Question about 2000 Ford Mustang

1 Answer

1999 mustang my husband changed the transmission fluid well he put 6 quarts in and then he said u r suppose to start the car then add the other 7 quarts xcept when he tried to start ignition would not turn we tried moving the steering wheel back and forth jacking the car back up everything help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 150 Answers

Did this help

Posted on Nov 03, 2008

  • Brian032472
    Brian032472 Nov 04, 2008

    Did you try turning the steering wheel hard to the left or right to unlock the steering column?

  • Brian032472
    Brian032472 Nov 04, 2008

    Did you try turning the steering

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How much trans.oil does the trans.hold


On 1999 Jeep Cherokee 4WD 4.0L MFI 6cyl ...
With Transmission model AW4:
-Service change only - 2 quarts.
- Total refill - 8.2 quarts.

With 30RH transmission: Pennzoil Multi Vehicle ATF

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 08, 2012 | 1999 Jeep Cherokee

1 Answer

How many quarts of transmission fluid do i need to put in after a used transmission is installed in my 1990 nissan maxima se


If you drained the torque converter 6 or 7 quarts. If not about 4 quarts. Best to start out with 3 start the car and add from there.

Aug 14, 2011 | 1990 Nissan Maxima

2 Answers

Need to know how much transmission fluid to add if empty


Automatic Transmission, E4OD Initial Fill..........6.5 quarts
Automatic Transmission, C6 Initial Fill..........6 quarts
Automatic Transmission, 4R70W Initial Fill..........5 quarts
Automatic Transmission, 4R75W Initial Fill..........5 quarts
Automatic Transmission, Total Fill
4 speed E4OD..........15.7 quarts
4 speed 4R70W..........14 quarts
3 speed C6..........12.1 quarts
4 speed 4R75W..........14 quarts

E 150 5.0L engine

Feb 22, 2011 | 1996 Ford Econoline

1 Answer

How much transmission fluid should be put in a 1995 cutlass ciera?


If you are just draining the pan and replacing the filter it will hold around 6 quarts. However the total capacity on the THM125C transmission is 7 Quarts. On the 4T60-E transmission it is 13.4 quarts. My advice if you wish to replace it all is to have it done by a professional. If you are just draining the pan and replacing the filter then park on level surface, add 5.5 quarts and then start the engine and let the transmission reach full operating temperature. Add enough to reach the full mark. Do not overfill! Use Dexron 3 A/T fluid.

Feb 06, 2011 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

My tranny slips some times but it will catch after a few min


SOUND LIKE TRANSMISSION FLUID LOW OR YOU NEED A TRANSMISSION FLUID AND FILTER CHANGE.THE 4T40E OR 4T45E IF YOU DONT SEE TRANSMISSION DIP STICK.BEST TO DO A FILTER AND FLUID CHANGE.YOU NEED 7 QUARTS OF TRANSMISSION FLUID A NEW TRANSMISSION FILTER AND PAN GASKET.I WOULD BUY FILTER AND PAN GASKET AT DEALERSHIP.YOU NEED A LARGE DRAIN PAN TO CATCH TRANSMISSION FLUID.IF YOU HAVE A TRANSMISSION DIP STICK. BEFORE YOU FIRST BEFORE STARTING THE ENGINE CHECK TRANSMISSION FLUID LEVEL ON DIP STICK.SHOULD BE ON THE FULL MARK.IF NOT ADD FLUID TO FULL MARK.THEN CRANK VECHICLE LET IDLE UNTIL ENGINE HOT OPERATION TEMPERATURE ABOUT 10 MINUTES.THEN APPLY BRAKE PEDAL.THEN SLOWLY SHIFT TRANSMISSION SHIFTER THROUGH ALL GEARS 2 TIMES.THEN PUT TRANSMISSION IN PARK.CHECK TRANSMISSION FLUID LEVEL.IF NOT AT FULL MARK ADD TRANSMISSION FLUID UNTIL LEVEL CORRECT.

Nov 13, 2010 | 1999 Oldsmobile Alero

1 Answer

How many quarts of transmission do i put in my 1993 jeep Cherokee sport 4.0L


If the filter has been changed,start with four,start the engine and move gear selector to drive and reverse,and do this a few several times and then back to park,then if needed add a quart at a time ,remember to wipe the dip stick several times upon checking the fluid level,to be acuate,it should not hold over 6 to 7 quarts.

May 28, 2010 | 1993 Jeep Grand Cherokee

1 Answer

1996 mustang v6 3.8 reverse works fine, but no forward gears. had to add 3 quarts trans fluid. don't see any leaks.


its impossible to lose that much fluid with out a leak. the was so low that it has burned your clutches out. would have to rebuild or replace entire transmission

Apr 05, 2010 | 1999 Ford Mustang Cobra

3 Answers

How much transmission fluid do I put in my 2003 alero. I am changing the filter and gasket.


IT WILL TAKE 7 QUARTS FOR FLUID CHANGE.YOU NEED TO USE FACTORY GASKET.BECAUSE THE GASKET THAT COME WITH FILTER WILL LEAK.I HAD THAT PROBLEM.YOU CAN REUSE THE OLD GASKET.ITS THICK RUBBER GASKET WITH HOLDING HOLDING TABS THAT HOLD IT IN PLACE.IF GASKET LOOKS DAMAGED OR BAD ITS BEST TO BUY IT AT DEALERS SHIP.IT COST ABOUT $40.00 DOLLARS.THE GASKET THAT COME IN FILTER KIT IT TOO THIN.IT PLAIN.IT DONT HAVE SEALING BEADS IN IT.WHEN YOU PUT IT ON ADD FLUID TRANSMISSION WILL LEAK THROUGH THE GASKET.LOOK AT THE OLD GASKET LOOK AT THE DOUBLE SEAL BEAD IT HAS IT KEEP IT FROM LEAKING.

Jan 18, 2010 | 2003 Oldsmobile Alero

3 Answers

Does the crown vic police intercepter take as much oil as the regular crown vic? (when changing the oil and filter)


I ~think~ the 1999 is the same as the 2000 (mine is a 2000 P71)

The 2000 CVPI (Crown Vic Police Interceptor) owners manual recommends the following:

Engine Oil - Motorcraft SAE 5W-30 Super Premium Motor Oil 5.0 quarts

Transmission Fluid - Motorcraft Mercon V ATF 13.9 quarts (fluids Mercon & Mercon V are NOT INTERCHANGEABLE, DO NOT MIX)

Fuel Tank - 19.0 gallons

Break Fluid - DOT 3


Rear Axle Lubricant - Motorcraft 80W-90 Premium Rear Axle Lubricant 3.75 pints (add 4 oz of Additive Friction Modifier C8AZ-19B546-A or equilavent meeting Ford Spec. EST-M2C118-A for complete refill of Traction-Lok Rear Axles)

Engine Data - 4.6L V8 Engine
Cubic Inches - 281
Required Fuel - 87 Octane
Firing Order - 1-3-7-2-6-5-4-8
Spark Plug Gap - 1.3-1.4 mm (0.052-0.056 inch)
Ignition System - Coil On Plug
Compression Ratio - 10.0:1

I hope this helps!

Jun 27, 2009 | 1999 Ford Crown Victoria

Not finding what you are looking for?
2000 Ford Mustang Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...