Question about 2007 Honda Accord Sedan
HOW DO YOU LOCATE AND CHANGE CABIN AIR FILTER?
Open the glove box. Remove the damper from the glove box then let the glove box hang down
Remove the dust and pollen filter assembly from the evaporator case.
Remove the filter (A) from the housing (B), and replace the filter.
Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the evaporator
Posted on Nov 03, 2008
SOURCE: cabin air filter
Purchase a Purolator Cabin Filter for your Impala. It comes with complete instructions. The filter is located below the windshield, passenger side. The black plastic cover must be removed to access the filter. You simply raise the hood and remove 3 plastic clips, and the washer hose from it's holders. This will allow you to remove the plastic cover over the filter
Please rate this
Posted on Nov 22, 2008
1. Open glove box
2. Unhook elastic retainer on right side
3. Locate the two "stop tabs", one on the upper left and the other on the right side. Push both to the left to clear their stops and the glove box will swing down, allowing access to the filter cover.
Posted on May 06, 2009
The cabin air filter is behind the glove box. The first thing you need to do is empty the glove box. (2) you need to remove the side panel that runs along the side of the shifter, it is a long panel and has on clip near the firewall, the clip will have a phillips head on it, just back it out and remove this panel. Then remove all the bolts (10MM) holding the glove box on, The glove box is will stay up because it has two hings that run into the sides of dash. All you need to do is squeeze the glove box untill it pops out and the glove box will be out. There is no need to unhook the wiring for the light bulb just let the glove box hang on the floor. Now you will see a black cover that is held on by 4 small metal clips, remove these and pull the cabin air filter out. when you reinstall the new one, make sure you put it in with the air flow arrows pointed in the right direction or else you will cause blockage. reinstall and enjoy your new heppa filter
Posted on Jun 25, 2009
This solution pertains to a 2008 Honda Pilot...To replace the cabin air filter which is located on the passenger side of the vehicle behind the glove box: Open glove box and remove stored items...while sitting in the passenger seat, pull towards you on each of the two clips on the left and right side of the glove box...this will cause them to become loose and the glove box will tip out completely exposing the inside of the dashboard. (Alternately...carefully pull towards you on the top center of the glove box which will cause the left and right side stops to pull away from the edges and allow the glove box to tip out) Here it gets tricky...the box holding the cartridge for the cabin air filter is the large black box on the left side behind the glove box The filter fits in a removable tray vertically inside that box. A pressure clip at the top of the box allows the vertical cover to be removed exposing the tray with the Cabin air filter... BUT!!! There is a plastic bar an inch or so high which has been placed there by the manufacturer to prevent most from changing the filter without the service department being involved. This bar must be cut with a sharp sheetrock knife or hacksaw and discarded, (it will not be reinstalled). Then there is a flat metal bar behind the plastic bar that can be removed using an 8mm socket and a phillips screwdriver. There are 2 8mm screws and one phillips head screw on each side that must be removed in order to remove the metal bar. THEN you can remove the cover to the cabin air filter box, pull out the tray with the filter (note how the filter is in the box so the new one can be placed the same way) reinsert the tray with the new filter and replace the tray cover. All other steps to finish the job are obvious as everything is the reverse. Actually the whole process is a lot of trouble and unless you are determined to change the filter I would recommend not doing it.
Posted on Apr 01, 2010
Tips for a great answer:
Feb 05, 2016 | 2006 Chevrolet Chevrolet Malibu
Jan 20, 2016 | Cars & Trucks
Sep 20, 2014 | Cars & Trucks
Feb 14, 2014 | 2009 Pontiac G8
Jun 05, 2011 | 2008 Volkswagen Beetle
Locate the cabin air filter container on your Lincoln LS. Looking at the engine from the front, you will find the casing on the left side against the back firewall. The cabin air filter is mounted vertically and is approximately 6 by 9 inches and about 2 inches deep.
Remove the cowling cover by pushing in the black cover pins and lightly prying the cover off with a screwdriver. Lift the filter out of the container.
Vacuum the inside of the container to remove any dust or debris. Wipe down the inside and outside of the container and lid with a clean damp cloth, then dry it off completely.
Insert the new cabin air filter into the container and check to make sure it is seated properly. Cover the container by putting the lid back on and gently pushing down to make sure the pins click into place.
Jun 02, 2011 | 2001 Lincoln LS
Dec 06, 2009 | 2003 Chevrolet Silverado 2500HD
Nov 26, 2008 | 2006 Honda Accord
662 people viewed this question
Usually answered in minutes!