My esp light,abs light and anti slippery light in my jeep compass 2007 comes on and stays on , what does this means???

you did it wrong for sure, as we all do time to time.
open glove box remove operators guide it tells you what to do.
so car drives perfectly , no told brake tool
only lamps scare you?
dash is lit up ABS and esp 4wl drive is on. <<<, what does this mean, key, only or running the engine

TPMS well fails at 5 year old batters, most cars seen on the road it is ignored. do it manual be safe

the manual covers the oil change NAG , just read it do it
google 2008 Jeep Compass. users guide it it read it use it and keep it. by law here free.

ABS and esp 4wl drive

I have no idea at all why you posted this line, (what is the key doing now)??????????

for sure do not engage 4wd LOCK , on dry pavement ever. do NOT
or ABS and you both will be SUPER UNHaPPY.
tell the kids to not touch 4wd levers or buttons for sure LOCK

Abs light comes on when a fault with the braking system is sensed usually a wheel speed sensor or sensors one to each wheel ESP uses the same sensors for traction control so start with the wheel sensors but get the codes read to find out which sensors are throwing faults could also be the connections or wiring to the sensors

1. check fuses 1st.
2. scan it next !

do tell DTC errors, do not skip this step or its impossible......
if the ABS is not showing abs parts bad, then the brakes are bad.

Have you put it on the computer? If so what code has it given you

the operators guide shows what these mean and what to do.
lost that>? i have one, and 08 JK.
pages 105 to 116
it resets each drive. the opr guide says that, and does.
its a very complex system, you should RTM.

ill quote your missing pages.
ABS:
If the light remains on after start-up or comes on and
stays on at road speeds, it may indicate that the ABS has
detected a malfunction or has become inoperative. The
system reverts to standard non-anti-lock brakes.
ESP:/TCS
The ESP/TCS Indicator Light (located in the instrument
cluster), starts to flash as soon as the tires lose traction
and the ESP system becomes active. The ESP/TCS Indicator
Light also flashes when TCS is active. If the
ESP/TCS Indicator Light begins to flash during acceleration,
ease up on the accelerator and apply as little throttle
as possible. Be sure to adapt your speed and driving to
the prevailing road conditions

is this clear? if not ask more, questions , more specific and we can peel the onion deep as you want.
also wiki this topic, to understand it ...

location not stated, or road conditions. nor if in 4low , nor if the ESP switch is off or on. Ask Suzuki for help (lol) or any ASE shop.

it's not magic, it can not give traction , if none.
on ice slow down. (esp can do that too. slow you,brake you and even
shift gears in the transmission)

are you in 4wd? or high 4Low, esp is inactive. (or limited)
read the operators guide. (if lost, get one now)
read the page on driving on ice.
chapters 5,6,7.
have you had any off these conditions , related to ESP, this a
is the ESP light acting wrong, or CEL check engine light running?
are all dash lamps (warning) showing correctly per the opr. guide?
ESP & ABS are vary complex, (not magic)


quote from the servise manual. (car battery dead or disconnected?)
ESP control module
When ESP control module is removed / installed, do
not use impact wrenches which generate shock or
impact to avoid damaging sensors in ESP control
module.
Note that Calibrate word here..!
When any of the following operation is done, calibrate
steering angle sensor, G sensor and master cylinder
pressure sensor (in ESP control module) referring to
"Sensor Calibration in Section 4F
- When battery or dome fuse is removed. (a low battery or weak)
- When steering angle sensor is replaced.
- When ESP control module is removed.
- When yaw rate / G sensor assembly is removed.


read this, it covers this system well,

http://www.wkjeeps.com/wk_esp.htm

read page 7-2 here (the do not drive words)
http://www.autodealertools.com/quickQuote/manuals/2007/Grand%20Vitara.pdf

this car has no center differential. (read limits there of)
are you using chains on the tires?
oper guide page 4-6 , read that yet?

If the vehicle speed is greater thanapproximately 30 km/h (19 mph), the ESP systems (other than ABS) will turn
on automatically and the light will go out.
• When the transfer switch (if equipped) is
turned to the "4L LOCK" position, the
ESP systems (other than ABS) will be canceled automatically. The light will come on and stay on.
• If the ESP systems operate continu-ously such as when driving on slippery roads, the traction control functions of the ESP systems may be canceled temporarily to avoid overheating the brake pads, and the light will come on. After a short period of time, the ESP.

(this latter cut out happens, with wild driving)

yes it should it works with the brakes transmission and so on you need to check the codes the suspension and traction control are not working properly

question is why you want to turn of a brake safety feature, if you are refering to a light on the dash it usually means this system has malfunctioned and will default to "normal" braking rather than anti lock, best to have a shop check it out reasonably soon, you are safer with ABS.

If the ESP light is on, the system is not functioning. have your dealer look at and replace your Brake Light Switch

The lights are being turned on by your BCM or Body Control Module. It's located under the driver's side knee bolster, but it will probably have to be taken to the Dealership to hook up their DRB III to ascertain as to why the BCM is turning on all of your lights.

"00 Buck"