- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Toyota Highlander C1233 OBD-II Diagnostic Chassis (C) Trouble Code Description
Toyota Highlander car C1233 OBD-II Trouble Code The ABS module receives wheel speed readings from each wheel speed sensor and processes this information to determine if an ABS event is necessary. The wheel speed sensor detects the magnetic field of
Reason For Toyota Highlander C1233 Code
The reason of Toyota Highlander C1233 OBD-II Engine Trouble Code is C1233 Left Front Wheel Speed Sensor Input Signal Missing.
C1095 refers to a noticed failure with the ABS pump motor. C1230 and C1102 refers to a failure with the rear ABS wheel speed sensor. You may have two separate issues but I think if you inspect the wiring, and it is fine. Replace the rear speed sensor and that should fix your problem. Please write back if you need more help, good luck.
Hi!! When Yellow ABS warning light illuminates during normal operation, the system has detected a problem and has stored a Diagnostic Trouble Code (DTC). Loss of power to module will cause system to be deactivated and Yellow ABS warning light to be illuminated. This fault will not set a DTC. The Rear Anti-Lock Brake System II (RABS II) Speed Sensor is located on the Rear Differential Case. This sensor sends the speed signal of the rear tires to the RABSII Control Module, which also receives the Turbine Shaft Speed Sensor. The RABSII Control Module uses both signals to control the RABS II Proportioning Valve. If the RABSII Control Module does not receive both signals, the ABS Light will come ON. Finally, the Sensor I think is giving you trouble.The Turbine Shaft Speed (TSS) Sensor is located on the transmission tail. This sensor sends the speed signal to the PCM which in turn sends it to the Speedometer and to the RABSII Module. If this sensor is disconnected or inoperative, the Speedometer won't work and the ABS light will come ON. Check electrical connector to the sensor, make sure is clean, free of corrosion and properly connected. Before you replace the sensor, have the computer codes scanned for FREE at AutoZone, Checkers or similar autoparts store. Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.
The brake pads and shoes are not elec., your abs light is on because your abs computer pick up a bad signal from one of your abs sensor's,, take it to any auto parts or some one like autozone where they can do a code reading and get back us with the code so we can help you diag. your trouble code.