Had new fuel filter put in and new battery. Ran fine for a while but now (again) is turning over strong but will not fire to start. What could be wrong? I am a disabled woman and cannot afford to put it in a shop to have it totally checked out.
SOURCE: 1991 Buick Regal will not start
Chech to see if you're gettin a signal from the crankshaft position sensor located behind the crank pulley. If no signal, you have either a bad sensor or a bad crank pulley. There is a reluctor ring on the pulley that separates and goes bad. If you have a good square wave signal from the the crank sensor it's probably going to be the computer. I've replaced a lot of them. They do really wierd things when they start to go. Check all of your grounds first. Also, while the car is running, shake and pull on the wiring harnesses for the computer. I've seen on a few cars where a wire or 2 will go bad and cause and occational short.
SOURCE: 2003 Buick Regal Service Engine Soon light.
The error that I'm showing for error code P1133 is
P1133 Heated Oxygen Sensor (HO2S) insufficient switching bank 1 sensor 1(Rear Bank). I would suggest having both of your Oxygen Sensors replaced if you haven't already had that done. Hope this helps. Thanks for an honest rating and for using FixYa.
171 views
Usually answered in minutes!
It has a new fuel pump and fuel filter. The car will start fine for days then all of a sudden it will not start.
×