Question about 1993 Pontiac Grand Am

2 Answers

93 pontiac grand am

I have put a new crank sensor 3 different ign modules diferent coils 2 different computers but no spark

Posted by on

  • dwkammer Nov 06, 2008

    do the harmonic balancers go bad

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Thank you nicksudekum i had the same problem with my 93 grand am gt i hooked a load tester to the batt and the positive hot wire started to crackle and fizz i replaced the connector just like you said and my car started right back up thank you so much for your help

Posted on Jan 27, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

This happened to me on my 93 grand am. I also like you got new sensors and a new computer which did not fix the problem. It turned out to be a cracked wire at the battery. Thats right a wire on the positive side of the battery that wasn't even broke all the way through. I re spliced the wire and VAROOOOM it fired right up.

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont start.


Crank sensor faulty.

Nov 26, 2011 | 2001 Pontiac Grand Am SE

1 Answer

2000 chevy 3/4 ton 2 wd 5.7L 42,ooo miles have no spark from ign. coil have replaced coil ,ign module and crank sensor please help


Better pull the dist. cap make sure the rotor turns when cranked,and if it does put a rotor on it.They will "fire" a hole thru the rotor to the shaft and kill the spark.

Jun 17, 2011 | 2000 Chevrolet 2500

1 Answer

Does the crank sensor send the spark to the spark plug and can i fix this? this is for a 98' pontiac gran prix


yes the crank sensor sends a signal to the computer to fire the plug through the ignition control module which then fires the coil.

May 28, 2010 | 1998 Pontiac Grand Prix

1 Answer

I have a 97 plym grand voy. 3.3 v6, it has new ignition coil, new spark plug, new crank shaft sensor, new camshaft sensor, but it missfire the cilinder n3 and n6, check the wires from the pcm to the ign....


Not likely. With 3 cylingers out, it would not run. When you have one coil, and spark different at any plug, it has to be wires. Not unusual to have 2 bad wires. Switch with one thought to be good before buying anything. Check the voltage at suspect injector, with test light. Should flicker. If flickers, swap injector with one thought to be good. Buy only parts known to be bad by comparison.

Jan 16, 2010 | 1997 Plymouth Voyager

1 Answer

93 jeep burns out crank sensors


SONDS LIKE YOR ALTERNATER IS OVER CHARGING REPLACE THE INTERNAL REG

Aug 31, 2009 | 1999 Pontiac Grand Am GT

1 Answer

1992 pontiac grand prix cranks but will not start


there is a module that the coil pacs plug into, it may be bad or have a bad connection

Nov 21, 2008 | 1992 Pontiac Grand Prix

1 Answer

Motor runs rough no power 1989 pont.grand prix. 3.1 motor


unplug your harness for your transconverter clutch for transmission,this will not harm your transmission. i had this problem on a 91 grand am

Aug 20, 2008 | 1993 Pontiac Grand Prix

1 Answer

Motor runs rough


Hi,there. I would suggest you do a compression test to verify that the cyl head was installed correctly.If the compression is good,i would check for codes stored in the computer and go from there.Good Luck!!!

Aug 04, 2008 | 1993 Pontiac Grand Prix

Not finding what you are looking for?
1993 Pontiac Grand Am Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...