Question about 1992 Honda Civic

1 Answer

Instrument panel takodometer,speedodometer,gas gauge,temp gauge,blinkers,and shifter is not working. the battery light and the SRS light still work,but nothing else on the instrument panel work. already checked the fuses and wiring. I'm wondering if the instrument panel assembly is needing to be replaced.

Posted by on

  • cmacsmooth1 Jan 28, 2009

    i have the same problem the srs light is still lit but no lights in the instrument panel

  • Anonymous Mar 30, 2014

    light above temperature gauge in instruments

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If you take off the cover around the steering colum there should be a wire connected above your blinker switch if its not all the way pushed in tac ,speed and other lights will not work.

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My fuel gauge, speedometer gauge, RPM gauge oil pressure temp gauge not workinge gauge, battery gauge


There should be an instrument panel fuse in the fuse box located inside the car. Check the fuse and replace in needed.

Oct 11, 2016 | 2000 Ford Explorer

1 Answer

The blinker lights arent working and neither is the hazard lights the temp lights the fuel gauge the temperature gauge


I have seen the same issues in my own car and a few others an almost every time it is a relay mine was located between the steering wheel and the gauge cluster on the steering shaft. Mine simply jostled out an needed to be plugged it again but the others I've seen 2 had bad relays, 1 had a a bad harness farther down under the dash. And the worst issue I have seen with these issues was a bad computer. There is also 1-5 wire harnesses that plug into the back of your instrument cluster that you can check your connections there as well. Hope this helps, more information about the car will you get better answers for future reference

Sep 22, 2014 | Cars & Trucks

1 Answer

Gas gauge and blinkers stoped working on my 1988 nissan picup


check the fuse for the instrument panel It may be blown.

Feb 14, 2013 | Nissan Pathfinder Cars & Trucks

1 Answer

No guages working


If all voltages checked ok, then most probably its faulty instrument cluster board on which gauges are connected. Yes if cluster circuit board looks ok, then also it can be faulty. Somewhere there is minute short or burn on board then such problem arises.


Also check the fuse box. One under hood and other under dash.

Inspect each and every fuse and see if all are fine or not.


---------------

For more troubleshooting on these cluster gauges I suggest you to refer the list of help links mentioned below. Its step by step instructions will help you to confirm the exact cause of problem in these conditions: ---------


Click the link below: ------


2004 Toyota Tundra: Oil Gauge and Temp Gauge Not Working?

http://howtobyme.blogspot.in/2012/05/2004-toyota-tundra-oil-gauge-and-temp.html

--------------

2005 Lexus SC430: Fuel Door, Dome light and Fuel Gauge Fuse Location?

http://howtobyme.blogspot.in/2012/05/2005-lexus-sc430-fuel-door-will-not.html

----------

Toyota 4Runner: Temperature Gauge Sensor

http://technoanswers.blogspot.in/2012/04/toyota-4runner-temperature-gauge-sensor.html

------------

Temperature gauge sits over half way mark?

http://schematicsdiagram.blogspot.in/2012/04/temperature-gauge-sits-over-half-way.html

---------------

Heater blows intermittently and temp gauge goes erratic?

http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html

----------

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

-----------

2003 Pontiac Grand Prix: Erratic Fuel Gauge?

http://technoanswers.blogspot.in/2012/06/2003-pontiac-grand-prix-erratic-fuel.html

-----------

Temperature gauge keeps fluctuating up and down close to red?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-keeps-fluctuating-up.html

-------------

Temperature gauge on the dash quit working on Pontiac Grand Prix?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-on-dash-quit-working.html

---------------

Fuel gauge jumps from empty to full?

http://schematicsdiagram.blogspot.com/2011/12/fuel-gauge-jumps-from-empty-to-full.html

--------------

Gas gauge stuck on empty on 2002 Mercedes Benz 240c?

http://repairhelpcenter.blogspot.in/2012/02/gas-gauge-stuck-on-empty-on-2002.html

---------------

Oldsmobile Temperature Gauge Lamp Switch?

-----------------

Fuel gauge drops to Empty?

http://technoanswers.blogspot.com/2012/01/fuel-gauge-drops-to-empty.html

----------------

Dodge neon gauges not working?

http://technoanswers.blogspot.in/2012/02/dodge-neon-gauges-not-working.html

------------

Temperature gauge went up?

http://schematicsdiagram.blogspot.com/2011/12/temperature-gauge-went-up.html

------------

Temperature gauge stays At cold on jaguar?

http://technoanswers.blogspot.in/2012/02/temperature-gauge-stays-at-cold-on.html

-----------

How to replace Instrument panel and dashboard on Toyota car?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-instrument-panel-and.html

-----------

How to remove instrument panel on Chevrolet car?

http://technoanswers.blogspot.in/2012/02/how-to-remove-instrument-panel-on.html

-----------

How to remove control panel on Buick regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-control-panel-on-buick.html

---------------


These details will help.

Thanks.

Nov 28, 2012 | 2000 Mitsubishi Lancer

1 Answer

How to change heater core on 2005 dodge stratus?


  1. Disconnect the negative battery cable.
  2. Remove the radio/HVAC control module bezel. CAUTION
    The vehicles covered by this manual are equipped with a Supplemental Restraint System (SRS), which uses air bags. Whenever working near any of the SRS components, such as the impact sensors, air bag modules, steering column and instrument panel, disable the SRS, as described earlier in this section.
  3. Remove the right instrument panel side trim.
  4. Remove the two retaining screws at the lower right side support beam.
  5. Remove the instrument panel support bolt at the A-pillar.
  6. Remove the left instrument panel side trim and upper instrument panel bezel.
  7. Remove the lower knee bolster and console screws at the instrument panel.
  8. Remove the gearshift knob and shifter bezel.
  9. Remove the mounting screws at the front and rear of the floor console. Remove the front and rear console halves.
  10. Remove the right side instrument panel support strut.
  11. Drain the cooling system into a suitable container, then disconnect the heater hoses at the cowl panel. Plug the heater core outlets to prevent coolant from spilling during unit housing removal.
  12. Remove the mounting screws and heater core cover.
  13. Remove the heater core from the vehicle. To install:
  14. Carefully position the heater core unit into the heater housing.
  15. Install the heater core cover onto the heater housing and tighten the mounting screws.
  16. Install the right side instrument panel support strut.
  17. Install the front and rear console halves.
  18. Install the shifter bezel and gearshift knob.
  19. Install the lower knee bolster and console screws at the instrument panel.
  20. Install the upper instrument panel bezel and left instrument panel side trim.
  21. Install the instrument panel support bolt at the A-pillar.
  22. Install the two retaining screws at the lower right side support beam.
  23. Install the right instrument panel side trim.
  24. Install the radio/HVAC control module bezel.
  25. Fill the cooling system to the proper level.
  26. Connect the negative battery cable.

Aug 13, 2010 | 2005 Dodge Stratus

1 Answer

How do I remove heater core on 1997 dodge stratus


prev.gif next.gif Heater Core REMOVAL & INSTALLATION Cirrus, Stratus, Sebring Convertible and Breeze
  1. Disconnect the negative battery cable.
  2. Remove the radio/HVAC control module bezel. CAUTION
    The vehicles covered by this manual are equipped with a Supplemental Restraint System (SRS), which uses air bags. Whenever working near any of the SRS components, such as the impact sensors, air bag modules, steering column and instrument panel, disable the SRS, as described earlier in this section.
  3. Remove the right instrument panel side trim.
  4. Remove the two retaining screws at the lower right side support beam.
  5. Remove the instrument panel support bolt at the A-pillar.
  6. Remove the left instrument panel side trim and upper instrument panel bezel.
  7. Remove the lower knee bolster and console screws at the instrument panel.
  8. Remove the gearshift knob and shifter bezel.
  9. Remove the mounting screws at the front and rear of the floor console. Remove the front and rear console halves.
  10. Remove the right side instrument panel support strut.
  11. Drain the cooling system into a suitable container, then disconnect the heater hoses at the cowl panel. Plug the heater core outlets to prevent coolant from spilling during unit housing removal. Fig. 1: Remove the heater core cover 90906g01.gif
    Fig. 2: Remove the heater core 90906g02.gif

  12. Remove the mounting screws and heater core cover.
  13. Remove the heater core from the vehicle. To install:
  14. Carefully position the heater core unit into the heater housing.
  15. Install the heater core cover onto the heater housing and tighten the mounting screws.
  16. Install the right side instrument panel support strut.
  17. Install the front and rear console halves.
  18. Install the shifter bezel and gearshift knob.
  19. Install the lower knee bolster and console screws at the instrument panel.
  20. Install the upper instrument panel bezel and left instrument panel side trim.
  21. Install the instrument panel support bolt at the A-pillar.
  22. Install the two retaining screws at the lower right side support beam.
  23. Install the right instrument panel side trim.
  24. Install the radio/HVAC control module bezel.
  25. Fill the cooling system to the proper level.
  26. Connect the negative battery cable.
Sebring Coupe and Avenger
  1. Disconnect the negative battery cable. CAUTION
    The vehicles covered by this manual are equipped with a Supplemental Restraint System (SRS), which uses air bags. Whenever working near any of the SRS components, such as the impact sensors, air bag modules, steering column and instrument panel, disable the SRS, as described earlier in this section.
  2. Remove the instrument panel from the vehicle, as outlined in Section 10 of this manual.
  3. Drain the cooling system into a suitable container, then disconnect the heater hoses from the dashboard panel. Plug the heater core outlets to prevent coolant from spilling during unit housing removal.
  4. Remove the center stay.
  5. Remove the lap cooler duct mounting screw. Remove the center duct.
  6. Remove the left and right rear heater ducts.
  7. Remove the foot distribution duct.
  8. If equipped with A/C, remove the cooling unit mounting nut and bolt.
  9. Remove the retainer clip, then the heater unit.
  10. Remove the heater core. Fig. 3: Exploded view of heater unit and core assembly 90906g03.gif
    To install:
  11. Install the heater core into the heater housing.
  12. Install the heater housing and retainer clip into the vehicle.
  13. If equipped with A/C, install the cooling unit mounting bolt and nut.
  14. Install the foot distribution duct. Install the left and right rear heater ducts.
  15. Install the center duct, then install the lap cooler duct mounting screw.
  16. Install the center stay and connect the heater hoses to the heater core at the dashboard panel.
  17. Install the instrument panel.
  18. Fill the cooling system to the proper level.
  19. Connect the negative battery cable.

Jul 08, 2010 | 1997 Dodge Stratus

1 Answer

Instrument Panel Problem - Electrical


check all wiring and maby youl get it right

Sep 18, 2009 | 2005 Chrysler PT Cruiser

1 Answer

Gas gauge moves from full to empty to half, while idiol.


Traction Light has a traction system sensor going bad.
Blinker rapid flash- brakes applied, Need to replace dual function tail lamp bulb(brake turn
bulb)
Reverse light need shifter adjustment.
Gas gauge The sending unit in your tank is going bad replace it.

Mar 19, 2009 | 2001 Oldsmobile Silhouette

1 Answer

Instrument cluster damaged after battery shorted out.


4 resistors on the back of cluster bad get them at radio shack.

Dec 14, 2008 | 1998 Buick Regal

Not finding what you are looking for?
1992 Honda Civic Logo

366 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...