Cruise control ford f-150

SOURCE: horn,airbag light,cruise control

ON CERTAIN MINIVANS, THE DRIVER'S AIR BAG MAY BECOME DISABLED DUE TO A FAILURE OF THE CLOCKSPRING, WHICH IS LOCATED IN THE HUB OF THE STEERING WHEEL. Consequence Summary: THIS CONDITION WILL MANIFEST ITSELF THROUGH ILLUMINATION OF THE AIR BAG WARNING LAMP, AND COULD EVENTUALLY RESULT IN A DRIVER'S AIR BAG OPEN CIRCUIT, IF THE PART IS NOT REPLACED IN A REASONABLE AMOUNT OF TIME. Corrective Summary: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY ON ALL COVERED VEHICLES WITH 70,000 MILES OR LESS. FOR THOSE VEHICLES WITH MORE THAN 70,000 MILES, DAIMLERCHRYSLER WILL OFFER AN EXTENDED LIFETIME WARRANTY UNDER WHICH IT WILL REPLACE THE CLOCKSPRING AT NO CHARGE IF IT FAILS. DAIMLERCHRYSLER WILL ALSO REIMBURSE OWNERS WHO HAVE PAID TO HAVE THE CLOCKSPRING REPLACED ON THEIR VEHICLES. THE RECALL BEGAN ON OCTOBER 12, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403. A malfunctioning clockspring can also effect your cruise control,radio, wipers, and your horn relay. This can also happen one at a time til none of these are working.The solotion is to get the clockspring replaced . I DO NOT suggest you doing this on your own!

SOURCE: cruise control on my 1005 ford f-150 not working.

No the exterior lighting is an independent system and not related. Just replace the light and you should be good as far as the backup light goes.

SOURCE: horn,airbag light,cruise control

Sounds like a bad clockspring

SOURCE: My cruise control quit. What might be some of the

theres one of two things i think it is, either cruise servo or bad contact with brushes on plate behind steering wheel. Does the horn work? if not, thats most likely the source.

SOURCE: ford f350 horn and cruise control quit working,

It is most likely a part called a clockspring. It is located behind the steering wheel. When that part is defective you will almost definitely lose your horn, airbag, and cruise control. If it is not that it is probably corroded at the harness located on the steering column or at the cruise control module in the engine bay. If you have tilt, which you probably do, those wires can become frayed at the plug or directly after the plug at the column. I would start with fuses, then wires, then clockspring.