Question about 1999 Plymouth Voyager

1 Answer

98 plymouth voyager van

My van has 180K miles but runs extremely well. I went out yesterday and it was hard to start. I went to work and it became harder and harder to start. I changed the PVC and the MAP sensor. It had the same problem 4 years ago and that fixed it. Did not work this time. Hard to start and staggers then dies on acceleration. I do my own maintenance on my cars and have kept it up. There is no check engine and no code reading. Any help would be greatly appreciated.

Posted by on

  • eagle_51 Nov 01, 2008

    Alway keep it tuned on sched. Changer plugs about 5K miles ago. Wires and distributer about 10K back.

  • eagle_51 Nov 01, 2008

    Yes, sorry I forgot to add earlier. It's the 3.0. The PVC threads directly into the manifold. I will check for leaks. Thank very much for your responces!



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

What is your engine size?
Have you "tuned" it lately - ignition parts (spark plugs, wires, etc...,)

Posted on Nov 01, 2008

  • dpjones1700
    dpjones1700 Nov 01, 2008

    I assume your engine size is 3.0 liter 6-cylinder or 2.5 liter 4-cylinder.

    Check for vacuum leaks along hoses running near your throttle body or intake.

    The best way to do this is to start the vehicle, and either feel or listen for a suction or hissing noise.

    It may become difficult, once your cooling fan comes on, but be patient. Also, check your PCV grommet (gasket that holds the PCV valve). If this is worn, air will **** in between the grommet and the PCV valve.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

93 Plymouth Voyager will not start, the Fuel Pump isn't whirring when the key is turned.

You should always hear the pump. Check the electrical connections after you check to fuse.

Dec 06, 2012 | 1997 Plymouth Voyager

2 Answers

1994 Plymouth Voyager 3.3 The "Check Engine Light" comes on after driving 6 miles on open highway.

Take to local auto parts store and they will usually run codes for free and from there you can find the most likely source of the problem area.

Jun 09, 2012 | 1994 Plymouth Voyager

1 Answer

Turn signals stopped working now no power

I concur this is a power supply fault of some sort, insure your battery connections are maintained, meaning clean and good of contact, obtain a voltmeter and test the voltage at the battery contacts it should be about 12.5 or higher, turn the key on and try to start, noting the voltage, if it drops below 11 volts, there's your fault if not a poor ground from the battery and the frame of your vehicle may be faulty but boosting your vehicle from another sports battery fault

May 05, 2010 | 1998 Plymouth Voyager

1 Answer

None of the gauges will work on my 98 plymouth

This is because it is one of your main relay is bad. It is also part of the circuit that your starter is on.
This fuse panel is under the hood just to the left of the battery.

Sep 18, 2009 | 1998 Plymouth Voyager

1 Answer

98 Ply Grand Voyager, 1.4K miles with recurring P0305 code.

You say you changed the cap and rotor so I'm assuming the van has a 3.0L? Possible injector problem on cylinder #5, swap injector with cylinder 1 or 3 and see if miss/dtc moves to that cylinder. You also could have a vaccum leak, although they usually won't come and go. Does the vehicle have a consistent miss or do you just have a check engine light?

Aug 19, 2009 | 1998 Plymouth Grand Voyager

2 Answers

Last week my van 88 plymouth voyager over heated, now it will not start and others are telling either it has no compression or the timing went or needs to be readjusted, please help

Your nearest mechanic might have a compression tester/meter to verify it. Sometimes it depends on the degree of overheating that will cause damage to the top gasket and piston rings. A warped engine head is likely also.

Jan 13, 2009 | Plymouth Voyager Cars & Trucks

1 Answer

98 plymouth voyager after 2 miles or so loses all drive gears

when you shut the car off it resets the computer so it works again you may have a bad transmission sensor .or an internal trans problem.

Dec 19, 2008 | 1996 Plymouth Grand Voyager

1 Answer

1999 Plymouth Voyager. Van acts like it does not want to start sometimes.

Gee......since you haven't listed too much info...kind of hard to tell u what to do next. Need more information. Is the "check engine" light on? When was the last tune up? How many miles?

Jul 30, 2008 | 1999 Plymouth Voyager

Not finding what you are looking for?
1999 Plymouth Voyager Logo

267 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides