Question about 1998 Volvo S70

1 Answer

Replace broken driver side turn signal lights - left fender

I ran into a deer on a blind curve of highway at 2:00 a.m. How do I take off the damaged lens on the front driver's side turn signal lights so I can install purchased replacement. It looks like I need to remove the headlights first? I cant seem to locate the back side of the said damaged turn signal light. Its enclosed inside the left front fender. Thanx! for your immediate assistance

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 60 Answers

Reach screwdriver down between headlight and marker to releace clip, pull forward.

Posted on Dec 03, 2008

  • josecabrera2 Feb 18, 2011

    Additional information to what "cargod78" wrote.
    With the hood up, between headlight assembly and turn signal assembly between headlight, with a screwdriver, push down the marker to release clip that locks the turn signal assembly, then pull forward the whole turn signal assembly.
    I hope it help.
    Thanks "cargod78" your information was very helpful to me. I successfully replace the right turn signal assembly of my 2000 S70 SE.


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My turn signal and flasher fuses blow when I turn the ignition on

you have obvious short in the wiring - check the bulbs first, then the wiring. it is rarity to exchange relay - if it was not physically damaged during accident.

Apr 12, 2015 | Cars & Trucks

1 Answer

How to change turn sign light

1Start your vehicle's engine. Turn the steering wheel the opposite direction of the bulb you need to change. If you need to change the left turn signal light bulb then you will turn the wheel as far as you can to the right. This moves the wheel out of the way so that you have access to the fender and the turn signal assembly.

2Get down by the front fender of your vehicle. Use a Philips screwdriver to remove the screws from the wheel well cover. Take off the wheel well cover and set it off to the side.

3Stick your hand into the wheel well and find the turn signal bulb. Turn it to the left and unscrew it from the turn signal assembly. Remove the bulb.

4Take your new turn signal light bulb and screw it into place using your hand. Replace the wheel well cover and use the Philips screwdriver to secure it in place. Repeat this process for the turn signal on the other side of the vehicle.

Read more: Chinasinoy

Aug 03, 2012 | 2010 Kia Optima

1 Answer

No low beam lights or DRL

the recall splice repair is where to start. the repair may be bad again. had a friend that had the same problem. told him to check the splice and try to get rid of the splice block. he did and the lights worked fine.

Jun 03, 2012 | 2006 Suzuki Forenza

1 Answer

2000 toyota corolla...the car was in a crash,damage to driver side front.I have replaced parts(fender,bumper ,etc)but now the park light or signal light will not work.when I turn the turn signal on for the...

you need to check the fuse for it. with no power going to it that is the most likely explanation. other than that, trace the wire from the light and be sure there is no breaks

Aug 26, 2010 | 2000 Toyota Corolla

1 Answer

Broken door windows - deer ran into side of car

You can get used door glass from an auto salvage yard, for not too much cash. They aren't hard to install, and your doors are already painted and match the car.

Nov 18, 2009 | 1999 Ford Contour

1 Answer

Turn Signal light not working after collison with deer.

run a new ground to this light and see if it works!!

Jun 11, 2009 | 1997 Chevrolet Lumina

1 Answer

Left fender turning signal


May 03, 2009 | 2003 Pontiac Sunfire

1 Answer


I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...

Feb 25, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
1998 Volvo S70 Logo

388 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts


Level 3 Expert

71231 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7001 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides