Question about 2004 Mitsubishi Lancer Evolution

Open Question

MITSUBISHI 2003 MODEL EXPRESS VAN JERKING WHEN AT HIGH REVS OR GOING UP HILL WITH THROTTLE DOWN

When the van is cold and I drive either at full throttle like going uphill or accelerating the van jeks and the motor wants to stall. if I reduce the throttle it will come back good but going uphill it is even worse. I have checked the spark plugs and I am using 91 octane fuel but even have tried 95 octane and still the same. I suspect a fuel / emmision type problem, but not sure.

Posted by on

6 Suggested Answers

  • 1 Answer

SOURCE: 2002 Mitsubishi Lancer sputters when idling and accelerating

My Lancer was doing the same thing and i had a tune-up and got a new catalytic converter but it was my ignition coil that was bad. Maybe this can help you.

Posted on Mar 11, 2009

  • 201 Answers

SOURCE: Bogging while heavy accelration.

vacuum advance working ? do manuel check with cap and rotor button off and see if it's moving. chris

Posted on May 08, 2009

  • 78 Answers

SOURCE: where is oil fill plug on mitsubishi express van manual trans??

fuel filer will be located blow ur chasy near fuel pump, generally.

n about Oil fill hole, it will located next to the engine, below the hood, or above the gearbox, for manual transmission. thank u

Posted on Jul 17, 2009

motor1258
  • 6674 Answers

SOURCE: 1995 Mitsubishi L300 Van 2ltr aspirated motor,

If it's carburetor & has automatic choke, then there is probably a screw at side of carb, by step cam that moves with choke . Back it of a little at a time until you get desired cold idle speed. Make sure you turn step cam to setting it would normally be when cold, and choke on, then turn screw out to lower rpm's. Look for a little rod from choke shaft, down to base or side of carb area, to step cam.

Posted on Jul 18, 2009

  • 14 Answers

SOURCE: Mitsubishi Lancer OZ Rally 2003 hesitates while driving

before anything i had the problem and this is the way i solved it ... the lancer has 2 ignition coils in 2 cylinders what you do is take the iginition coil out of the cylinder that is misfiring and change it to another cylinder and put the car on the odb reader again it should change location of misfire .. then that would tell you that its the ignition coil thats bad i ended up getting my coil at the dealer for $110 ebay has some aftermarket pairs for $100 so you can get 2 now for the price i paid for 1 that will solve the problem guaranteed owne d a lancer for 5 years know the ups and downs to them

dirtyjerz908 at GMail.com hit me up

Posted on Dec 25, 2009

  • 145 Answers

SOURCE: My 1995 Lincoln Mark viii takes fuel of 91 octane

The higher the octane the cleaner the engine will stay.

Posted on Jan 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

High rpms in idle


check for vacumme leaks sonds like a hose came off if nothing found replace teh idle air controll motor

Feb 23, 2014 | 1997 Dodge Caravan

1 Answer

My Mercury Villiger's been over heating, it just started im going to replace the thermostat, but when going up hill the van jerks as if it wants to die down on me. When i say jerks i mean shakes really bad...


The jerking could be the EGR valve--as you have a
high vacuum signal under a load,meaning going up hill
and on the gas

The overheating issue could be effecting the ignition
and again cause misfires going up hill

When ever I have any problems I immediately stop
using the vehicle until ALL Problems are resolved

Remember your not working on a ford if I
recall, it is actually a nissan powertrain

Apr 27, 2011 | 1997 Mercury Villager

1 Answer

How to locate a vacum leak under load [going up hill] on a 2006 express van with 4.3 moter


only thing i can suggest is while the engine is cold have someone run up the rpms and spray carb cleaner around the vacuum lines and anywhere else you think there could be leak. if a leak is present the engine will **** up the carb cleaner and bog down. BE SURE TO DO THIS WITH THE ENGINE COLD CARB CLEANER IS FLAMMABLE.

Apr 18, 2011 | 2006 Chevrolet Express

1 Answer

I have a 2002 e-250 van and when im at a stop light it revs up and down eraticaly. A friend told me its the I.A.C.V and that I could clean it so I did and nothing happened ..The van also has just started...


possible fuel pump. test the fuel pressure. possible M.A.F.. test first. then attempt cleaning with approved maf cleaner. check coolant level, test coolant temp sensor.

Feb 01, 2011 | 2002 Ford E250

1 Answer

Car revs to high when pressing petal


IF IT'S GOT A MANUAL GEAR BOX IT'S PROBABLY THE CLUTCH SLIPPING, YOU WILL NEED A NEW ONE

Apr 25, 2010 | 2003 Toyota Corolla

1 Answer

351C with FMX auto, Wont engage drive with high RPM


A CLEVELAND ENGINE IN A FAIRMONT????HMMMMMMMMMMMM....SOUNDS LIKE THE PUMP IS GOING BAD. DO YOURSELF A FAVOR AND JUK THE FMX AND GET A GOOD USED OR REBUILT C-6 INSTEAD.

Dec 15, 2009 | 1983 Ford Fairmont

2 Answers

1995 Mitsubishi L300 Van 2ltr aspirated motor, Automatic choke revs extremely high on cold start, will not decelerate till engine is hot. How can I remedy this?


If it's carburetor & has automatic choke, then there is probably a screw at side of carb, by step cam that moves with choke . Back it of a little at a time until you get desired cold idle speed. Make sure you turn step cam to setting it would normally be when cold, and choke on, then turn screw out to lower rpm's. Look for a little rod from choke shaft, down to base or side of carb area, to step cam.

Jul 17, 2009 | 1988 Mitsubishi Pickup

1 Answer

Loss of power going up hill


fuel pump is bad. they are under extented warranty from ford. take to dealer and "insist" they change it. there is service bulletin on this, but dealers often play "dumb".

Nov 23, 2008 | 2001 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...