Question about 2007 Toyota Sequoia

1 Answer

20080 sequoia platinum edition with load leveling issue

Sorry to bother you again Toyota Ed but I want to clarify my problem. My new sequoia rides higher on the passengers side; 1/4 inch in the right front and 1/2 to 3/4 inch in the right rear. I do not engage any of the controls while moving, this suspension comes with toyota electronic modulated suspension. The service manager says this is normal for these systems. If I raise or lower the suspension, the right is always higher when parked in my garage. What should I do? Sometimes it is noticeable and bothersome, My wife keeps nagging. One Sunday morning went to the local dealership when closed, of course. Measure couple of land cruisers and platinum sequoias and couple were uneven while others seemed aligned. Thanks for your response. PS: Sweating in south texas.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

I think that you need a recalibration of the ride height sensors. Unfortunatly, this can only be done with a tool that the Toyota dealership has in the shop. I just did a Landcruiser with the same suspension, and it took me a while, could NOT get it right, I ended up having to replace one of the height sensors, but there were NO DTC codes in the suspension ECU. You either need a recalibration, or a sensor replacement, followed by a recalibration. I know this may not help you "do it yourself", but, this is what you need. A FixYa rating would be greatly appreciated. Hope I helped you out. Sorry about the sweating in TX. Nice here in PA.

Posted on Nov 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear speakers don't work after new head unit


There could be several reasons why the head unit for your car does not work. The most likely issue is that the head unit is not compatible with your stereo system. You can consult your vehicle owner's manual for speaker issues.---------------------------------------------------------------------------------------
Diagnostic VAG

Dec 17, 2012 | 2004 Toyota Sequoia

1 Answer

Key don;t work on my 2007 toyota sequoia driver side door


Check for some foreign body in the key hole. Kids have a fancy of pushing match sticks in car key holes.

Dec 13, 2012 | 2007 Toyota Sequoia

1 Answer

2001 Toyota Sequoia O2 sensor locations and fix


O2 sensor is mounted on exhaust system near engine before cat converter can't help with rest of question sorry

Jun 02, 2012 | 2001 Toyota Sequoia

2 Answers

At how many miles should my timing belt be changed on my 2004 sequoia?


HI- Most manufacturers reccomend replacement at 90k, 180k, etc. Variables include other parts that may need replacing during these belt changes. Water pumps and timing belts should be purchased from the DEALERSHIP, regardless of who does work. This is proper, normal cost of maintaining your sequoia. Complete inspections and labor should be completed by mechanic familiar w/Toyota vehicles. Parts may run 150-250$. Labor depends on who ya know.- Hope this helps- Thanks- ED

Feb 26, 2010 | 2004 Toyota Sequoia

1 Answer

Brakes issues even after I fixed it at the Toyota dealership. Rear windshield wiper, rear windshield heating and electrical issues- doesn't work (I have fixed it twice already since 2005), battery died...


Wow, that is a lot of problems to have with a vehicle that was problem 47,500 brand new (just guessing) Look up what qualifies in your state as far as the lemon law is concerned. I am sorry you have had so many issues with your vehicle.

Feb 17, 2010 | 2003 Toyota Sequoia

1 Answer

How to replace a rear door handle on a 2003 Toyota Sequoia


This is a very common problem with the Sequoias (along with broken inside door openers).

Go to www.tundrasolutions.com and find the Sequoia section. There are numerous threads about the steps needed to replace this handle. Some go into great detail about the steps needed and offer fixes to keep it from happening again.

This design obviously has flaws, and Toyota should have acted to fix these flaws much sooner.

Oct 10, 2009 | 2003 Toyota Sequoia

1 Answer

How to change plugs on 02 Toyota Sequoia


It would be to hard to tell and show you over the computer.
The best and easiest way for you is to buy a Chilton manual for your car at the autoparts store. The book runs about $20
This book is a do-it-yourself bible. It will show you everything you need to know on how to do maintenance and repair on your vehicle.

Apr 09, 2009 | 2003 Toyota Sequoia

1 Answer

Oil Pressure


Sure, Thanks Ed,

I just reported something that I knew, I will report the right solution to the user,

If you see that I write imprecisions feel free to post your comment in my solutions,

I will report your comment to the user.

Nov 24, 2008 | 2003 Toyota Sequoia

Not finding what you are looking for?
2007 Toyota Sequoia Logo

367 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...