Where is crank position sensor on a 1997 chevy 5.7

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Marvin

• 85242 Answers
• Posted on Jan 21, 2009

SOURCE: location of crank position sensor on 92 chevy corsica 3.1

You will have a no start or stalls after engine gets hot and then cools down restarts, the sensor is on the front of the engine mounted into the cam gear cover if it is not visiable get under the, (here is a picture) car and look.

SOURCE: Testing a crank position sensor on a 1997 astro

If you don't have the van, it will be very difficult to test the Camshaft Position Sensor. Most reliable tests involve cranking the engine with the sensor installed and testing the sensor's output ranges. Most CPS's are magnetic and therefore testable conditions will be most difficult to achieve outside of the vehicle.

However, if you use a voltmeter, you can test if there is any resistance between terminals 2 and 3 (on a three terminal CPS). If the resistance is zero, this will only tell you that it is probably dead, but will not test if it has any other faults.

I hope this helps.

Mike Butler

• 6674 Answers
• Posted on Sep 05, 2009

SOURCE: crank shaft position sensor needs replacing in 96 Chevy cavalier

Try this.

SOURCE: 98 chevy cavalier cranks but wont start changed

try to start the car, than the anti theift would shut the car off. you wait ten min with the key on, until you see the anti theift flash or disapear. than turn key to off position and try to start it. this will reprogram the computer.. Good luck.

you can also try disconnecting the battery for 30 minutes