuse locations and there numbers.

Jan 15, 2009 | 2000 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

603 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...