Question about 2001 Volvo V70

1 Answer

Keyless Remote I went to change the battery in my keyless remote and when I took the old one out a small part came out and now I don't know where it goes.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 128 Answers

What does the part look like?

Posted on Nov 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced CR2032 battery in my pacificas keyless remote but it still wont work. I did not drop nor did water hit the remote. Was working fine one minute then died


First thing to do is check with your local Dodge dealer and see if the keyless remote is still under warranty. I had this same problem with a Dodge Durango Keyless remote. Problem was the + and - neg. connecters from battery to circuit board broke the solder connection going to the small circuit panel in the keyless remote, if this is the problem with yours, go the Radio Shack and buy a small 15watt soldering iron and solder for PC circuit boards and resolder it and it should fix the problem. If this did not fix it, the only thing to do is buy a new remote at your local Dodge dealer

Sep 20, 2011 | Chrysler Pacifica Cars & Trucks

1 Answer

How do I change the battery on keyless remote


the keyless remote splits in half then just remove the battery and replace, i have an 07 and thats what i had to do

Mar 15, 2010 | 2006 Pontiac G6

2 Answers

Keyless Remote Won't Work - But Car Starts


The remote receiver unit is located in the rear view mirror. This may be faulty. Since the car is new (less than a year?) you still may have the factory warranty.

Jan 16, 2010 | 2009 Volvo S40

1 Answer

How to change battery on keyless entry


There should be a small screw on the remote if not just pry it open. it will snap back together.

You should be able to split the remote in half. You can usually use a small flat blade screw driver to do this. You should a line all the way around the outside of the remote. Gently pry it open and replace the battery.

When you can see the CODE BAT, select your new battery HERE.

I hope helped (remember rated this help). Good luck.

Dec 02, 2009 | 2001 Mazda MPV

1 Answer

My keyless remote wont work


needs replacement battery

Aug 22, 2009 | 2005 Ford Freestyle

2 Answers

Purchased used. have remote for keyless remote.


That you need to take it to a car stereo dealer that install NEW keyless entry's...Sorry, thats the easiest way to fix this issue.

Jun 14, 2009 | 1999 GMC Jimmy

1 Answer

Keyless entry doesn't work, batteries good in transmitter,fuses good


there is a tester that checks for Rf signals from your remote. if the batteries are good, you should get a strong signal from it. most likely the remote went bad

May 09, 2009 | Dodge Dakota Cars & Trucks

1 Answer

Suzuki 2003 - Keyless Entry not working, alarm goes off with key


Unfortunately, the keyless entry remotes and OE systems usually require a dealership to service them. Sounds to me like they need to re-set the alarm

Apr 13, 2009 | 2003 Suzuki Aerio

1 Answer

Truck won't start


Possible weak battery has got the security system where it want respond or in some models want let the vehicle start until a new battery is installed and you use the keyless remote to active the securtiy mode a time or two possilbe then the vehicle will operate properly ..no question it is something electronic and this might be a possilbe solution check the battery to see if is still good,

Nov 28, 2008 | 2006 Chevrolet Silverado 2500HD 2WD

1 Answer

Keyless entry remote doesn't work with old or new batery. If sensor is bad where is sensor and how do you know if sensor is prolem with keyless remote.


I had the same problem. Went to dealer who said it probably needed to be reprogrammed (around $45-50). Paid for premium assistance with FixYA. Ginko gave me the procedure to reprogram my remotes. It was very easy and worked great. Now both of my remotes are working and it only cost me $9.99.

JOECOV

Jul 29, 2008 | 1999 Buick Century

Not finding what you are looking for?
2001 Volvo V70 Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...