Question about 2001 Acura 3.2CL

1 Answer

Rear Bumper Does anyone know how to take off the rear bumper any advice would help. dont feel like taking it to get it fixed would cost 900 so i am doing it myself

Posted by on

  • ace13928 Nov 07, 2008

    ^^^^^^ look above

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 229 Answers

It is pretty simple once you get started. First you will have to remove the beauty cover in most cases. The plastic cover that conceals the true bumper on most modern vehicles. Get under the rear bumper,if you jack the car up always be sure to use jack stands for safety reasons. There are clips that you can unfasten usually using a flat head screwdriver. Remove these gently and save them. They can be damaged very easily and can be expensive. Sometimes these can also be held on with aluminum screws and with plastic phillips head screws. After the cover is off you will see the bumper itself and by getting under the bumper you will see where it is attached to the frame. Unbolt the bumper from one side to the other and save all parts. Also some vehicles have light fixtures in the bumper - you will need to disconnect these as well and save every part. If it gets complicated make some type of system to keep organized. There is nothing worse than having parts left over! When you get to the last few bolts the bumper will start to hang and I recommend you have someone help hold it up until all bolts are removed. You don't want it to fall on you of course. After it is removed get your replacement ready to install and just do everything in reverse. Be careful in the last steps with any clips you use because this will make the difference between a "professional look" and just so-so. Make sure you have all tools handy - have plenty of room and plenty of time to do the job - take your time and you should be successful and save a ton of money. Good Luck!!!

Posted on Nov 07, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How does the back bumper of the Ford Excursion attach?


The process is like the Super Duty trucks, so watch the video at the link. How to Fix F250 Super Duty Rear Bumper

Sep 06, 2016 | 2000 Ford Excursion

1 Answer

The rear bumper cover came off how can I reinstall it


2000 Toyota Sienna rear Bumper cover replacement (1998 ...

? 3:40
https://www.youtube.com/watch?v=AY1BBdg3q74
Sep 20, 2013 - Uploaded by SergSpace
2000 Toyota Sienna rear Bumper cover replacement (1998-2003) .... Automotive Bumper Repair Specialist- How to repairyour plastic bumper cover ... Toyota Sienna Rear Shock Installation 2003, 2004, 2005, 2006 - Duration: ... 2015 Toyota Sienna XLE - Duration: 28:13. by MikesCarInfo 35,234 views.

Fixing My Mom's Prius: Loose Rear Bumper Cover - YouTube




Nov 29, 2015 | 2005 Toyota Sienna LE

2 Answers

How do I remove the back bumper from a 2006 hyundai tuscon?


take help of the following steps to remove rear bumper on ur tucson.

Open the trunk of your vehicle.
  1. Unscrew all the screws on the inside plastic trim that covers your bumper to trunk connection.
  2. Pry the plastic piece out with a flathead screwdriver. You will expose the bolts that attach the rear bumper to the trunk.
  3. Unscrew the bolts connecting to the inside of your rear bumper. There should be four bolts.
  4. Unscrew the two to four screws connecting to your bumper from the inside of the rear wheel tire wells. These screws are on the area of the tire well that is closet to the bumper.
  5. Slide under the rear of your car. Use a flathead screwdriver to pop the plastic rivets out of place along the underside of the rear bumper. There should be four to six rivets.

  6. Squat behind your car and firmly pull the bumper off. There will popping plastic sounds, this is the pop-in-place plastic rivets that are the last pieces that hold your rear bumper in place.

Dec 27, 2010 | 2005 Hyundai Tucson

2 Answers

Need step by step instructions on how to remove a rear bumper cover on a 2007 nissan altima


Rear Bumper: Service and Repair
REAR BUMPER
Removal and Installation
REMOVAL
1. Remove the LH and RH rear combination lamps.
2. Remove both the rear wheels and tires.
3. Remove the LH and RH splash shields.
4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.
5. Remove the rear energy absorbing foam.
6. Remove the rear bumper reinforcement.
7. Remove the rear bumper supports.
INSTALLATION
Installation is in the reverse order of removal.

c674cde.jpg

Nov 12, 2009 | 2007 Nissan Altima 3.5 Sedan

1 Answer

S Type Jaguar rear bumper removal


how do you remove a front bumper off of an jaguar s type?

Mar 09, 2009 | 2004 Jaguar S Type

1 Answer

Cost to fix scratch


take some tooth paste and rub the scratch , many time this will repair if it's not too deep .

Feb 12, 2009 | 2004 Ford Explorer

2 Answers

2000 Pontiac Sunfire GT needs new rear bumper cover


Depends on whether it is broken cracked or just scuffed. Repaint of the scuffed cover between $200 and $300. If cracked or broken a good used bumper is about $150 buy you usually have to paint and install. The total cost could add up to $500.00
If you are lucky to find a good one you do not need to paint in your color it is about 1 hour labor to replace.

Dec 17, 2008 | 2000 Pontiac Sunfire

1 Answer

Rear bumper replacement


there will be some screws and plastic clips around the trunk and rear quarters remove these. look at yours should still see the screws to give you an idea

Nov 06, 2008 | 1994 Geo Prizm

2 Answers

Corolla 2003 rear bumper


Pop the trunk and remove the screws or clips thats connecting the bumper there, and then do the same thing in the wheel wheel and under the bumper along the lip and it should come right off. There might be some under the tail lights so you might have to take out the tail lights.

Jun 23, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
2001 Acura 3.2CL Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...