Question about 2007 Toyota Corolla

4 Answers

Oem code p2716

My check engine light came on i had it diagnosed at the auto parts store and got oem brand code p2716 pressure control solenoid d electrical fault. could you tell me in laymans terms what that means? Intermittent rough shifting and check engine light is on.

Posted by on

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Same issue.

There is a service bulletin on this. Toyota will replace computer. I have a 2007 Corolla S with 56,000 miles

Posted on Mar 07, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 104 Answers

The pressure control solenoid controls the fluid pressure inside the transmission, which governs the speed at which each gear is engaged, or it's harshness. This code could indicate a sticking solenoid, or a faulty solenoid, or a problem with the electrical signal to the solenoid. Does the vehicle still have a current warranty (being so new)? If so, it is highly likely that this fault would be repaired by the dealership for free, as it seems unlikely that it could be caused by external factors. You could check under the car to see if there is any sign of impact damage or similar to the transmission to at least attempt to rule this out..

Hope this helps,
Mark.

Posted on Nov 02, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

I have a 07 corolla, i pulled the same code (p2716) after experiencing harsh shifting and the "Check Engine" light came on. It appears to be a known issues with '05-'07 Matrix and corolla . there is a Technical Service Bulletin (TC015-07) from Toyota
It calls for replacement of the ECU (PCM)(engine control unit). the TSB also states
"this repair is covered under the Toyota Federal Emissions Warranty. this warranty is in
effect for 96 months or 80,000 miles, whichever occurs first, from the vehiclesoem code p2716 - icon1.png in-service date". safest bet is to take it to the dealership and have them replace the part under warranty

Posted on Nov 13, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 136 Answers

The recall still applies if the car is 80,000 miles or less . You don't need a warranty. The recall is for 8 years . Just take it to the dealer and remind them to replace your ECM.

Posted on Nov 29, 2011

1 Suggested Answer

SOURCE: oem code p2716

Get your ECM checked out!

I was driving on the freeway when I noticed that I couldn't accelerate. The my service engine light turned on. I shut off my engine, but when I tried to turn it back on, no luck.

Posted on Oct 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car has problem of jerking on 10 30 and code comes up 2716


Muhammad, Possible transmission solenoid problem, code P2716 pressure control solenoid 'D' circuit malfunction. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
found this helpful answer from toyota mechanic on JustAnswer com
Transmission Pressure Control Solenoid PCS
P2716 2007 Toyota Camry Pressure Control Solenoid Electrical Shift...
Transmission Code P2716

Jun 08, 2016 | Cars & Trucks

1 Answer

What is P2716 code for a 2006 Corolla mean?


It is common for a failed engine control module to call this code. First you can replace the solenoid and test the wiring and if problem is still there replace ecm. Let me know if you have questions, thanks.
P2716 Pressure Control Solenoid 'D' Circuit Malfunction
Possible Causes Setting Conditions
  • Shift solenoid (SLT) connector is damaged (check pins for damage, moisture)
  • Shift solenoid (SLT) control circuit is open or shorted to ground
  • Shift solenoid (SLT) has failed (electrical fault)
  • ECM has failed


Read more: http://www.justanswer.com/toyota/2zd2p-toyota-code-p2716-repair-it.html#ixzz3XycnoMij

Apr 21, 2015 | 2006 Toyota Corolla

2 Answers

03 Toyota 4runner 4wd 4.7l had codes p0771 , p0986, and p2716 with vsc light on. Told to replace trans. Replaced with used and now has p0778 and p2716 now with vsc light on and still harsh shifts


Who told u to replace trans?..first thing should have been done was check wiring and connections at transmission and ECM and between the 2...also need to check the pressure control solenoids B and D...its possible the ECM is acting up especially since P2716 came back twice.

Mar 08, 2015 | Toyota Cars & Trucks

1 Answer

P2716 code in 2007 Toyota Corolla


P2716 -Pressure Control Solenoid "D" Electrical (Shift
Solenoid Valve SLT)
Trouble Area:
1. Open or short in shift solenoid valve SLT circuit. (repair harness wiring)
2. Shift solenoid valve SLT defective. (replace)
3. ECM defective. (replace with a good known one)

Nov 25, 2013 | 2007 Toyota Corolla S

1 Answer

Pressure Control Solenoid P2716


have the code checked especially if the car is out of warranty. If it is still under warranty take the car to the dealership . The Pressure Control Solenoid determines the quality and accuracy of the shift points and if you let it go the transmission will not shift properly after a period of time. The pressure control solenoid is used by the PCM to raise the mainline hydraulic pressure during high throttle - this increases the holding force on the clutches and bands and prevents slipping. The pressure control solenoid is controlled by pulses from the PCM and this in turn operates the boost valve insde the valve body.

The problem could be either in the PCM or it could be an electrical problem with the solenoid. As suggested it should be diagnosed by a transmission tech. They can check if the PCM is good by looking at the pulses with an oscilloscope at the connector and they should also be able to test the continuity of the solenoid. If the solenoid is faulty the valve body will need to be removed and the solenoid replaced.
good luck

Apr 04, 2010 | 2006 Pontiac Vibe

2 Answers

P2716 pressure control solenoid d 2005 toyota corolla 117000 miles check engine light on


This is very common on Matrix/Corollas and is repairable by way of replacement PCM to correct invalid parameters. the labor is low but the part is very expensive.

Expect approximately $89 or less in labor, and $648 for the new PCM



Reference bulletin #TC015-07

The contents are below:

TRANSMISSION & CLUTCH
TC015-07 Title:
HARSH SHIFT AND M.I.L. "ON"
DTC P2716 Models:
'05 - '07 Corolla & Matrix (1ZZ-FE) September 20, 2007

Introduction
Some 2005 - 2007 model year Corolla and Matrix vehicles equipped with an automatic transaxle may exhibit a harsh shift condition and a M.l.L. ON" with DTC P2716 stored.
Improvements have been made to the Engine Control Module (ECM) (SAE term:
Powertrain Control Module/PCM) to reduce the possibility of this condition occurring.

Applicable Vehicles
^ 2005 - 2007 model year Corolla and Matrix (2WD) vehicles equipped with the 1ZZ-FE engine.
Warranty Information
Applicable Warranty*:
This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's in-service date.

Oct 28, 2009 | 2006 Toyota Matrix

2 Answers

Pressure Control Solenoid P2716 toyota matrix issue


There is currently a recall going on for this problem. You can likely get your money back on the prior repairs as well. See this link http://www.toyota.com/recall/corolla-matrix.html. On the left-hand side, you can click to take you to put in your VIN and see if your vehicle is included. My 2007 vehicle IS included, and I just had the check engine light come on and have been experiencing rough shifting for about 6 months. When the light came on yesterday, it was extremely rough jerky shifting. The light went off today. Took it to Autozone and got same code P2716. Toyota has assigned me a case number, but I won't get a call back until Monday or by close of biz on Tuesday. This problem can cause your car to not start, or to shut down while driving. YIKES! The person I talked to at Toyota acted a little too nonchalant about the whole deal. Telling me to just wait for the call that I will get. She said most dealers would not have the part needed to fix this. According to what I have read. That is the reason why Toyota is not sending out the notification letters to the affected parties until mid-September. Check out all the info and good luck. I am a little bit p.o'd about this right now. - Natalie

Oct 12, 2009 | 2006 Toyota Matrix

2 Answers

Pressure Control Solenoid D electrical fault (P2716)


There is a Bulletin on this concern, and it is a warrantable condition for 8 years or 80,000 miles so you are still covered by the factory warranty.
The problem is a logic issue in the PCM. The correction is a new PCM with updated software.


Reference bulletin #TC015-07

The contents are below:

TRANSMISSION & CLUTCH
TC015-07 Title:
HARSH SHIFT AND M.I.L. "ON"
DTC P2716 Models:
'05 - '07 Corolla & Matrix (1ZZ-FE) September 20, 2007

Introduction
Some 2005 - 2007 model year Corolla and Matrix vehicles equipped with an automatic transaxle may exhibit a harsh shift condition and a M.l.L. ON" with DTC P2716 stored.
Improvements have been made to the Engine Control Module (ECM) (SAE term:
Powertrain Control Module/PCM) to reduce the possibility of this condition occurring.

Applicable Vehicles
^ 2005 - 2007 model year Corolla and Matrix (2WD) vehicles equipped with the 1ZZ-FE engine.
Warranty Information
Applicable Warranty*:
This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's in-service date.



** Please be sure to rate me if this free information has been helpful!

Sep 21, 2009 | 2006 Toyota Matrix

2 Answers

Pressure Control Solenoid "D" Electrical


You need to take it to a reputable repair facility. The pressure control solenoid needs to be checked for proper operation. If the solenoid is operating properly, the PCM (Powertrain Control Module[computer]) will need to be replaced. If you continue to drive the vehicle with this condition the transmission will eventually destroy itself.

Jan 28, 2009 | 2005 Pontiac Vibe

5 Answers

Oem code p2716


It can all be explained here: http://matrixowners.com/tsb/T-TC014-06.pdf

BOTTOM LINE: TAKE IT TOYOTA BEFORE THE WARRANTY EXPIRES @ 80,000 MILES OR 8 YEARS OF OWNERSHIP.

I had mine taken care of today free of charge, and hassle free, thanks to the service crew at Condit's Toyota.

Aug 14, 2008 | 2006 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

1,166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...