Question about 1996 Jeep Grand Cherokee

1 Answer

Diffrental ! Can I use another Jeeps or other cars rear diffrental for a 2x2 1999 Grand Cherokee?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

You can only use other Grand Cherokee rears.
Check the gear ratio on the tag of the rear. You need to replace with the same ratio.
But in your case since it's a 2x2, you can use any other ratio as long as the tire sizes are the same.
This will not affect the speedo accuracy.

Posted on Oct 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to close and lock the rear lift glass.


press it down and the latch closes. and locks.
on all jeeps.
if not the latch system is failing. (i own 2010) and JK 08.
the FSM covers this, read that yet>? posted 100s of times
see WK jeeps?

http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Oct 18, 2015 | 2006 Jeep Grand Cherokee

1 Answer

How to remove a dashboard from a 1994 grand cherokee


XJ 94
its not bad, wana bet? 90% are not.
(i used to fix them)
so the PCM,. the FSM book covers that.
why not read that.
JEEPJX
PCM is baD ONLY WHEN inputs good, and its outputs are bad.
(and outputs not shorted) !!!
(same or all computers on earth)
lose of power to PCM or ground
or bad power.(weak, or intermittent)


Got DTC errors , post them?
innova 3140 best bank for buck on 93-95 jeeps. !!!
that is a low priced scan tool

are you having ASD relay issues?
http://www.fixkick.com/Jeeps/ASD.html


see XJ 95 here (same i think)
http://colorado4wheel.com/manuals/Jeep/XJ/

page 8D-23
engine bay next to Air cleaner.

to diagnose any car, a real scan tool is best.
or you will need a full lab of meters and scopes. like me.
the scan tool show up things the keyon/off trick does not.
http://www.fixkick.com/Jeeps/jeeps.html#poor_mans-scan


25499888-tk5pw0guzkbs2wb12fwiwrb2-5-0.jpg

Mar 01, 2015 | 1994 Jeep Grand Cherokee

2 Answers

1995 Jeep Grand Cherokee at parking lot speed I have a chatter coming from the diff. when I let off the accelerator, I have replaced the fluid with Royal Purple which says I DON'T have a modifier.


Sounds like you could possibly have a pinion bearing issue. Have you had the pinion seal replaced recently? if so, sometimes the nut that holds the yoke on the rear differential gets over-tightned causing the pinion bearing to be too tight in the race, therefor damaging the bearing assembly and causes a "chattering" sound. When a pinion bearing goes bad in these Jeeps that is the noise they will make, even at lower speeds. Hope this helps..

Oct 22, 2012 | 1995 Jeep Grand Cherokee

1 Answer

I am having rear end noises on my 1999 Jeep Grand Cherokee and the mechanic is having trouble getting the number from the plate attached to the differential because it's rusted and broken off. Is there...


Hello, Most of the time there is a spec sheet in the jeeps that will tell you this. They are usually on the inside of the glove box or under the hood on the front cowl or on the underneath of the hood itself. Good luck hope this is helpful.

Oct 27, 2011 | 1999 Jeep Grand Cherokee

2 Answers

How to replace spark plugs on 2000 jeep cherokee classic 6 cyl.? Also does 2000 cherokee have inline fuel filter?


TO REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU HAVE 6 INDIVIDUAL COIL PACK TO EACH CYLINDER. YOU NEED A 3/8 RATCHET WRENCH - LONG 3/8 EXTENSION -SPARK PLUG SOCKET - SPARK PLUG GAUGE.AND TORQUE WRENCH.THE 2000 MODEL JEEPS FUEL FILTER INSIDE THE TANK.1993 - 1996 MODEL JEEPS FUEL FILTER LOCATED LEFT SIDE OF THE VECHICLE NEAR THE FUEL TANK.

Jul 20, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Need fuse layout and listings for 2000 grand cherokee


2000 Grand Cherokee allso called WJ, go to 1999-2004 Jeeps; check here for the Fuse Location and Description.

Hope helps (remember rated this). TY for using Fixya.

Jun 04, 2010 | 2000 Jeep Grand Cherokee

1 Answer

1997 jeep grand cherokee ring and pinion


you have a set bolt to hold the shaft in and once it is removed you have a set of retainerd holding the gears

Feb 05, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Engine number for a 1997 cherokee jeeps


on the passenger side of the block on a machined surface between #2 and 3 cylinder

Sep 16, 2008 | 1996 Jeep Grand Cherokee

1 Answer

My rear lights on my 99 jeep grand cherokee do not work when I turn the lights on. They work fine when the lights are off. Any idea as to what the cause might be. Any place I can view a wiring diagram...


These Jeeps are notorious for the retainers breaking that hold the circuit board type wiring against the bulb contacts. With my 2000 Grand Cherokee, the brake lights would work when the headlight/tail lights were off. If the lights were on, the rear lights would go out altogether when I pressed the brakes. The easist fix would be replacing the tail light assemblies, but these are not cheap. My fix was to open up the inside cover of the tail light housing and use machine screws in each of the locations that the plastic tabs hold the retainer against the light housing.

Jul 27, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...