An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: Fog light bulb replacement
This bulb can be replaced without removing the washer fluid reservoir. There are 3 screws that go through the bottom edge of the bumper cover into the right inner fender guard. Remove these screws and pull the inner fender down to gain access to the back side of the fog lamp and remove the bulb.
Nissan Scope Technician- 10+ years experience in Nissan dealership.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check the bulb, socket interface, clean contact points. IF you have a test light or ohmeter, check for power to the socket. If unpowered, check the fuse, if powered check bulb element, and socket condition.
you can take loose the black plastic shield that runs from inner fender to bottom of bumper. once loose you gain access to back of fog light where mounting bolts are located if its just the bulb your replacing you can also do that without removing it
hi..You will have to access the fog light bulb from below the vehicle.
Remove the plastic clips from the wheel well cover extension that is
below the fog light.once the clips are out and the plastic cover is pull
down,you should be able to see the back of the fog light.you can try
to replace the fog light bulb by removing the two 10mm bolts and slide
the fog light assemble out through the front of the bumper.Turn the cover
of the rear of the fog light and replace light.
try this out..
kindly rate my response..
the service light with wrench is for service vehicle and is on possibly because there is a burned out light bulb on the exterior. turn lights on and check every light even the license plate light. i bet there is a bulb out somewhere. check every light and hopefully this is the problem.
jorgeva: on the driver's side to gain access, you must remove the air cleaner assembly. At that point, you can see the back of the light which has a plastic cap. Rotate this "counter clockwise" and you can pull it back from the back of the lamp housing. From there you will see how the bulb it self is plugged in, which is obvious. Unplug it. There is a "spring "like latch retainer to hold the bulb in place. Unlatch it, remove the bulb and install the new bulb.
CAUTION!!!!!!! DO NOT TOUCH THE GLASS AREA OF THE NEW BULB! Only handle the rear section. Reassemble in the reverse order.
The right side will require the removal of the windshield washer tank.
I trust this will have answered your question. If you would, let me or FIXYA know if I have solved your problem......
you don't. you disconnect the wire on the back of the light assembly and then the bulb twists counter clockwise and pops out, to re-install reverse the procedure. the wire is accessible from below the car under a black plastic flap the pulls down out of the way directly underneath the fog light.