Question about 2006 Fiat X1/9

1 Answer

Heaters Do you know where i would find the fuses fro my heaters and how would i know if they were blown. How much do they usually cost?>

Posted by on

  • 1 more comment 
  • marieclark Nov 06, 2008

    I have actually checked allot of my fuses on my drivers side by the steering wheel i replaced the one for my heaters. Is that the only one? I f theres no power for the heater motor what do i do? How much will it cost to get fixed?

  • marieclark Nov 06, 2008

    I dont have anything to check the power supply in booked in a garage tomorrow but just worried of the cost?

  • marieclark Nov 06, 2008

    Thank you



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 905 Answers

Do you have a meter to check for voltage?
the fuse might look funny like a component or a small capacitor , there could also be an inline fuse on the wires to the motor , but you will need to know if power is going to the motors power lines
does the heater have a power light on or something to indicate that power is present to the heater?

Posted on Nov 06, 2008

  • 4 more comments 
  • jason Nov 06, 2008

    to be able to find out if a fuse has gone , it will be an open on the diode check on the meter(DMM)

  • jason Nov 06, 2008

    fuses are cheap , like a buck or two

  • jason Nov 06, 2008

    there may be a relay switch not engaging and the cost of having that replaced depends on who you go to get it done , but also who will do a better job , like the dealer

    if it is just the relay then it shouldn't be to much for them just to replace the relay, but if there is a wire not connected(burnt apart)then it will be more ( just the relay /$60-$80 if there is another problem then it depends on what that is and how much the replacement part costs

  • jason Nov 06, 2008

    the relay is cheap and should just be plugged in somewhere in the fuse box in the car or under the hood

  • jason Nov 06, 2008

    or it may be behind the glove box( the relay)

  • jason Nov 06, 2008

    your very welcome!



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

1998 Cavalier--I have no brake lights flashers,radio, AC/heater,or head lights. There are dash lights and the car will crank but not turn over. No blown fuses, changed all the relay fuses.

Check the starter connections for a corroded/blown fusible link.Pull on the wires attached there and if one pulls apart easily,it's defective.

May 28, 2017 | 1998 Chevrolet Cavalier

2 Answers

No elctirc to replaced heater blower

blown fuse..burnt up resistor block..bad ground..

Dec 30, 2013 | Cars & Trucks

1 Answer

2003 s-10 4.3....truck was running fine, check engine came on, usually gas cap...after couple days of not going out i obd2 it. codes.135,141, 154 and 155 3 of where double. says check circuit fuse? any...

You're making the most common DIY mistake in thinking that whatever part is listed in the trouble code is what you need to replace. In your case the most important codes are:
P0135 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)
P0141 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2)

Oxygen sensors don't work well unless they're up to a certain temp. That's why they have heaters. So these codes are telling you there's a problem with the O2 sensor HEATER circuit. That could be a blown fuse or a problem with the wiring harness. Since the heaters aren't working, it makes perfect sense that you'd get the two other codes. Check the fuse for the O2 sensor heaters. Oxygen fuse in underhood fuse box (20A). If it's blown, replace it. If it blows again, you've got a short somewhere. Start by unhooking the all the O2 sensors. If the fuse doesn't blow, plug them in one at a time. Get it?

Aug 27, 2017 | 2003 Chevrolet S-10

1 Answer

2001 Subaru Outback both seat heaters do not work but the lights work on both switches. Can you suggest fix ?

The LEDs are probably only capable of lighting if the switch works and not that the heaters will function. Those are probably on a separate fuse which may have failed and are likely located on the left end of the instrument panel in the passenger compartment fuse panel. There is a layout diagram on the inside of the panel.
If you find a blown fuse, replace it; if it blows again, there is a fault either in the wiring of the heaters or in one of the heaters itself.

Dec 05, 2010 | Subaru Outback Cars & Trucks

1 Answer

Taurus X driver and driver rear seat heaters not working.

Usually there is a snap plug underneath the seat sometimes these get pulled apart by sweaty things under the seat. Also check the fuse and fuse map

Jul 08, 2017 | 2008 Ford Taurus X

2 Answers

Seat heaters and cabin fan both not working - all

there is a breaker and it is likely pooched or it is shorted
try replacing breaker buy it from dealer and ask them where to install it they will show you
total cost 10 bucks
failing that start looking at the wires and the master fuses under hood

Jan 10, 2010 | 2004 Subaru Outback

1 Answer

2005 Chevy Silverado O2 sensor

I 1st need to know the codes, the O2 heaters are fused, but without the codes don't know, check the fuse box for the O2 heater fuse, if it is not blown I will try to make out what is wrong from the codes

Oct 16, 2008 | 2005 Chevrolet Avalanche

3 Answers

Gmc Envoy 2004 Seat heaters

I have the same exact problem so i would be very thankful if any know the reason

Oct 06, 2008 | 2004 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fiat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers


Level 3 Expert

77202 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides