Question about BMW 328

1 Answer

BMW 328I 1997 TOURING ON TICK OVER SOME TIMES REVS GO UP AND DOWN 1000/1400 REVS AND THEN BACK TO 800. REPLACE MAF SENSOR.RECENTLY HAD REPLACEMENT HEAD ASWELL. CAR HAS DONE 138000 MILES.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Has it been timed up correctly when head replaced,also check the icv, idler,ecu working overtime,get fault codes from garage if poss

Posted on Nov 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 bmw 328i sputters when i rev over 2000


no definetly not camshaft sensor but problem with fuel pump

Feb 07, 2014 | Cars & Trucks

1 Answer

Ford cougar


If holding back on excelleration like to be the MAF sensor faulty. Easy to test by simply unplugging MAF sensor, car is likely to stall on tick over by doing this but on higher revs if car then revs freely then you could try cleaning MAF sensor with aerosol cleaner you can purchase from most car factors but more likely to need replacing.

Dec 01, 2013 | Cars & Trucks

1 Answer

Hey, my 1997 Bmw 328I is idleing irratically


Hi Paula, Had same problem with mine,use a can of throttle cleaner.Disconnect air intake from the air filter to the last clamp.Start car (get help) spray into intake and don't be shy about how much you spray. Rev car moderately, car will stall, and just keep repeating the process. You should see black type fluid running out, when it stops you stop.

Feb 19, 2013 | 1997 BMW 328

1 Answer

I have a 1999 bmw 328i se manual it runs fine when cold but once walmed up it cuts out when i put the clutch in and some times revs up and down also recently a very quite ticking sound has started ???


the idle is the control stepper motor on the inlet manifold as it sounds like its sticking or the its not recieving the signals from the ECu also check the vacumn pipes in case one or more is perished causing it to **** in air ,as for the noise i would need my head under the bonnet and listen to know what this noise is and if its related to the idle problem

Mar 03, 2012 | Cars & Trucks

1 Answer

How easy is it to replace the lid motor on a bmw 328i 1997


Lid Motor? Is this a convertible & you're referring to lid when top is down?

Jan 05, 2011 | 1997 BMW 328

1 Answer

97 328i throttle sticking in high rev.


if the throttle plate is sticking clean it with throttle body cleaner with an old tooth brush. if still doing the same, it maybe the throttle position sensor is acting up. need more info to help. you at idle. starting up car. when hot or cold motor. best of luck

Aug 07, 2009 | 1997 BMW 318

1 Answer

Indicator light for a 1997 bmw 328i


i think it means that you have a turn signal bulb that needs replacing cause its not working. check turn signals and see if they are blinking properly from front & rear of vehicle.

Mar 16, 2009 | 1997 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...