Question about 2004 Mercury Mountaineer

2 Answers

New charged battery in 2004 Mountaineer, but it won't start.

I replaced old battery. New one is charged, but car will not start. Starter does not click or anything. Interior, exterior lights work, radio works and gauges light up. Any ideas?

Posted by on

  • 3 more comments 
  • pmp548 Dec 15, 2008

    I have a 2002 Mountaineer with a good battery and good connections to the battery and starter. All power is on in the car, but the starter does not operate - no click, no extra load on the battery (voltage does not drop when key is turned to start).

  • Anonymous Feb 03, 2009

    I had to change my alternator.

  • pauline Oct 07, 2012

    replaced alternator

  • Anonymous Mar 14, 2014

    starter clicking intermittent new starter @ battery fitted

  • Anonymous Mar 23, 2014

    Will not start, new battery. have remote start, it doesnt work either

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Check the fuse

Posted on Oct 31, 2008

  • thriftylife1
    thriftylife1 Jan 02, 2012

    having the same problem and was thing of using this same solution, which fuse?

  • pauline Oct 07, 2012

    cant find book

×

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

I think your starter solenoid might be busted

Posted on Dec 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can a solenoid be replaced on a 2004 mercury mountaineer 4.6 engine


Make sure ur battery has 12 15 vdc and if not battery is ur problem also check ur starter by getting underneath and while someone is trying to start it give it a few good wacks with a heady pipe or crowbar

Sep 26, 2016 | 2004 Mercury Mountaineer

1 Answer

I put the key in but won't start


Could be battery check connection,must be 12.5V,check all fuses ,starter,spark plugs,check oil.

Feb 06, 2013 | 2004 Mercury Mountaineer

1 Answer

My daughter 2004 Kia won't hold a battery charge.


voltage regulator. it may be in the alternator, or remote mounted. ((the alternator can be charging, but if voltage regulator is'nt working then it won't allow voltage to get back to the battery to keep it charged

Sep 07, 2012 | Cars & Trucks

1 Answer

2005 mercury mountaineer wont start, no clicking no nothing, then all of a sudden it starts. whats going on?


when it won't crank you will need to start at the battery and work your way to the starter checking for voltage
battery - cables - ignition switch - neutral safety switch - starter

Jun 28, 2012 | 2004 Mercury Mountaineer

1 Answer

My 2002 merc mountaineer wont start- battery is fully charged, but car wont turn over, there is no power on anything, and there is a clicking noise that, when i sit in the driver's seat to try to start the...


sounds like the battery termanals need to be cleaned and tightend,have somebody wiggle the battery wires while you try to start it allso the clicking noise is comeing from you starter it is not getting anuff power to it.

Jul 12, 2010 | 2004 Mercury Mountaineer

1 Answer

Got in mountaineer to start would not start tried to jump battery no luck bought new battery because water empty in battery still will not start could it be security problem and what to do


check for bare wire on battery cable then check battery cable to starter and run wire if ok try hitting starter several good whacks if it starts then starter is bad put on new starter but replace solenoid first make sure connector is tight take a pliers and squeeze it a little so it is tight then try to start.

Oct 23, 2009 | 2004 Mercury Mountaineer

1 Answer

Where is starter located on 2004 chrysler pacifica???


90e9c96.jpg
Look around the "back" of the engine beside the transmission. The Starter connects to the flywheel to start the engine.
If you are replacing the starter you may want to consider doing this first;
) Have the charging system checked. Many auto parts stores and Sears will do this for free.
) Clean the battery terminal/connectors.
) Check the wiring from the battery to make sure it's good.

If you replace the starter yourself;
) Does your car have an anti-thief alarm ? If so find how to reset it if the battery is disconnected. Some alarms will shut down the car if the battery is disconnected !!
) DISCONNECT THE BATTERY.
) Disconnct the wiring to the starter.
) Remove the bolts holding the starter. Remove the harder one to reach first.
) Pull out the old starter.
) Put it the new starter.
) Bolt the new starter in. Put the easier bolt to reach first.
) Connect the wiring to the new starter.
) Re-connect the battery.
) If necessary reset the thief alarm.
) Take the old starter back for a core charge refund.

May 15, 2009 | Chrysler Concorde Cars & Trucks

Not finding what you are looking for?
2004 Mercury Mountaineer Logo

701 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...